D-Link DWR-926 Manual de usuario
This document will guide you through the
basic installation process for your new D-Link
4G LTE M2M VPN Router.
DWR-926
Quick Installation Guide
4G LTE M2M VPN Router
Quick Installation Guide
DWR-926
2
ENGLISH
Before You Begin
This Quick Installation Guide gives you step-by-step instructions
for setting up your DWR-926 4G LTE VPN Router. The model you
have purchased may appear slightly dierent from the one
shown in the illustrations. For more detailed information about
the router, please refer to the User Manual.
Package Contents
This DWR-926 package should include the following items:
• DWR-926 4G LTE VPN Router
• AC adapter - 12 V/DC 2A
• RJ-45 cable
• [1] Interchangeable 3G/4G blade antennas
• [2] Interchangeable Wi-Fi Antennas
• Warranty Card
• Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link re-seller.
DWR-926 3
ENGLISH
Hardware Overview
Front Panel
1234 6 7
5
Figure 1
#Item Description
13G/4G DRX SMA female connector - Diversity 3G/4G antenna.
2Gateway
Solid Amber Gateway is booting up
Blinking
Amber
In Recovery Mode or abnormal situation
Solid Green Powered ON and working normally
3Cellular 1 Signal
Green:
LTE Mode
Flash(Fast): Signal Strength is 0~30%
Flash(Slow): Signal Strength is 31~60%
Solid: Signal Stregth is 61~100%
Amber:
HSPA/3G Mode
Flash(Fast): Signal Strength is 0~30%
Flash(Slow): Signal Strength is 31~60%
Solid: Signal Stregth is 61~100%
DWR-926
4
ENGLISH
#Item Description
4Wi-Fi
Green:
2.4GHz Wi-Fi\
enabled
Solid: Wireless Signal is enables
Flashing: Data packet transfered
Amber:
5GHz, or both
5 and 2.4 GHz
Wi-Fi enabled
Solid: Wireless Signal is enables
Flashing: Data packet transfered
O Wireless Signal is disabled
5LAN1/WAN
LAN2~LAN4
Blue Ethernet connection has been established
Data packet transferred via Ehthernet
O Wireless Signal is disabled
6USB For log or RS-232(TX/RX)
73G/4G MAIN SMA female connector - Primary Antenna for 3G/4G
Table 1
Rear Panel
Figure 2
#Item Description
13G/4G MAIN1SMA female connector - Primary Antenna for 3G/4G
2Wi-Fi Antenna 2 SMA male connector - Wi-Fi 2.
3Reset Press and hold for 10 seconds to restore factory
defaults.
4SIM 2x 4FF size nano-SIM slots.
1 2 3 4 5 6 78910
DWR-926 5
ENGLISH
#Item Description
5Ethernet LAN 1-4 Connect Ethernet devices such as computers,
switches, external APs, and NAS.
6Ethernet WAN Allows optional use of Ethernet as primary or fallback
WAN connection.
7Power input 12 V/DC 2A barrel connector.
8Power On/O Press to toggle power.
9Wi-Fi Antenna 1 SMA male connector - Wi-Fi 1.
10 3G/4G DRX SMA female connector - Diversity Antenna for 3G/4G
1Included antennas are interchangeable, but third party antennas may not be.
Table 2
Hardware Installation
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures, and personal injury:
• Install the DWR-926 in a cool and dry place. Refer to
the technical specications in the user manual for the
acceptable operating temperature and humidity ranges.
• Install the router in a site free from strong electromagnetic
sources, vibration, dust, excessive moisture, and direct
sunlight.
• Place antennas in an unobstructed area with clear mobile
signal. Avoid metal boxes, brick walls, and other dense
materials. It is recommended to use the web interface to
conrm signal strength before permanent installation.
DWR-926
6
ENGLISH
• Visually inspect the power connector and
make sure that it is fully secure.
• Do not stack any devices on top of the router.
Attaching the External Antennas
Figure 3: Attaching External Antennas
The DWR-926 requires four external antennas to function
correctly: two blade antennas for 3G/4G, and two Wi-Fi
antennas. The included antennas are interchangeable, but
third party antennas may require connection to specic ports.
1. Attach the blade antennas to the SMA connectors on the
side of the router. Turn clockwise to fasten each antenna. If
you are using third party antennas that require specic ports,
the port on the left side of the device is the“MAIN”antenna,
and the port on the right side is the“AUX”or “DRX”antenna.
DWR-926 7
ENGLISH
2. Attach theWi-Fi antennas to the SMA connectors on the back
of the router. Turn clockwise to fasten each antenna.
