Dreamline Visions Manual de usuario

Visions Tub Door & QWALL-TUB Kit

Tub Door AND SHOWER BACKWALLS KIT INSTALLATION

INSTRUCTIONS

IMPORTANT

DreamLineTM reserves the right to alter, modify or redesign products at any time

without prior notice. For the latest up-to-date technical drawings, manuals or any

other details please refer to the support.BathAuthority.com web page.

STEP 1: Install Shower Backwalls

Shower Backwalls Installation Instructions

STEP 2: Install Shower Door

Shower Door Installation Instructions

Please read these instructions carefully before installing. If you have any questions regarding

installation, please call our technical support specialists Monday through Friday 9:00 AM –5:00

PM EST at Phone: 1-866-731-2244, Fax:1-866-227-1533 or e-mail our technical support

group at

[email protected].

For more information on DreamLine Shower Kit please visit www.BathAuthority.com

Rev 1.6 1

VISION

SHOWER DOOR &TUB DOOR INSTALLATION INSTRUCTIONS

IMPORTANT

DreamLineTM reserves the right to alter, modify or redesign products at any time without

prior notice. For the latest up-to-date technical drawings, manuals or any other details

please refer to the support.BathAuthority.com web page.

Please carefully read the instructions before installing. If you have any questions

regarding installation, please call our technical support specialists Monday through Friday

9:00 AM – 5:00 PM EST at 1-866-731-8378, ext. 3 or e-mail our technical support group at

support@BathAuthority.com.

For more information on DreamLineTM Shower Doors & Tub Doors please visit www.BathAuthority.com

Rev 1.6 2

Preparation

1. After opening all boxes and packages, read this introduction carefully. Check that all of the

needed parts are included in the package, by marking all the components on the “Detailed

Diagram of Shower Door Components”. Examine boxes and packages for shipping damage. If

the unit has been damaged, has a finishing defect, or has missing parts, please contact our

customer support department within 3 business days of the delivery date. Please note that

DreamLine TM will not replace any damaged products or missing parts free of charge

after 3 business days or if the product has been installed. Feel free to contact DreamLineTM

if you have any questions.

2. Please note that you should consult your local building codes with questions on

installation compliance standards. Building and plumbing codes may vary by location,

and DreamLine is not responsible for code compliance standards for your project.

3. Install all of the required plumbing and drainage before securing the shower. Have a competent

and licensed (if required by local code) plumber or tradesman do and/or approve your

plumbing installation.

4. Please insure that prior to the installation the installation surface is leveled and solid and will be

able to support the total weight of the unit. Also make sure the walls are at right angles. While

some adjustment in leveling of the door is possible, irregular installation surface level or

improper angle of side walls will result in serious problems for your installation. Please, note

that some adjustments and drilling might be necessary during the installation process.

Note: If glass has silk, print or molded designs, please make sure that clear side faces inside

the shower

Tools Required

Caulk Tape

Measure Pencil Screwdriver

Phillips

Level Gun

Caulk Drill

Electric Hammer Miter saw or Hacksaw

Drill bit Drill bit

(Ø=5/16") (Ø=1/8")

Rev 1.6 3

Detailed Diagram of Shower Door Components

123

Packing List

01 Glass profile 2pcs 10 Round head screw ST4.2×30 8pcs

02 Wall profile 2pcs 11 Round head screw ST4.2x25 8pcs

03 Guide rail 2pcs 12 Round head screw ST4.2x10 4pcs

04 Glass door 2pcs 13 Flat head screw ST4.2x15 4pcs

05 Stationary glass 2pcs 14 Decorative cover 4pcs

06 Handle 2pairs 15 Wall anchor 8pcs

07 Magnetic strip 1pair 16 Glass holder 4pcs

08 Anti-water strip 4pcs 17 Wheel assembly 4pairs

09 Single side strip 2pcs

NOTE: Unpack your unit carefully and inspect it. Lay it out and identify all parts using parts

diagram and part list in your manual as a reference. Before discarding the carton, check for

small hardware bags that tend to fall to the bottom of the box. If any parts are damaged or

missing, please contact DreamLineTM for replacement.

Rev 1.6 4

Shower Door Installation

1. Measure the distance between two

walls. This distance is marked as “W”.

See Fig. 1 for details.

Fig. 1

2. Your Guide rails (03) have been

precut for the installation between

the walls with a distance of: 60”

If W=60”, then it is unnecessary to

cut the Guide rails and you can

continue to Step 3.

If W<60”,then you will need to cut

the Guide rails from both ends.

The length to cut off will be L:

See Fig. 2 & Fig. 3 for details.

Fig. 2

60”−W

Rev 1.6 5

Fig. 3

3. If the Guide rails (03) have been cut, you will need to

reinstall the roller stoppers on each Guide rail on both

sides where it has been cut.

Remove existing stopper. Mark the drilling hole with a

distance of 2” from the cut off edge of the Guide rail.

Drill the new hole using Ø 1/8” drill bit; then fasten the

stopper with screw.

ATTENTION:

Do not drill Guide rail throughout, only the first layer.

See Fig. 4 for details

Fig. 4

Ø1/8”

2”

Rev 1.6 6

4. Fasten the bottom Guide rail (03) to the Glass profiles (01)

with the Round head screws ST4.2x25 (11).

See Fig. 5 for details.

Fig. 5

5. Slide the Stationary glasses (05) fully into the groove of

the Glass profiles (01), and then fasten it by the Glass

holders (16) to the bottom Guide rail (03).

See Fig. 6 for details.

