D-Link DWL-3140AP - Web Smart PoE Thin Access Point Manual de usuario

Quick Install Guide

DWL-3140AP

Wireless 108G Web Smart Thin AP with PoE

2D-Link DWL-3140AP Hardware Installation Guide

System Requirements

Package Contents

• Access Point

• CD

• Ethernet Cable

• 5V 1.2A Power Adapter

• Mounting Bracket

• Mounting Kit

• A Network with a D-Link DES-1228P Wireless

Switch

This access point can only be used with a D-Link DES-1228P

wireless switch. Please refer to the xStack user manual for

conguration of the access point.

3 D-Link DWL-3140AP Hardware Installation Guide

Installation Considerations

D-Link wireless devices allow you access your network using a wireless connection

from virtually anywhere within the operating range of your wireless network. Keep

in mind, however, that the number, thickness and location of walls, ceilings, or

other objects that the wireless signals must pass through, may limit the range.

Typical ranges vary depending on the types of materials and background RF (radio

frequency) noise in your home or business. The key to maximizing wireless range

is to follow these basic guidelines:

1. Keep the number of walls and ceilings between the D-Link access point

and other network devices to a minimum - each wall or ceiling can reduce

your adapter’s range from 3-90 feet (1-30 meters.) Position your devices

so that the number of walls or ceilings is minimized.

2. Be aware of the direct line between network devices. A wall that is 1.5

feet thick (.5 meters), at a 45-degree angle appears to be almost 3 feet (1

meter) thick. At a 2-degree angle it looks over 42 feet (14 meters) thick!

Position devices so that the signal will travel straight through a wall or

ceiling (instead of at an angle) for better reception.

3. Building Materials make a difference. A solid metal door or aluminum

studs may have a negative effect on range. Try to position access points,

wireless routers, and computers so that the signal passes through drywall

or open doorways. Materials and objects such as glass, steel, metal, walls

with insulation, water (sh tanks), mirrors, le cabinets, brick, and concrete

will degrade your wireless signal.

4. Keep your product away (at least 3-6 feet or 1-2 meters) from electrical

devices or appliances that generate RF noise.

5. If you are using 2.4GHz cordless phones or X-10 (wireless products such as

ceiling fans, lights, and home security systems), your wireless connection

may degrade dramatically or drop completely. Make sure your 2.4GHz

phone base is as far away from your wireless devices as possible. The

base transmits a signal even if the phone is not in use.

4D-Link DWL-3140AP Hardware Installation Guide

Please read the following before you begin:

1. Do not operate the DWL-3140AP access point near unshielded

blasting caps or in an otherwise explosive environment unless the

device has been modied for such use by qualied personnel.

2. Do not touch or move the DWL-3140AP access point when the

antennas are transmitting or receiving.

3. Do not hold any radio device so that the antenna is very close to

or touching the face, eyes, or other exposed body part while the

device’s radio antenna is transmitting.

4. Before using a wireless device in a hazardous location, consult

the local codes, national codes, and safety directors of the

location for usage constraints.

5. Do not connect or disconnect cables or otherwise work with the

DWL-3140AP access point hardware during lightning storms.

6. The DWL-3140AP access point is intended for indoor use only.

Do not install the device outdoors.

7. To reduce the possibility of connection interference caused by

dust, clean the CAT 5 connector pins before inserting a cable

into an DWL-3140AP access point.

Before You Begin

5 D-Link DWL-3140AP Hardware Installation Guide

Front Panel

Rear Panel

Power Receptor

Receptor for the supplied power

adapter.

6D-Link DWL-3140AP Hardware Installation Guide

Rear Panel

Power LED

A solid green light indicates

a proper connection to the

power supply.

Ethernet Port

Connects the DWL-3140AP

to the DES-1228P switch

using an Ethernet cable.

LAN LED

A solid green light indicates

a connection to the Ethernet

port. This LED blinks during

data transmission.

Reset

Press the reset button to

restore the access point to

its original factory default

settings.

WLAN LED

A solid green light indicates a

wireless connection is ready.

This LED blinks during data

transmission.

7 D-Link DWL-3140AP Hardware Installation Guide

Mounting Options

You can mount a DWL-3140AP access point on any of the following

types of surfaces:

• Solid surface wall or ceiling

• Tabletop

Cable Requirement

The Ethernet ports on the DWL-3140AP access point cannot accept

a CAT 5 cable that has an uneven sheath. The RJ-45 connector on

the cable will not seat properly in the receptacle on the access point.

Use a CAT 5 cable with an even sheath instead.

Wall Installation Recommendations

If you plan to install an AP on a partial wall or other vertical surface,

orient the top of the access point (the side with the D-Link Logo)

toward the intended coverage area. The radio antennas transmit

through the top of the access point but not through the bottom

(where the bracket is).

DES-1228P Wireless Switch Recommendations

D-Link recommends that you install and congure the DES-1228P

wireless switch before installing an access point. If the switch is

already installed and congured for the access point(s), you can

immediately verify the cable connection(s) when you plug the

cable(s) into the access point.

Warning: The DWL-3140AP is designed to receive power only from

an 802.3af-compliant source, a D-Link DES-1228P wireless switch,

or a D-Link-approved power injector. Connecting an access point to

a Power over Ethernet (PoE) device that is not approved by D-Link

can damage the equipment.

