Dell PowerEdge R905 Manual de usuario
Dell™ PowerEdge™
R905 Systems
Getting Started
With Your System
Začínáme se systémem
Guide de mise en route
Erste Schritte mit dem System
Τα πρώτα βήµατα µε το σύστηµά σας
Rozpoczęcie pracy z systemem
Начало работы с системой
Procedimientos iniciales con el sistema
תכרעמה ע הדובעה תליחת
Dell™ PowerEdge™
R905 Systems
Getting Started
With Your System
Notes, Notices, and Cautions
NOTE: A NOTE indicates important information that helps you make better use
of your computer.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data
and tells you how to avoid the problem.
CAUTION: A CAUTION indicates a potential for property damage, personal injury,
or death.
____________________
Information in this document is subject to change without notice.
© 2007 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly
forbidden.
Trademarks used in this text: Dell, the DELL logo and PowerEdge are trademarks of Dell Inc.; AMD,
AMD Opteron and combinations thereof are trademarks of Advanced Micro Devices, Inc.; Microsoft,
Windows and Windows Server are either trademarks or registered trademarks of Microsoft Corporation
in the United States and/or other countries; Red Hat and Enterprise Linux are registered trademarks
of Red Hat, Inc.; SUSE is a registered trademark of Novell, Inc. in the United States and other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming
the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and
trade names other than its own.
Model EMMA
December 2007 P/N NX805 Rev. A00
Getting Started With Your System 3
System Features
This section describes the major hardware and software features of your
system. It also provides information about other documents you may
need when setting up your system and how to obtain technical assistance.
• Two or four dual-core or quad-core AMD Opteron™ 8000 Series
processors.
• A minimum of 2 GB (dual-processor systems) or 4 GB (four-processor
systems) of 667-MHz DDR2 memory modules. Memory is upgradable
to a maximum of 128 GB (256 GB when 8-GB memory modules are
available) by installing combinations of 512-MB, 1-GB, 2-GB, 4-GB,
or 8-GB (when available) memory modules in the 32 memory module
sockets (8 per processor) on the system board and Processor Expansion
Module (PEM).
• 800-MHZ DDR2 memory modules are supported in restricted
configurations.
• An optional slim-line SATA DVD-ROM drive, slim-line SATA DVD-RW
drive, or a combination CD-RW/DVD drive (when available).
NOTE: DVD devices are data only.
• Support for up to five 3.5-inch hot-plug SAS hard drives or up to eight
2.5-inch hot-plug SAS hard drives.
• An optional external USB diskette drive.
• An optional external USB optical drive.
• Two hot-pluggable, 1100W high efficiency power supplies in a 1 + 1
redundant configuration. The power supplies support an input voltage
range from 100 V to 240 V.
• Four hot-pluggable system cooling fans.
The system board provides the following features:
• The baseboard has CPU 1 and CPU 2 sockets with 16 DIMM slots.
• CPU 3 and CPU 4 and their 16 DIMM slots are on a separate PEM.
• Dedicated PCIe slot for a SAS controller.
4Getting Started With Your System
• Two x8 lane-width PCI-Express (PCIe) expansion slots and five x4 lane-
width PCIe slots.
• Four integrated Gb Ethernet NICs, capable of supporting 10-Mbps,
100-Mbps, and 1000-Mbps data rates. Each NIC also supports TCP/IP
offload engine (TOE) and iSCSI boot functionality. Two of the integrated
NICs are on a daughter card that can be upgraded to 10Gb Ethernet.
• An integrated Trusted Platform Module (TPM) version 1.2 used for
security applications, capable of generating and storing keys and storing
passwords and digital certificates. (Not available in China.)
• Four external USB 2.0-compliant ports, capable of supporting a diskette
drive, an optical drive, a keyboard, a mouse, or a USB flash drive.
• One internal USB 2.0-compliant connector.
• One internal connector for an optional flash memory card.
• Systems management circuitry that monitors operation of the system
fans as well as critical system voltages and temperatures. The systems
management circuitry works in conjunction with the systems management
software.
• Standard Baseboard Management Controller (BMC) with serial access.
• An optional remote access controller (RAC) card for remote systems
management.
•
An integrated VGA-compatible video subsystem based on an integrated
ATI RN50 33-MHz PCI
video controller. The video subsystem includes
16 MB of graphics memory and supports various 2D graphics video
modes. Maximum resolution is 1600x1280 with 65,536 colors.
(
When the optional RAC is installed, the integrated video subsystem
is disabled and the video controller on the RAC is used instead.)
• Front-panel support for a video connector, two USB connectors,
and a 1x5 LCD panel for system ID and error messaging.
• Back-panel connectors including one serial, one video, two USB,
and four NIC connectors.
• System ID button on the front and back panels.
