Dreamline BTCB6041HFXXC00 Manual de usuario
SAVE THIS GUIDE FOR FUTURE REFERENCE.
Read all instructions carefully before proceeding.
Serial Number
IMPORTANT • Record the serial number
INSTALLATION INSTRUCTIONS
FREESTANDING BATHTUB
MODEL
• BTCB6041HFXXC00, BTCB6635HFXXC00 (Caribbean)
•BTSC6032WFXXF00 (Seneca) •BTLV6032WFXXF00 (Levantine)
•BTMO6032WFXXC00, BTMO6636WFXXC00 (Montego)
•BTCA6032WFXXC00, BTCA6636WFXXC00 (Caspian)
Install Questions?
Call 888-704-3690 -or-
Email [email protected]
A two person installation
is recommended
TABLE OF CONTENTS
PAGE
Before you begin .............................................4
Tools and supplies ............................................5
1. Unpacking the unit..........................................6
2. Leveling legs adjustment.....................................7
3. Bathtub skirt and drain positioning............................8
4. Faucets installation (not included).............................9
5. Bathtub preparation and installation ..........................10
Troubleshooting and maintenance ..............................15
Warranty ....................................................16
DreamLineShowers.com | 3Freestanding Tub Installation Manual
• Carefully read the all the instructions in the manual before beginning the installation.
• Consult local building codes to make sure the installation complies with standards.
• Remove the unit from its packaging. Before disposing of it, inspect the unit to make sure it
is in good shape. Should inspection reveal any damage or defect in the finish, contact your
distributor. The warranty does not cover damages or defects in the finish once the unit has been
installed. DreamLine’s responsibility for shipping damages ceases upon delivery of the product
in good order to the carrier. All complaints regarding damage due to transport must be made
directly to the carrier.
• Place the unit in the bathroom before you start working. Sectional units should be disassembled
if necessary. Conserve all nuts and bolts.
• To protect the unit during installation, we recommend that you lay a piece of cardboard on the
bottom.
• If the unit is covered with polyethylene protective film, do not remove until installation is
complete to grant maximum protection. However, remove film where two surfaces will be in
permanent contact.
• Install all plumbing and drainage before securing the unit. It is always recommended to
have a professional plumber do the plumbing installations. See rough-in information for
your model on our website.
BEFORE YOU BEGIN
DreamLineShowers.com | 4Freestanding Tub Installation Manual
Pencil
Clear silicone sealant
Measuring tape
Level
Utility knife
Safety equipment Screwdriver
Electric drill
⅛" -drill bit
Box of #8x1¾"
flathead screws Wooden shims
50
Hole saw
30" 2 x 4 studs
TOOLS
SUPPLIES
DreamLineShowers.com | 5Freestanding Tub Installation Manual
1.1
Check me!
1.2
Check me!
Cut the cardboard box so as to keep one side to
protect the bathtub while is upside down. Turn the
bathtub upside down. Unscrew the skirt from the
wooden blocks.
Not all bathtubs have screws and
wooden blocks holding the skirt
and the bathtub together.
Remove the skirt.
Insert a at-head screwdriver between the wooden
blocks and the wood plank to remove the blocks.
STEP 1 | Unpacking the Unit Follow all instructions and
check them o as you go.
DreamLineShowers.com | 6Freestanding Tub Installation Manual
Place back the skirt in the inverted bathtub. Adjust
the legs so that they exceed the top of the edge
of the skirt by 1/8". You can use a 2x4 to take the
measure as shown.
2x4
Leg
Skirt
⅛"
Legs
Skirt
⅛"
Legs
2x4 Cut view
Skirt
⅛"
Legs
2x4 Cut view
Skirt
⅛"
Legs
2x4 Cut view
Bolt leg installation only
applicable to certain models.
STEP 2 | Leveling Legs Adjustment
2.1
Check me!
DreamLineShowers.com | 7Freestanding Tub Installation Manual
3.1
Check me!
3.2
Check me!
3.3
Check me! Drill the cutout on the oor for the drain and
overow in the previously marked position.
With the help of the bathtub apron, mark the
center of the drainage line in relation with the
desired position of the bathtub. See also the
rough-in information for your model on our
website.
Floor
Drain position
Desired bathtub position
Before drilling a hole in the oor for
the drainpipe, make sure there are
no hidden elements underneath
(pipes, oor joists, heating ducts,
electrical wires).
Make sure the oor is level.
If the user needs faucet on the same side than
the overow, they must validate that there is no
interference between them.
Place the bathtub in the previously marked position.
Verify that the bathtub is completely leveled. Use
the leveling legs if needed. Remove the bathtub.
STEP 3 | Bathtub Skirt and Drain Positioning
DreamLineShowers.com | 8Freestanding Tub Installation Manual
Faucet elements must be installed in the intended
area. See also the rough-in information for your
model on our website.
Before drilling, position the faucet base to make
sure they line up with the predrilled holes.
Mark the location of the faucets on the unit and
drill 3/16"(5 mm) pilot holes. Make sure the holes
line up with the plumbing.
Drill directly on the finished side, following
the faucet installation instructions.
If the user needs faucet on the same side than the overow, he
must validate that there is no interference between them.
STEP 4 | Installing Faucets (NOT INCLUDED)
4.1
Check me!
4.2
Check me!
DreamLineShowers.com | 9Freestanding Tub Installation Manual
Install the waste and overow and faucets according
to the manufacturer's instruction manuals.
Standard drainpipe and overflow compatible with end-drain
freestanding bathtub models: BTSC6032WFXXF00 (Seneca)
Standard drainpipe and overflow compatible
with center drain freestanding bathtub models:
BTMO6032WFXXC00, BTMO6636WFXXC00 (Montego),
BTCA6032WFXXC00, BTCA6636WFXXC00 (Caspian)
For models BTSC6032WFXXF00 (Seneca),
BTMO6636WFXXC00, BTMO6032WF (Montego),
BTCA6032WFXXC00, and BTCA6636WFXXC00 (Caspian)
5.1
Check me!
Install the valves and
faucets at this stage.
STEP 5 | Bathtub Preparation and Installation
DreamLineShowers.com | 10Freestanding Tub Installation Manual
STEP 5 | Bathtub Preparation and Installation (CONTINUED)
5.2
Check me!
5.3
Check me!
Top view
Add two spacers (example 2x4) on the skirt ends
and position the bathtub inside the skirt. Attach the
hot and cold water riser to the plumbing hoses.
Faucet must be connected to 1/2" exible hoses
of sucient length to allow the bathtub to be
lifted if needed (25" or 635mm).
Apply a silicone seal under the apron (optional).
According to bathroom ooring, use proper screws
(not included) to secure the skirt to the oor.
Skirt
Silicone
Make sure the skirt is level.
Este manual sirve para los siguientes modelos
7
Tabla de contenidos
Manuales populares de Bañera de otras marcas
Lyons
Lyons Elite ETLxx663219 Series Manual de usuario
Woodbridge
Woodbridge BJ500 Instrucciones de montaje
Whirlpool
Whirlpool Ariel ARL-702 Manual de usuario
TEIKO
TEIKO EXCELLENT DUO Manual de usuario
American Standard
American Standard Colony 5-1/2' x 32" Manual de usuario
American Standard
American Standard 3052OD.X0X Guía de inicio rápido