8D-Link DWL-3140AP Hardware Installation Guide

Solid Wall or Ceiling Installation

1. Remove the mounting bracket from the DWL-3140AP.

2. Attach the bracket to the wall or ceiling.

3. Mark the points where you will use screws. Take out the bracket.

4. Drill the marked points and insert the plastic wall mount.

5. Let the power and CAT5 cable slide through the mounting

bracket.

6. Use the supplied screws to attach the bracket.

7. Plug the power cable into the access point.

9 D-Link DWL-3140AP Hardware Installation Guide

8. Plug the CAT 5 cable into the access point.

9. Attach the access point to the mounting bracket.

10. Gently pull the power cable and the ethernet cable as you slide

up to lock the access point onto the bracket.

Technical Support

You can nd software updates and user documentation on the D-Link website.

Tech Support for customers in

Australia:

Tel: 1300-766-868

24/7(24Hrs, 7days a week) technical support

http://www.dlink.com.au

e-mail: [email protected]

India:

Tel: 1800-222-002

9.00 AM to 9.00 PM. All days

http://www.dlink.co.in/support/productsupport.aspx

Indonesia, Malaysia, Singapore and Thailand:

Tel: +62-21-5731610 (Indonesia)

Tel: 1800-882-880 (Malaysia)

Tel: +65 6501 4200 (Singapore)

Tel: +66-2-719-8978/9 (Thailand)

24/7, for English Support Only

http://www.dlink.com.sg/support/

e-mail: [email protected]

Korea:

Tel: +82-2-2028-1815

Monday to Friday 9:00am to 6:00pm

http://www.d-link.co.kr

e-mail: [email protected]

New Zealand:

Tel: 0800-900-900

24/7(24Hrs, 7days a week) technical support

http://www.dlink.co.nz

e-mail: [email protected]

Otros manuales para DWL-3140AP - Web Smart PoE Thin Access Point

Tabla de contenidos

Idiomas:

Otros manuales de Punto de acceso inalámbrico de D-Link

D-Link

D-Link DBA-1210P Manual de usuario

D-Link

D-Link DAP-3520 - AirPremier N Dual Band Exterior PoE Access... Manual de usuario

D-Link

D-Link AirPremier N DAP-2310 Manual de usuario

D-Link

D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM... Manual de usuario

D-Link

D-Link DWL-G700AP - AirPlus G Access Point Manual de usuario

D-Link

D-Link DWL-3500AP Manual de usuario

D-Link

D-Link DAP-2553 - Wireless N Dual Band Gigabit Access... Manual de usuario

D-Link

D-Link DWL-2200AP - AirPremier - Wireless Access... Manual de usuario

D-Link

D-Link DAP-3320 Manual de usuario

D-Link

D-Link DAP-1360 Manual de usuario

D-Link

D-Link DIS-2650AP Manual de usuario

D-Link

D-Link AirPremier DAP-2565 Manual de usuario

D-Link

D-Link DWL-3260AP - AirPremier - Wireless Access... Manual de usuario

D-Link

D-Link AirPremier N DAP-2310 Manual de usuario

D-Link

D-Link DWL-1000AP+ Manual de usuario

D-Link

D-Link AirPremier N DAP-2310 Manual de usuario

D-Link

D-Link DWL-2230AP - xStack - Wireless Access Point Manual de usuario

D-Link

D-Link AirPremier N DAP-2310 Manual de usuario

D-Link

D-Link D DWL-8200AP DWL-8200AP Manual de usuario

D-Link

D-Link DAP-1665 Manual de usuario

D-Link

D-Link DAP-3220 Manual de usuario

D-Link

D-Link myPocket DIR-457 Manual de usuario

D-Link

D-Link AirPremier N DAP-2310 Manual de usuario

D-Link

D-Link Rangebooster N 650 Access Point DAP-1353 Manual de usuario

Manuales populares de Punto de acceso inalámbrico de otras marcas

Ubiquiti

Ubiquiti NanoStation NSM2 Manual de usuario

Cisco

Cisco Aironet 1550 Series Manual de usuario

Aruba

Aruba IAP-335 Manual de usuario

Advantek Networks

Advantek Networks AWN-AP-54MR Manual de usuario

IP-COM

IP-COM AP355 Manual de usuario

Buffalo

Buffalo AirStation WLA-L11G Manual de usuario

EnGenius

EnGenius EnStationACv2 Manual de usuario

xG Technology

xG Technology xMax CN1300 Manual de usuario

Widelink

Widelink ezWave WAP-1100 Series Manual de usuario

Edimax

Edimax CAP1200 Manual de usuario

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manual de usuario

Aruba

Aruba AP-203R Manual de usuario

LuXout Shades

LuXout Shades LUXSHADE MOTION Manual de usuario

CreatComm

CreatComm TB5F Manual de usuario

SineDigital

SineDigital MW-1500AP(H) Manual de usuario

TP-Link

TP-Link AP9650 V1 Manual de usuario

Draytek

Draytek VIGORAP 902 Manual de usuario

EnGenius

EnGenius EAP350 Manual de usuario