Digi-tech Bass Whammy Manual de usuario

A Harman International Company

These symbols are internationally accepted symbols that warn of potential

hazards with electrical products.The lightning flash means that there are

dangerous voltages present within the unit.The exclamation point indicates

that it is necessary for the user to refer to the owners manual.

These symbols warn that there are no user serviceable parts inside the unit.

Do not open the unit.Do not attempt to service the unit yourself. Refer all

servicing to qualified personnel. Opening the chassis for any reason will void

the manufacturer’s warranty. Do not get the unit wet.If liquid is spilled on

the unit,shut it off immediately and take it to a dealer for service.

Disconnect the unit during storms to prevent damage.

Warning

For your protection, please read the following:

Water and Moisture: Appliances should not be used near water

(e.g. near a bathtub, washbowl,kitchen sink,laundry tub, in a wet

basement,or near a swimming pool,etc.) Care should be taken so

that objects do not fall and liquids are not spilled into the enclosure

through openings.

Power Sources:The appliance should be connected to a power

supply only of the type described in the operating instructions or as

marked on the appliance.

Grounding or Polarization: Precautions should be taken so that

the grounding or polarization means of an appliance is not defeated.

Power Cord Protection: Power supply cords should be routed so

that they are not likely to be walked on or pinched by items placed

upon or against them,paying particular attention to cords at plugs,

convenience receptacles,and the point where they exit from the

appliance.

Servicing: To reduce the risk of fire or electrical shock,the user

should not attempt to service the appliance beyond that described in

the operating instructions.All other servicing should be referred to

qualified service personnel.

For units equipped with externally accessible fuse recepta-

cle: Replace fuse with same type and rating only.

Electromagnetic Compatibility

Operation is subject to the following conditions:

•This device may not cause harmful interference.

•This device must accept any interference received,including interfer-

ence that may cause undesired operation.

•Use only shielded interconnecting cables.

•Operation of this unit within significant electromagnetic fields should

be avoided.

DECLARATION OF CONFORMITY

Manufacturer’s Name: Digitech Electronics

Manufacturer’s Address: 8760 S. Sandy Parkway

Sandy, Utah 84070, USA

declares that the product:

Product Name: Whammy/Whammy4

Product Options: All (requires a Class II power adapter that conforms to the requirements of

EN60065, EN60742, or equivalent.)

conforms to the following Product Specifications:

Safety: EN 60065 (1993)

IEC 65 (1985) with Amendments 1, 2 & 3

EMC: EN 55013 (1990)

EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage Directive

73/23/EEC and EMC Directive 89/336/EEC as amended by Directive 93/68/EEC.

Digitech

Vice-President of Engineering

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

Tel: 801-566-8800

Fax: 801-566-7005

Effective February 15, 2000

European Contact: Your Local Digitech Sales and Service Office or

Harman Music Group

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

Tel. 801-568-7638

Fax 801-568-7642

Warranty

We at Digitech are very proud of our products and back-up each one we sell with the following warranty:

1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty.

2.Digitech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.

3.Digitech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect,provided the product is

returned to DigitechWITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year.A ReturnAuthorization

number may be obtained from Digitech by telephone.The company shall not be liable for any consequential damage as a result of the product's use in

any circuit or assembly.

4.Proof-of-purchase is considered to be the burden of the consumer.

5.Digitech reserves the right to make changes in design, or make additions to, or improvements upon this product without incurring any obligation to

install the same on products previously manufactured.

6.The consumer forfeits the benefits of this warranty if the product's main assembly is opened and tampered with by anyone other than a certified

Digitech technician or,if the product is used with AC voltages outside of the range suggested by the manufacturer.

7.The foregoing is in lieu of all other warranties,expressed or implied,and Digitech neither assumes nor authorizes any person to assume any obligation

or liability in connection with the sale of this product.In no event shall Digitech or its dealers be liable for special or consequential damages or from

any delay in the performance of this warranty due to causes beyond their control.

NOTE: The information contained in this manual is subject to change at any time without notification. Some information contained in this manual

may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed. The

information contained in this version of the owner's manual supersedes all previous versions.