Fig. 6

Rev 1.6 7

6. Slightly tap the Single side strips (09) in between the

Stationary glasses (05) and the Glass profiles (01) using

wooden shim or other piece of wood. The strips should be

inserted from the sides that will face inside the shower.

ATTENTION:

Do not use the screwdriver or other metal objects; you can

scratch or damage the glass and aluminum.

7. Repeat Step #4 and Step #5 to fasten the upper Guide rail

(03) to the Glass profiles and secure the Stationary glasses

by the Glass holders (16).

See Fig. 7 for details.

Fig. 7

8. Slide the Wall profiles (02) all the way onto the Glass profiles

(01) on both sides. Make sure the flanges of the Wall profiles

faces inside the shower.

See Fig. 8 for details.

Fig. 8

Rev 1.6 8

9. Move the finished frame to the designated

position on the shower base, the bathtub or the

threshold (depending on your installation); push it

against the walls. If your top and bottom wall

opening measurements are different or if the

walls are out-of-plumb, make adjustment by

slightly pulling the Wall profiles (02) out of the

Glass Profiles (01).

Use the level to adjust the frame in the vertical

position

See Fig. 9 for details.

Fig. 9

10. Using help to hold this assembly in the right

position, mark the drill holes on the wall through

the holes on the flange of the Wall Profiles (02).

11. Gently set the assembled unit aside; drill the holes

using Ø 5/16” drill bit and insert the Wall anchors

(15).

Apply silicone caulk along the Wall profiles and

around the holes on the wall. Also apply silicone

under the bottom Guide rail (03). Place the whole

shower assembly back into the designated position

and secure it to the walls using the Round head

screws ST4.2×30 (10).

See Fig. 10 for details.

Fig. 10

Ø5/16”

Rev 1.6 9

NOTE: Glass Door (04) comes with

preinstalled Wheel assemblies (17). If not,

please refer to (Fig. 11) for detailed

installation.

12. Fasten the top and the bottom Wheel

assemblies (17) to the Glass door (04). The

top wheels can adjust the door level with the

adjustable bolt and lock nut. The bottom wheel

has a press button to fix the wheel on to the

bottom Guide rail (03).

Note:

The lock nut of the upper wheel and the press

button of the bottom wheel should be

pointing up.

See Fig. 11 for details.

Fig. 11

13. Slide the top door wheels into the

top Guide rail (03). Push the

bottom wheels into the bottom

Guide rail by pressing down the

button on the Wheel assembly.

Use the Phillips screwdriver #2 (do

not use power screwdriver) to

adjust upper wheels, make sure

they move smoothly and the door

closes tight.

See Fig. 12 for details.

Fig. 12

1 3

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorio de baño de Dreamline

Dreamline

Dreamline Unidoor-X D58580 Series Manual de usuario

Dreamline

Dreamline UNIDOOR-X L1 Series Manual de usuario

Dreamline

Dreamline ASCEND Manual de usuario

Dreamline

Dreamline AQUA-Q FOLD SD-363072Q Series Manual de usuario

Dreamline

Dreamline ENCORE-X SHDR-166062X Series Manual de usuario

Dreamline

Dreamline Unidoor Lux D SHDR -23297210 Series Manual de usuario

Dreamline

Dreamline ENIGMA AIR SHEN-6434480 Series Manual de usuario

Dreamline

Dreamline AQUA-Q FOLD Manual de usuario

Dreamline

Dreamline Aqua Fold DLT-1132320 Manual de usuario

Dreamline

Dreamline SHCM-2648-00 Manual de usuario

Dreamline

Dreamline SHST-01-PL Manual de usuario

Dreamline

Dreamline AQUA UNO Manual de usuario

Dreamline

Dreamline PYRAMID Manual de usuario

Dreamline

Dreamline ALLIANCE PRO SDAH48W700 Manual de usuario

Dreamline

Dreamline UNIDOOR Manual de usuario

Dreamline

Dreamline SHDR-20237210F Series Manual de usuario

Dreamline

Dreamline ILLUSION Manual de usuario

Dreamline

Dreamline QWALL-3 Manual de usuario

Dreamline

Dreamline PRISM PLUS Manual de usuario

Dreamline

Dreamline BUTTERFLY Manual de usuario

Dreamline

Dreamline FRENCH LINEA Series Manual de usuario

Dreamline

Dreamline FLEX Shower Enclosure Manual de usuario

Dreamline

Dreamline DREAMSTONE WKDS363684XMS00 Manual de usuario

Dreamline

Dreamline Aquaswing-EX Manual de usuario

Manuales populares de Accesorio de baño de otras marcas

DURAVIT

DURAVIT C.1 C15240 0090 Manual

Heatstore

Heatstore HSTRL500WTN Manual de usuario

Sunshower

Sunshower PURE SOLO Manual de usuario

Delabie

Delabie Delabie Sporting 714700 Manual de usuario

Kohler

Kohler K-13056 Instrucciones de montaje

ESS

ESS Container TCL-11 Manual de usuario

Mustee

Mustee 22C Manual de usuario

VITRA

VITRA V-Flow Manual de usuario

baliv

baliv DUK-80.30 T Manual de usuario

Malmet

Malmet B105BT Manual de usuario

bathstore

bathstore Transition H1690MM Guía

BELLOSTA

BELLOSTA Edward 0800/M Manual de usuario

baliv

baliv DU-5160 Manual de usuario

Franke

Franke PRTR0006 Manual de usuario

Gessi

Gessi RILIEVO 59011 Manual de usuario

noken

noken VITAE 100188525-N299998810 Manual de usuario

Allen + Roth

Allen + Roth 1142VA-30-201 Manual de usuario

Britex

Britex HBDA Manual de usuario