For more information about specific features, see “Technical Specifications”
on page 10.
Getting Started With Your System 5
Supported Operating Systems
Your system supports the following operating systems:
• Microsoft
®
Windows Server
®
2003 R2 Standard and Enterprise Editions
(SP1 and later)
• Microsoft Windows Server 2003 R2 Standard and Enterprise x64 Editions
(SP1 and later)
•RedHat
®
Enterprise
®
Linux Server 5 AP (x86)
• Red Hat Enterprise Linux Server 5 AP (x86_64)
• Red Hat Enterprise Linux Server AS (Version 4.5) (x86)
• Red Hat Enterprise Linux Server AS (Version 4.5) (x86_64)
•SUSE
®
Linux Enterprise Server 10 (x86_64)
• VMware ESX Server 3 (including embedded versions)
NOTE: For the latest information on supported operating systems,
see www.dell.com.
Other Information You May Need
CAUTION: The Product Information Guide provides important safety and
regulatory information. Warranty information may be included within this
document or as a separate document.
• The
Rack Installation Guide
or
Rack Installation Instructions
included
with your rack solution describes how to install your system into a rack.
• The
Hardware Owner’s Manual
provides information about system
features and describes how to troubleshoot the system and install or
replace system components. This document may be found on the CDs
that came with your system or at
support.dell.com
.
• CDs included with your system provide documentation and tools
for configuring and managing your system.
6Getting Started With Your System
• Updates are sometimes included with the system to describe changes
to the system, software, and/or documentation.
NOTE: Always check for updates on support.dell.com and read the updates
first because they often supersede information in other documents.
• Release notes or readme files may be included to provide last-minute
updates to the system or documentation or advanced technical reference
material intended for experienced users or technicians.
Obtaining Technical Assistance
If you do not understand a procedure in this guide or if the system
does not perform as expected, see your Hardware Owner’s Manual.
Dell Enterprise Training and Certification is available; see
www.dell.com/training for more information. This service may not
be offered in all locations.
Installation and Configuration
CAUTION: Before performing the following procedure, read and follow the safety
instructions and important regulatory information in your Product Information
Guide.
This section describes the steps to set up your system for the first time.
Unpacking the System
Unpack your system and identify each item.(Your system may not include
the optional rack kit and bezel shown here.)
Keep all shipping materials in case you need them later.
Getting Started With Your System 7
Installing the System in a Rack
Install the system in the rack once you have read the “Safety Instructions”
located in the rack installation documentation for your system.
See your rack installation documentation for instructions on installing
your system in a rack.
Connecting the Keyboard, Mouse, and Monitor
Connect the keyboard, mouse, and monitor (optional).
8Getting Started With Your System
The connectors on the back of your system have icons indicating which cable
to plug into each connector. Be sure to tighten the screws (if any) on the
monitor's cable connector.
NOTE: If you simultaneously connect two monitors to the system, using the front
and back video connections, the video will default to the front since only one
display can operate at a time.
Connecting the System and Monitor Power Cables
Connect the monitor's power cable to the monitor (optional). Connect the
system’s power cables to the system.
Plug the other end of the power cables into a grounded electrical outlet or
a separate power source such as an uninterrupted power supply (UPS) or a
power distribution unit (PDU). If possible, connect the power supplies to two
different 110V power sources or two different 220V power sources, depending
on the power sources used.
Otros manuales para PowerEdge R905
2
Tabla de contenidos
Idiomas:
Otros manuales de Servidor de Dell
Dell
Dell Dimension 2200 Manual de usuario
Dell
Dell EMC VxFlex Ready Node 14G Manual de usuario
Dell
Dell PowerEdge SC1435 Manual técnico
Dell
Dell PowerEdge T105 Systems Manual de usuario
Dell
Dell PowerEdge 6600 Manual de usuario
Dell
Dell PowerEdge T320 Guía de inicio rápido
Dell
Dell DX6000 Manual de usuario
Dell
Dell PowerEdge T320 Guía de inicio rápido
Dell
Dell PowerVault 735N Manual de lista de piezas
Dell
Dell DR4000 Restore Manager Manual de usuario
Dell
Dell PowerEdge FX2 Guía de referencia rápida
Dell
Dell PowerEdge T620 Guía de inicio rápido
Dell
Dell PowerEdge C1100 Manual de usuario
Dell
Dell PowerEdge C6145 Manual de usuario
Dell
Dell PowerEdge 6450 Manual técnico
Dell
Dell PowerEdge 2900 Manual de usuario
Dell
Dell PowerEdge R415 Manual de usuario
Dell
Dell PowerEdge E31S Series Manual de usuario
Dell
Dell PowerEdge R910 Manual de usuario
Dell
Dell PowerEdge R210 Manual técnico