Congratulations on the purchase of your new Whammy™ Pedal. When DigiTech invented

the Whammy™ pedal, it was the most revolutionary and innovative pedal to hit the guitar since

the the wah wah. Nearly a decade later, in response to your demands, we have gone to

painstaking lengths to bring back the original Whammy™. Every last detail was considered as we

recreated this classic pitch bending effect. However, we strengthened the rugged steel chassis to

endure the perils of the stage better, the addition of a MIDI input provides more flexibility, pre-

set LEDs provide a visual indication of your selection, and the Dive Bomb setting bends your sig-

nal a full 3 octaves down. We are proud to bring back this pedal, and we’re proud that you

wanted it. Although the Whammy™ has an extremely intuitive user interface, this User’s Guide

will help you understand the Whammy™ functions and allow you to get the most out of your

purchase for years to come.

Included Items

The utmost care was taken while your Whammy™ was being manufactured. Everything should

be included and in perfect working order. Before you get started, please make sure that the

following items have been included:

• Whammy™ Pedal

• PS750 or PS0913B Power Supply

• User’s Guide

• Warranty Card

If anything is missing, contact the factory at once. Please take a moment to complete your

warranty card. It is your safeguard should a problem arise with your Whammy™.

Page1

User’s Guide

Guided Tour

Detailed Descriptions

1. Preset Knob - This knob is used to select the Whammy™ (bend), Harmony intervals, or

Detune range controlled by the treadle.

2. Effect LED - This LED lights to indicate the effect is on.



Page2

User’s Guide

3. Treadle - This Pedal is used to bend the input note, bend between harmony intervals, or mix

detuning with your input signal.

4. Effect Switch - This switch turns the effect on and off.

5. Input - Connect your instrument to this jack.

6. MIDI In - Connect any external MIDI device to this jack for the purpose of controlling the

Whammy™ remotely.

7. Power - Connect the provided power supply to this jack. Do not use any power supply

other than the supplied PS750 or PS0913B.

8. Dry Out - This jack contains your dry guitar signal only. No effect is present at this output.

9. Wet Added - This jack contains a mix of your dry guitar signal, and the pitch shifted signal

produced by the Whammy™.

Page3

User’s Guide

Making Connections

The Whammy™ pedal is extremely easy to set up and use. Simply follow these steps and you be

Whammin.

1. Connect your instrument to the Whammy™ input.

2. Connect from the “Wet Added” output to your favorite distortion pedal or to your amplifier.

3. Connect from the Whammy™ Dry Out to a guitar tuner if desired.

4. Connect from the MIDI Out of a MIDI controller to the MIDI In on the Whammy™ if

desired.

5. Connect the power supply between an AC outlet and the power jack on the Whammy™.

6. Turn on you amp and adjust the volume to a desired level.

7. Rotate the Preset knob to select the desired effect or interval.



Distortion Pedal

Tuner

Dry Out

Wet Added Input

AC Power

MIDI Out

MIDI In

Page4

User’s Guide

About the Whammy™

The Whammy™ pedal contains 17 Presets which are selected by rotating the Preset knob. An

LED will light to indicate which preset has been selected. Each Preset will fall into one of three

groups: Whammy, Harmony, or Detune.

Whammy - This group of Presets will bend your incoming signal either up or down depending

upon the Preset you have chosen. As the treadle is rocked back and forth, the signal will bend

from the original input pitch, to the pitch specified by the selected Preset. Whammy Presets

include:

2 Oct Up - Bends your input note two octaves up.

1 Oct Up - Bends your input note one octave up.

1 Oct Dn - Bends your input note one octave down.

2 Oct Dn - Bends your input note two octaves down.

Dive Bomb - Bends your input note three octaves

down.

Drop Tune - Bends your input note two semi-tones

down with a reversed pedal action.

