Datamax H-4212X Manual de usuario

Operator’s Manual

CG Triumvirate is a trademark of Agfa Corporation.

CG Times based upon Times New Roman under license from the Monotype Corporation.

Windows is a registered trademark of the Microsoft Corporation.

Ethernet is a registered trademark of Xerox Corporation.

All other brand and product names are trademarks, service marks, registered trademarks,

or registered service marks of their respective companies.

Firmware (Software) Agreement

The enclosed Firmware (Software) resident in the Printer is owned by Licensor or its

suppliers and is licensed for used only on a single printer in the user’s Trade or Business.

The User agrees not to, and not to authorize or permit any other person or party to

duplicate, or copy the Firmware or the information contained in the non-volatile or

programmable memory. The firmware (Software) is protected by applicable copyright

laws and Licensor retains all rights not expressly granted. In no event will Licensor or its

suppliers be liable for any damages or loss, including direct, incidental, economic, special, or

consequential damages arising out of the use or inability to use the Firmware (Software).

Information in this document is subject to change without notice and does not represent a

commitment on the part of Datamax Barcode Products Corporation. No part of this manual

may be reproduced or transmitted in any form or by any means, for any purpose other than

the purchaser's personal use, without the expressed written permission of Datamax

Corporation.

Part Number: 88-2329-01

Revision: E

Agency Compliance and Approvals

C US

Listed

UL60950-1: 2003 1st Edition Information Technology Equipment

CSA C22.2 No. 60950-1-03 1st Edition; April 2003

EN60950

For 230 Volt Operation (Europe): Use a cord set, marked "HAR," consisting of a min

H05VV-F cord which has a minimum 0.75 square mm diameter conductors, provided

with an IEC 320 receptacle and a male plug for the country of installation rated 6A,

250V

Für 230 Volt (Europa): Benützen Sie ein Kabel, das mit "HAR" markiert ist, bestehend

mindestens aus einem H05VV-F Kabel, das mindestens 0,75 Quadratmillimeter

Drahtdurchmesser hat; sowie eine IEC320 Steckdose und einen für das Land

geeigneten Stecker, 6A, 250 Volt.

As an Energy Star Partner, the manufacturer has determined that this product meets

the Energy Star guidelines for energy efficiency.

The manufacturer declares under sole responsibility that this product conforms to the

following standards or other normative documents:

EMC: EN 55022 (1993) Class B

EN 50024 (1998)

Safety: This product complies with EN 60950-1, 1st Edition

Gost-R

FCC: This device complies with FCC CFR 47 Part 15 Class A.

Note: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy, and if

not installed and used in accordance with the instructions in this manual, it may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be required to correct the interference

at their own expense.

Important Safety Instructions

The exclamation point within an equilateral triangle is intended to alert the user

to the presence of important operating and maintenance instructions.

This unit has been carefully designed to provide years of safe, reliable performance. As with

all electrical equipment, however, there are some basic precautions that you should follow

to avoid personal injury or printer damage:

yBefore using the printer, carefully read all the installation and operating instructions.

yObserve all warning instruction labels on the printer.

yInstall the printer on a flat, firm surface.

yDo not place the printer upon or near a heat source.

yNever insert anything into the ventilation slots and openings of the printer.

yDo not use the printer near water or spill liquid into it.

yEnsure that the AC power source matches the ratings listed for the printer. (If unsure,

check with your dealer or local utility provider.)

yDo not step on the AC power cord. If the AC power cord becomes damaged or frayed,

replace it immediately.

yIf the printer ever needs repair, consult only qualified, trained service personnel. No

user-serviceable parts are inside; do not remove the cover.

Special Instructions

;

The green check box is intended to alert the user to conventions used within this

text or to notable operating details of the printer.

Contents

Overview ...........................................................................................1

1.1 About the Printer ...................................................................................1

1.1.1 Standard Features ...................................................................... 2

1.1.2 Optional Features ....................................................................... 3

Getting Started..................................................................................7

2.1 Unpacking............................................................................................. 7

2.1.1 Additional Requirements.............................................................. 8

2.2 Installation ........................................................................................... 8

2.2.1 Connecting the Power Cord .......................................................... 8

2.2.2 Connecting the Interface Cable(s)................................................. 9

2.2.3 Connecting to the SDIO Slot and USB Host Ports........................... 11

Setting up the Printer......................................................................13

3.1 Media Loading ...................................................................................... 13

3.1.1 Internal Media Sources.............................................................. 15

3.1.2 External Media Sources ............................................................. 17

3.1.3 Rewinding Media....................................................................... 19

3.2 Media Sensor Adjustment...................................................................... 25

3.3 Ribbon Loading.................................................................................... 26

3.4 Quick Calibration ................................................................................. 29

Using the Control Panel ...................................................................31

