Comtrol ROCKETLINX ES7206-XT Manual de usuario

QUICK INSTALLATION GUIDE

2000584 Rev E | Release Date- March 2014

ROCKETLINX ES7206-XT

Industrial PoE Plus Switch

INTRODUCTION

The RocketLinx ES7206-XT is an industrial 6-port Gigabit 802.3af/at PoE

Voltage Boost Switch.

SeetheComtrolwebsiteforproductspecicaons.

INSTALLATION OVERVIEW

YoucanusethefollowinginformaontoinstalltheES7206-XT.TheES7206-XT

istobeconnectedtoPoEnetworkswithoutroungtooutsidetheplant.

Wiring the Power Inputs

TheES7206-XTprovidesredundantpower,reversepolarityprotecon,over-

currentproteconandacceptsaposiveornegavepowersourcebutPWR1

andPWR2mustbeappliedwithpowersourcesofthesamepolarity.

Theterminalblockaccepts12-24AWGwire.UseaULlistedpowersupply

withtherequiredoutputvoltageof12-36VDCtodeliverIEEE802.3atPoEPlus

onallPoEports(Ports1-4).Thepowersupplymustberatedasfollows:

• 802.3af-96Was(Minimum)

• 802.3at-168Was(Minimum)

Power Supply AC Power Input

12-36VDC/7A

(UL Listed)

V+

V-

Wiring Posive Power Supplies

Power Supply AC Power Input

12-24AWG

V+

V-

DC Power Input

12-36VDC

DC Power Input 12-36VDC/7A

(UL Listed)

Relay

PWR1PWR2

Powershouldbedisconnectedfromthepowersupplybeforeconnecngitto

the switch. Otherwise, your screwdriver blade can inadvertently short your

terminalconneconstothegroundedenclosure.

1. InserttheposiveandnegavewiresintoPWR+andPWR-contacts

(PWR1andPWR2).Youcanconnectasinglepowersupplyortwopower

supplies depending on your requirements.

Ifbothpowerinputsareconnected,theES7206-XTwillbepowered

fromthehighestconnectedvoltage.Theunitcanbeconguredto

signalanalarmforlossofpowerineitherPWR1orPWR2.

2. Tighten the wire-clamp screws to prevent the wires from being

loosened.

Note: When the ES7206-XT is in operaon, cauon must be taken to not touch the hot

surface of the product enclosure.

Electrical Specicaons Value

PowerInput 12-36VDC

PowerConsumpon

(withoutPDloading) • 840mA@12VDC

• 420mA@24VDC

• 280mA@36VDC

PowerConsumpon

(withPDloading) • IEEE802.3af:6.25@12VDC

• IEEE802.3af:4A@24VDC

• IEEE802.3at:7A@24VDC

• IEEE802.3af:2.67A@36VDC

• IEEE802.3at:4.67A@36VDC

MaximumOutput/PowerPoEPort • 15W(IEEE802.3af)

• 30W(IEEE802.3at)

(table connued on next page)

Electrical Specicaons Value

Total PoE Power

Budget VIN=12VDC • 60W@-40°to70°C

• 55W@70°to75°C

VIN=24VDC • 110W@-40°to65°C

• 100W@65°to75°C

VIN=36VDC • 110W@-40°to65°C

• 100W@65°to75°C

Operang Temperature -40°to75°C

Storage Temperature -40°to85°C

Note: Exceeding the recommended power and operang temperatures may

result in failures or damage.

Wiring the Alarm Relay Output

Thealarmrelayoutputordigitaloutput(DO)contactsareontheterminal

block connector. The alarm relay output contacts are normally open. The

alarmrelayoutputcontactsclosewhenthealarmisenabledwiththeDIP

switches and there is a port link failure or PoE failure on a port.

Therelaycontactsupportsupto0.5Aat24VDC.Donotapplyvoltageand

currenthigherthanthespecicaons.

Thealarmrelayoutputiscontrolledbythepre-denedrules.Toacvatethe

alarmrelayoutputfuncon,refertothefollowingdrawing.

Earth Ground

Alarm Relay Output

DIP Switch

Alarm Control

Alarm

Relay

PWR2 PWR1

Power

Source

Buzzer/

PLC

Input

12 - 24

AWG Wire

24VDC/0.5A (Max)

Seng the DIP Switch

TheES7206-XThasan8-pinDIPswitchlocatedontheboompanelto

congurethePortLinkAlarmfortheEthernetports.Thefollowingtable

showstheDIPswitchnumbermappingtothecorrespondingopons.

Port

PWR

Alm

SFP

100

DIP1 DIP2 DIP3 DIP4 DIP5 DIP6 DIP7 DIP8

ThistableshowstherelaonshipbetweentheDIPswitchnumber,posion,

andfuncon.

Switch Posion Funcon

1-6 ON Enables port failure alarm for corresponding port

OFF(Default) Disablesportfailurealarmforcorrespondingport

7ON Enables power event alarm

OFF(Default) Disablespowereventalarm

8ON EnablesSFPportfor100BASE-FX

OFF(Default) Supports Gigabit SFP in SFP port

Note: Aer connecng the SFP or changing the speed through DIP 8, cycle the

power to acvate the SFP.