Whammy

Presets

Page5

User’s Guide

Harmony - This group of Presets adds a harmony to your incoming signal. Both the harmony

note and the input signal are mixed together as if two guitars were playing simultaneously. As

you rock the pedal back and forth, the harmony note bends between two intervals specified by

the selected Preset but the input signal remains unchanged. Harmony Presets include:

Oct Up/Oct Dn - Bends the harmony between one octave below

(toe up) and one octave above (toe down) the

input note.

5th Dn/4th Dn - Bends the harmony between a fifth (toe up) and a

fourth (toe down) below the input note.

4th Dn/3rd Dn - Bends the harmony between a fourth (toe up) and

a minor third (toe down) below the input note.

5th Up/7th Up - Bends the harmony between a fifth (toe up) and a

dom seventh (toe down) above the input note.

5th Up/6th Up - Bends the harmony between a fifth (toe up) and a

sixth (toe down) above the input note.

4th Up/5th Up - Bends the harmony between a fourth (toe up) and

a fifth (toe down) above the input note.

3rd Up/4th Up - Bends the harmony between a third (toe up) and

a fourth (toe down) above the input note.

Min 3rd Up/3rd Up - Bends the harmony between a minor third

(toe up) and a Major third (toe down) above

the input note.

2nd Up/3rd Up - Bends the harmony between a second (toe up)

and a third (toe down) above the input note.

Harmony

Presets

Page6

User’s Guide

Otros manuales para Bass Whammy

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Pedal de música de digi-tech

digi-tech

digi-tech Modeling Guitar Processor and USB Recording Interface... Manual de usuario

digi-tech

digi-tech PDS1700 Manual de usuario

digi-tech

digi-tech RP80 Manual de usuario

digi-tech

digi-tech GSP-21PRO Manual de usuario

digi-tech

digi-tech PDS2715 Manual de usuario

digi-tech

digi-tech JAMMAN STEREO Manual de usuario

digi-tech

digi-tech RP50 Manual de usuario

digi-tech

digi-tech RPX400 Manual de usuario

digi-tech

digi-tech RP-1 Manual de usuario

digi-tech

digi-tech RP100 Manual de usuario

digi-tech

digi-tech Bass Whammy Manual de usuario

digi-tech

digi-tech HARDWIRE TL-2 Manual de usuario

digi-tech

digi-tech Element Manual de usuario

digi-tech

digi-tech JamMan Solo Manual de usuario

digi-tech

digi-tech Control Seven Manual de usuario

digi-tech

digi-tech whammy ricochet Manual de usuario

digi-tech

digi-tech Element Manual de usuario

digi-tech

digi-tech GRUNGE Manual de usuario

digi-tech

digi-tech PDS3500 Manual de usuario

digi-tech

digi-tech RPX400 Manual de usuario

digi-tech

digi-tech HARDWIRE CM-2 Manual de usuario

digi-tech

digi-tech Mosaic Manual de usuario

digi-tech

digi-tech Hot Box PDS 2730 Manual de usuario

digi-tech

digi-tech GSP 21 Legend Manual de usuario

Manuales populares de Pedal de música de otras marcas

Behringer

Behringer ULTRA WAH UW300 Manual de usuario

Whirlwind

Whirlwind oc-bass Manual de usuario

Strymon

Strymon Lex-rotary Manual de usuario

Behringer

Behringer PB600 Manual de usuario

Lexicon

Lexicon MX200 Manual de usuario

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Manual de usuario

Matthews Effects

Matthews Effects Whaler V2 Manual de usuario

Grid 1

Grid 1 Pedal Jeanie Manual de usuario

Amptweaker

Amptweaker tightboost Manual de usuario

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Manual de usuario

PuzzleSounds

PuzzleSounds DR. Q ENVELOPE FILTER Manual de usuario

BYOC

BYOC Analog Chorus Manual

Dimavery

Dimavery EPVP-50 Manual de usuario

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Manual de usuario

Pro-MIDI

Pro-MIDI G25 Manual de usuario

DW 7000 Manual de usuario

FAMC

FAMC Liquid-Foot Jr. Series Manual de usuario

Dimavery

Dimavery EPOD-50 Overdrive Manual de usuario