3. Position the antennas where they will receive optimal signal.
Arrange them so they point upward.
Figure 4: Router with Correctly Attached Antennas
Note: The included antennas are interchangeable. Third
party antennas may require connection to specic ports.
Installing a SIM card
The DWR-926 is equipped with x2 4FF size nano-SIM slots. An
active SIM card is required for 3G/4G access.
1. Unscrew the SIM slot cover on the front of the device.
2. Insert a nano-SIM card into the slot with the contacts facing
down.
DWR-926
8
ENGLISH
Figure 5: Installing a SIM card
3. Gently press the nano-SIM into the slot until it locks into
place.To remove, press again and the SIM card will be ejected.
4. Replace the cover and screws.
Note: SIM behavior must be congured from the web UI before
an Internet connection can be established.
Powering the Router
The router requires 12 volt power supply and a minimum of 2
amp.
Using the Included AC Adapter
1. Attach the barrel connector of included AC adapter to the
DWR-926 power port on the rear panel.
2. Attach the AC adapter to an appropriate AC socket.
DWR-926 9
ENGLISH
Connecting Devices
After the DWR-926 has been successfully installed, the router can
be connected to the end device via the following connection
methods:
Over Ethernet
The Ethernet port can be connected to an end device. Use a
standard Category 5/5e/6 RJ-45 Ethernet cable to connect the
end device to the router. The port will auto-negotiate to the
highest possible port speed based on the connected device.
Note that the DWR-926 supports a maximum transfer speed of
300 Mbps over Ethernet.
Over Wi-Fi
You can connect to the router using the SSID and security
settings listed on the bottom of the router. If your Wi-Fi has
previously been congured, use those settings instead. The
router supports up to 802.11n/ac speeds on the 2.4GHz/5GHz
network. Maximum tranfer speeds are dependent on network
conditions.
DWR-926
10
ENGLISH
Management Options
Before You Begin
The D-Link router can be managed by using either the Web
User Interface (Web UI) or Telnet management interfaces.
If you wish to manage a single D-Link router, the Web UI
may be the best option. Each router must be assigned
its own IP address, which is used for communication
with the management PC. Please refer to the following
installation instructions to get started with the Web UI.
Web User Interface
Once the router has been successfully installed, you can begin
conguration, monitor the LED panel, and display graphical
statistics using a web browser. Supported browsers include:
Microsoft®Internet Explorer , Firefox, Chrome, and Safari.
You need the following equipment to access the Web UI of
your device:
• A PC with a RJ-45 Ethernet port
• A standard Ethernet cable
1. Connect the Ethernet cable to a LAN port on the router and
to the Ethernet port on the PC.
2. Congure the PC’s IP address to be in the same network
segment as the router. The router’s default IP address is
192.168.0.1, with subnet mask 255.255.255.0.
Tabla de contenidos
Otros manuales de Enrutador de red de D-Link
D-Link
D-Link DES-3550 Manual de usuario
D-Link
D-Link DES-1005D Manual de usuario
D-Link
D-Link DSL-124 Manual de usuario
D-Link
D-Link DES-1008D Manual de usuario
D-Link
D-Link DIR-850L Manual de usuario
D-Link
D-Link DIR-827 Manual de usuario
D-Link
D-Link xStack DGS-3426 Manual de usuario
D-Link
D-Link Xtreme N DIR-614 Manual de usuario
D-Link
D-Link AC750 Manual de usuario
D-Link
D-Link Xstack DGS-3300 Series Manual de usuario
D-Link
D-Link N600 Manual de usuario
D-Link
D-Link DIR-1950 Manual de usuario
D-Link
D-Link AirPlus XtremeG Ethernet-to-Wireless Bridge... Manual de usuario
D-Link
D-Link DSL-2741B Manual de usuario
D-Link
D-Link DGS-1008P Manual de usuario
D-Link
D-Link DFL-210 - NetDefend - Security Appliance Manual de usuario
D-Link
D-Link Express Ethernetwork DI-704P Manual de usuario
D-Link
D-Link DSL-4320L Manual de usuario
D-Link
D-Link DSL-2730U Manual de usuario
D-Link
D-Link DSL-504T Manual de usuario
Manuales populares de Enrutador de red de otras marcas
NETGEAR
NETGEAR FS526T - Switch Manual de usuario
Korenix
Korenix JetNet 5710G Series Manual de usuario
Automated Logic
Automated Logic ZN551 Manual del propietario
Cisco
Cisco ASR 1000 Series Manual del operador
EnGenius
EnGenius ESR-9710 Manual de usuario
Cisco
Cisco 805 Series Instrucciones de funcionamiento y seguridad