Grounding the ES7206-XT

Wiretheearthgroundtoensurethesystemisnotdamagedbynoiseorany

electricalshock,werecommendthatyoumakeadirectconneconbetween

the ES7206-XT and earth ground.

Usingascrewdriver,loosentheearthgroundscrewontheboomof

theES7206-XTandthenghtenthescrewaertheearthgroundwireis

connected.

Mounng the ES7206-XT

TheDINrailclipisaachedtotheES7206-XT.

1. InserttheupperendofDINrailclipintothebackofDINrailtrackfrom

its upper side.

2. LightlypushtheboomofDINrailclipintothetrack.

3. VerifythattheDINrailclipisghtlyaachedonthetrack.

Note: When the ES7206-XT is in operaon, cauon must be taken to not

touch the hot surface of the product enclosure.

Connecng the RJ45 Ethernet Ports

Connect one end of an Ethernet cable into the Ethernet port of the

ES7206-XTandtheotherendtotheaachednetworkingdevice:

• Ports1-4areGigabitPoEportsthatsupportIEEE802.3af/802.3at(PoE+)

• Port5isaGigabit(10/100/1000BASE-TX)port

• Port6isaGigabitSFPport,whichisdiscussedinthenextsecon

TheportssupportGigabithalf/full-duplex.AllRJ45portsauto-detectthe

signalfromconnecteddevicestonegoatethelinkspeedandduplexmode.

AutoMDI/MDIXallowsuserstoconnectanotherswitch,hub,orworkstaon

without changing straight-through or crossover cables.

Link/ActLEDsarelittoindicatetracandlinkstatus,seetheLEDssubsecon

formoreinformaon.

1000BASE-TX

Alwaysmakesurethatthecablesbetweentheswitchesandaacheddevices

(forexample,switch,hub,orworkstaon)arelessthan100meters(328

feet).YoushoulduseCategory5cableorhigher.

Connecng the SFP Port

You can connect an SFP transceiver to Port 6. Comtrol recommends using

Comtrol-approved SFP transceivers. Cross-connect the transmit channel at

each end to the receive channel at the opposite end as illustrated in the

gure.

MakesurethatyouuseanSFPbertransceivercompliantwithUL

cercaonandEN60825Class1.

LED INDICATORS

LED Status Descripon

PWR1/2 Green The terminal block is receiving power

O The terminal block is not receiving power

(table connued on next page)

A B

LED Status Descripon

Alm Red Oneofthefollowinghasoccurred:

• Port link failure has occurred

• PowerhasbeenremovedfromPWR1orPWR2

• Port6SFPis100BASE-FXandhaslost

connecon/link

O Nofailurehasbeenfound

PoE 1-4 Yellow TheportisprovidingPoEpowertothePD

O NoPDisaached

P 1-5

LNK/ACT

Green Anetworkdeviceisaached

Blinks ThereisavalidEthernettransmit/receiveacvity

to/from the connected network device

O Theportlinkisnotacve

LNK

Green Anetworkdeviceisaached

Blinks ThereisavalidEthernettransmit/receiveacvity

to/from the connected network device.

O Theportlinkisnotacve

COMTROL CUSTOMER SERVICE

You can use one of the following methods to contact Comtrol.

Contact Method Web Address or Phone Number

Support hp://www.comtrol.com/support

Downloads p://p.comtrol.com/html/default.htm

Website hp://www.comtrol.com

Phone +1763.957.6000

Tabla de contenidos

Otros manuales de Cambiar de Comtrol

Comtrol

Comtrol RocketLinx ES8108 Manual de usuario

Comtrol

Comtrol ROCKET LINX ES7506 Manual de usuario

Comtrol

Comtrol ROCKETLINX ES7110-VB Manual de usuario

Comtrol

Comtrol RocketPort Manual de lista de piezas

Comtrol

Comtrol ROCKETLINX ES8508 Manual de usuario

Comtrol

Comtrol RocketLinx ES7528 Manual de usuario

Comtrol

Comtrol ROCKETLINX ACS7106 Manual de usuario

Comtrol

Comtrol RocketPort Serial Hub Si Manual del operador

Comtrol

Comtrol RocketLinx ES7510 Manual de usuario

Comtrol

Comtrol Rocket linx ES8508 Manual de usuario

Comtrol

Comtrol RocketLinx ES8520-XT Manual de usuario

Comtrol

Comtrol Rocketlinx ES8108-GigE Manual de usuario

Comtrol

Comtrol RocketLinx ES8108 Manual de usuario

Comtrol

Comtrol ROCKETLINX ES7510-XT Manual de usuario

Comtrol

Comtrol ROCKET LINX ES7506 Manual de usuario

Comtrol

Comtrol RocketLinx MP1204-XT Manual de usuario

Comtrol

Comtrol RocketLinx ES8108 Manual de usuario

Comtrol

Comtrol RocketPort Manual del operador

Comtrol

Comtrol ROCKETLINX ES8509-XT Manual de usuario

Comtrol

Comtrol ROCKETLINX ES8509-XT Manual de usuario

Comtrol

Comtrol Satyrn U041-RE-M12 Manual de usuario

Comtrol

Comtrol ROCKETLINX ES8510 Manual de usuario

Comtrol

Comtrol DeviceMaster DM-2000 Series Manual del operador

Comtrol

Comtrol RocketLinx ES7506 Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario