Danfoss 176F6636 Manual de usuario

Description

The door fan replacement kit contains parts required to install

1 door fan in E1h/E2h drives in IP21/IP54 enclosures.

Kit Ordering Number

Kit number Kit description

176F6636 Door fan for E1h/E2h drives

Table 1.1 Ordering Number for the Door Fan Kit

Items Supplied

The door fan replacement kit contains the following:

•

1 fan

•

Installation instructions

Safety Instructions

Only qualied, Danfoss authorized personnel are allowed to

install the parts described in these installation instructions.

Handling of the drive and its parts must be done in

accordance with the corresponding operating guide.

WARNING

ELECTRICAL SHOCK HAZARD

VLT

FC series drives contain dangerous voltages when

connected to mains voltage. Improper installation, and

installing or servicing with power connected, can cause

death, serious injury, or equipment failure.

To avoid death, serious injury, or equipment failure:

•

Only use qualied electricians for the installation.

•

Disconnect the drive from all power sources before

installation or service.

•

Treat the drive as live whenever the mains voltage

is connected.

•

Follow the guidelines in these instructions and local

electrical safety codes.

WARNING

DISCHARGE TIME

The drive contains DC-link capacitors, which can remain

charged even when the drive is not powered. High voltage

can be present even when the warning LED indicator lights

are o. Failure to wait 40 minutes after power has been

removed before performing service or repair work can result

in death or serious injury.

•

Stop the motor.

•

Disconnect AC mains and remote DC-link power

supplies, including battery back-ups, UPS, and DC-

link connections to other drives.

•

Disconnect or lock PM motor.

•

Wait 40 minutes for capacitors to discharge fully.

•

Before performing any service or repair work, use

an appropriate voltage measuring device to make

sure that the capacitors are fully discharged.

Removing the Door Fan

The enclosure door includes 2 fan assemblies at the door top.

To remove and replace the door fan, use the following

procedures. Refer to Illustration 1.1.

1. Pinch together the release tabs on the front grill and

remove the grill from the enclosure door.

2. Remove the fan lter.

3. Inside the enclosure door, unplug the in-line

connector attaching the fan cable.

4. Detach 4 screws (T20), 2 nuts, and 2 corner brackets

from the corners of the fan. When removing the

screws, hold each nut (7 mm) with a wrench on the

opposite side of the fan.

5. Remove the fan from the enclosure door.

Installing the Door Fan

1. Position the fan in the door of the enclosure. Check

that the air direction arrows point away from the

internal drive components when the door is closed.

2. On the inner side of the door, replace the 2 brackets

at opposite corners of the fan and secure with 2

screws (T20).

Installation Instructions

Door Fan Replacement for E1h/E2h Drives

VLT®FC Series FC 102, FC 103, FC 202, and FC 302

3. Replace 2 screws in the remaining 2 corners of the

fan, securing each with a nut (7 mm).

4. Reconnect the in-line cable connector attaching the

fan cable.

5. Replace the lter over the fan on the outside of the

door.

6. Reposition the fan grill over the lter and press to

snap into place.

1 Front grill 5 Door fan front view

2 Release tab 6 Nut (7 mm)

3Fanlter 7 Cornerbracket

4 Screw (T20) 8 Door fan back view

Illustration 1.1 Door Fan Assembly

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on

order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss

Danfoss A/S

Ulsnaes 1

DK-6300 Graasten

vlt-drives.danfoss.com

*MI35M202*

MI35M202130R0766 03/2018

Otros manuales de Accionamiento de CC de Danfoss

Danfoss

Danfoss VLT Decentral FCD 300 Manual de usuario

Danfoss

Danfoss VLT 5000 Series Manual de usuario

Danfoss

Danfoss VLT Midi Drive FC 280 Instrucciones de funcionamiento

Danfoss

Danfoss VLT 5000 Series Manual de usuario

Danfoss

Danfoss MCB 113 Manual de usuario

Danfoss

Danfoss VLT MCB 115 Manual de usuario

Danfoss

Danfoss VLT HVAC Basic Drive FC 101 Manual de usuario

Danfoss

Danfoss VLT FC Series Manual de usuario

Danfoss

Danfoss VLT Automation Drive FC 300 Manual de usuario

Danfoss

Danfoss E3h Manual de usuario

Danfoss

Danfoss FC103-110-250Kw Manual de usuario

Danfoss

Danfoss VLT AutomationDrive FC 360 Manual de usuario

Danfoss

Danfoss Vacon NXS Series Manual de usuario

Danfoss

Danfoss VLT AutomationDrive EZ FC 321 Instrucciones de funcionamiento

Danfoss

Danfoss VLT Guía

Danfoss

Danfoss VLT 5000 Series Manual de usuario

Danfoss

Danfoss VLT AQUA Drive FC 202 Manual de usuario

Danfoss

Danfoss vlt aqua Manual de usuario

Danfoss

Danfoss VLT FC 103 Manual de usuario

Danfoss

Danfoss VLT HVAC Drive FC 102 Manual de usuario

Danfoss

Danfoss vlt fcd 302 Manual de usuario

Danfoss

Danfoss VLT PROFINET MCA 120 Manual de usuario

Danfoss

Danfoss VLT FC 103 Guía

Danfoss

Danfoss MCD 500 Manual de usuario

Manuales populares de Accionamiento de CC de otras marcas

Vincent Associates

Vincent Associates UNIBLITZ ED12DSS Manual de usuario

EKSMA OPTICS

EKSMA OPTICS DQ-100-4 Manual de lista de piezas

Chamberlain Garog

Chamberlain Garog D Series Manual de usuario

Parker

Parker PDS Series Manual de usuario

Festo

Festo DGC G Series Guía de configuración

Binks

Binks QS-5012-1-CE Manual de usuario

ABB

ABB ACQ580-01 Series Manual de instalación

YASKAWA

YASKAWA CANopen SI-S3 Manual de usuario

GE D20A6 Manual de usuario

Unex

Unex MC-D-250-1000-050W-TW Manual de usuario

Geckodrive

Geckodrive G213V Manual de usuario

ABB

ABB RSYC-01 Manual de usuario

Rockwell Automation

Rockwell Automation PowerFlex 700S Manual del propietario

WEG

WEG DeviceNet CFW500 Manual de usuario

Siemens

Siemens SINAMICS G Hoja de datos

Siemens

Siemens SINAMICS SM150 6SL3815-7NP41-0AA1 Instrucciones de funcionamiento

SOMFY

SOMFY JR RU 30 Manual de usuario

Beckhoff

Beckhoff AX8911 Manual del operador