4.1 Layout................................................................................................ 31

4.1.1 The Display, Icons and Indicators, and Keys and Buttons ............... 32

4.2 The Menu System ................................................................................ 33

4.2.1 Media Settings ......................................................................... 35

4.2.2 Print Control ............................................................................ 38

4.2.3 Printer Options......................................................................... 40

4.2.4 System Settings ....................................................................... 51

4.2.5 Communications....................................................................... 60

4.2.6 Diagnostics.............................................................................. 67

4.2.7 MCL Options ............................................................................ 70

4.3 The Test Menu..................................................................................... 71

4.3.1 Print Quality Label .................................................................... 71

4.3.2 Ribbon Test Label ..................................................................... 72

4.3.3 Test Label................................................................................ 72

4.3.4 Validation Label........................................................................ 72

4.3.5 Print Configuration.................................................................... 73

4.3.6 Print Last Label ........................................................................ 73

4.3.7 User-Defined Label ................................................................... 73

Operating, Adjusting and Maintaining the Printer............................75

5.1 Display Messages................................................................................. 75

5.1.1 Prompts and Condition Messages ................................................ 75

5.2 Calibration .......................................................................................... 78

5.2.1 Standard Calibration ................................................................. 78

5.2.2 Advanced Entry Calibration ........................................................ 80

5.3 Reset Methods..................................................................................... 88

5.3.1 Soft Reset ............................................................................... 88

iii

5.3.2 Level One Reset ....................................................................... 88

5.3.3 Level Two Reset ....................................................................... 88

5.4 Printhead Assembly Adjustments............................................................ 88

5.4.1 Leveling Cam Adjustment .......................................................... 88

5.4.2 Printhead Pressure Adjustment................................................... 90

5.5 Printhead Removal and Replacement ...................................................... 91

5.6 Maintenance........................................................................................ 92

5.6.1 Cleaning the Exterior Surfaces.................................................... 94

5.6.2 Cleaning the Fan Filter............................................................... 94

5.6.3 Cleaning the Interior Compartment ............................................. 95

5.6.4 Cleaning the Media Sensing Components ..................................... 95

5.6.5 Cleaning the Platen and Assist Rollers.......................................... 96

5.6.6 Cleaning the Printhead .............................................................. 97

5.6.7 Cleaning the Ribbon Path Components......................................... 99

5.7 Updating the Firmware ........................................................................100

5.8 Updating the Boot Loader.....................................................................102

5.9 Downloading Fonts..............................................................................103

Troubleshooting ............................................................................105

6.1 Problem Resolution .............................................................................105

6.1.1 General Resolutions .................................................................105

6.2 Warning and Fault Messages.................................................................109

6.3 Hex Dump Mode .................................................................................116

Specifications ................................................................................117

7.1 General .............................................................................................117

7.2 Model-Specific Specifications ................................................................118

7.3 Approved Media and Ribbon .................................................................128

7.4 Print Quality Controls ..........................................................................130

Appendix A ....................................................................................131

Module Assignments, and File Handling Definitions and Messages.....................131

Appendix B ....................................................................................135

Resolutions, Widths, Speeds, Emulations, and Custom Adjustment Settings.......135

Appendix C ....................................................................................139

RS-422/485 Port Configuration....................................................................139

Appendix D....................................................................................141

Changing the Display Language...................................................................141

Appendix E ....................................................................................145

Saving a Configuration File..........................................................................145

Appendix F ....................................................................................147

Ethernet Setup..........................................................................................147

Appendix G....................................................................................149

Using the HTML Pages................................................................................149

Appendix H....................................................................................157

Printer Driver and Port Setup ......................................................................157

Warranty Information ...................................................................171

Glossary ........................................................................................173

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Impresora de Datamax

Datamax

Datamax Ex2 Manual de usuario

Datamax

Datamax PrintPAD CN70 Manual de usuario

Datamax

Datamax MP Compact4 Mark II Manual de usuario

Datamax

Datamax Apex 3 Manual de usuario

Datamax

Datamax H Class Manual de usuario

Datamax

Datamax OC-3 Series Manual de usuario

Datamax

Datamax A-Class A-4310 Manual de operación y mantenimiento

Datamax

Datamax I-Class Mark II Manual de usuario

Datamax

Datamax Workstation w1110 Manual de usuario

Datamax

Datamax M-Class Mark II M-4206 Manual de usuario

Datamax

Datamax I-Class Mark II Manual de usuario

Datamax

Datamax I-Class Manual de usuario

Datamax

Datamax A-Class Mark II Manual de usuario

Datamax

Datamax H-Class Manual de usuario

Datamax

Datamax OC-2 series Manual de usuario

Datamax

Datamax ST-3210 Manual de operación y mantenimiento

Datamax

Datamax Apex 2 Manual de usuario

Datamax

Datamax MP Compact4 Mark II Manual de usuario

Datamax

Datamax H-Class Manual de usuario

Datamax

Datamax Mark II E-4205e Manual de usuario

Datamax

Datamax MICROFLASH 4TE Manual de usuario

Datamax

Datamax MP-Compact4 Manual

Datamax

Datamax MICROFLASH 4T Manual de usuario

Datamax

Datamax ST-3210 Manual de usuario

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Epson

Epson ET-7750 Instrucciones de funcionamiento

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Epson

Epson SC-F7100 series Manual de usuario

Epson

Epson Stylus C40UX Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario