MODE
ON footswitch
Set the effect ON or OFF.
Also while holding the footswitch down,
it works as a SHIFT function button.
Tap footswitch
Tap tempo over the Delay Time.
When holding the TAP and the ON buttons down for 3 sec,
you will save the current Algorithm’s state.
Feedback Knob
Set the Delay’s Feedback or the Number of the repeats.
This is the main feedback control, but there are
actually 2 feedback stages:
One right after the delay line, called “Main Feedback”
& the other is located after the effects of the delay lines
(Filter and Pitch Shifter) called “Post Feedback”.
Mix Knob
Controls the Dry/Wet balance of the effect.
At 50% there is a 1:1 mix ratio.
Time Knob
Delay time from 50ms up to about 1 second.
After 700ms, the repeats will start becoming LO-FI.
NOTE: when used as a stereo output,
the R channel will have an offset compared to the L channel,
so as to achieve the stereo spread effect.
MODE Toggle Switch
This changes which parameter the Control knob affects.
For more info check on the Algorithms section (page 3).
Control knob
Depending on the algorithm and the Mode switch position,
this controls different parameters each time.
For more info check on the Algorithms section (page 3).
Output
Audio out , send to an amp,
mixer or monitor.
Input
Audio, line or fretted instrument input.
Accepts up to 2Vpp levels.
9VDC center pin negative
standard effect pedals power
Raindrops is a Hybrid Delay/Pitch Shifter/Reverb pedal that takes the concept of short echos on a differ-
ent level. Ιt is equipped with multiple delay stages and different chips and you can choose between 3
different play modes, where in each one you can have a whole new experience and alternative sound-
scapes. You can achieve from simple short echos, to long, dirty and lo-fi delays and from simple pitch
shifting bursts to extensively lasting reverbs.
Main Page Controls
These are the hands on controls,
that you can access without
holding down the shift.
On/Off Indicator Delay Time Indicator
