Comica BoomX-U Manual de usuario
User Manual
Broadcasting-Level Multi-functional Mini UHF Wireless Microphone
Technology Parameters
Transmitter (TX)
Channels
Group A Wireless Frequency
Group B Wireless Frequency
Transmitting Power
48
568.125MHz ~ 579.875MHz
580.125MHz ~ 591.875MHz
15dBm
Receiver (RX)
Channels
Group A Wireless Frequency
Group B Wireless Frequency
48
568.125MHz ~ 579.875MHz
580.125MHz ~ 591.875MHz
Foreword
Main Features
Thanks for purchasing COMICA BoomX-U Broadcasting-Level Multi-functional Mini UHF Wireless Microphone.
To ensure bring you a good using experience, please read this manual book carefully before using and correctly install and
operate.
. Mini and Portable, Broadcast Level
. Dual-Channel UHF Wireless Microphone
. Internal and External Mic Two Input Modes
. Working Distance is Up to 120m
. Multiple Channels Used for Several Devices
Working Together
. Auto-scanning and Quick IR Pair
. LCF, M/S Switch, 16-Levels Adjusted Gain Control, Muting
Functions
. Real-time Visual Power and Audio Dynamic Monitor
. Special Anti-loose Design for External Lavalier Mic
. Colorful TFT Display, High Resolution
. Support Screen Flip
. Designed with Multi-functional Belt Clip and Compact
Notice
Please make sure the IR sensor are closely aligned when pairing
Don't block the antenna position to avoid any poor signal generated
Please attention that it can not realize STEREO function when in single channel mode
It is recommended to adjust the antenna of transmitter and receiver to appropriate angle for stable transmission and long
working distance
It is recommended to keep a distance more than one meter between the two transmitters when using IR sync function, or it
is easy to cause mismatching
This product belongs to high-precision instruments, please avoid falling, collision or pounding
Do not use this equipment in the vicinity of heat source or interference source, such as radiator, oven, WIFI AP, intercom or
next to the other wireless devices
If the pick-up distance is close or when used outdoors, please put on the wind mu to prevent sound burst or reduce wind
noise
Do not use the equipment in rain or in a damp environment to avoid short-circuit danger
Please keep the product in a dry environment 1
Packing List
U1 = TX + RX U2 = TX + TX + RX
Receiver (RX)Transmitter(TX)
Purchase Options:
Main Parts:
2
3.5mm Lavalier Mic
Wind Mu
3.5mm TRS-TRRS Audio Cable
3.5mm TRS-TRS Audio Cable
3.5mm-XLR Audio Output Cable
USB A-USB C Charging Cable
Carry Case
User Manual
Warranty Card
Accessories:
The accessories of each combination include :
①+②+③+④+⑤+⑥+⑦+⑧+⑨
U1= ①x2+②x2+③+④+⑤+⑥+⑦+⑧+⑨
U2=
1
2
3
4
5
6
7
8
9
7 8 96543
21
UHF
3
Components and Instruction
Transmitter (TX):
1. Power / Low Cut Filter Button
2. Muting Button
3. Power / Low Cut Filter Indicator Light
4. Audio Status Indicator Light
5. External Mic Locking Buckle
6. 3.5mm TRS Port of External Mic
7. Internal Mic
8. IR Sensor
9. USB-C Charging Port
10. Reset Hole
11. Belt Clip
12. Antenna
5
111
2
3
4
6
7
8
9
12
10
4
Receiver (RX)
3
13
12
14
5
4
1
2
6
7
8
9
10
11
1. Menu Function Button +
2. Function Setting Button
3. Menu Function Button -
4. Group A Working Status Indicator
5. 3.5mm TRS/TRRS Monitoring Port
6. IR Sensor
7. 3.5mm TRS Audio Output Port
8. Group B Working Status Indicator
9. Reset Hole
10. USB-C Charging Port
11. Power Button
12. Belt Clip
13. Group A Antenna
14. Group B Antenna
5
Installation
Transmitter (TX)
1.Use internal microphone :
Adjust the antenna angle; Install the transmitter on the collar through the belt clip so that the internal microphone
points in the direction of the sound source
Internal Mic
Belt Clip
Rotate 180 degrees for the best signal
For better concealment during use, it is recommended that the belt clip be fixed and used outwards
6
2.Use external microphone:
Insert the 3.5mm TRS microphone input cable into the transmitter's 3.5mm TRS external microphone port and
tighten it, then clip the transmitter to the belt through the belt clip and clip the lavalier microphone to your collar
When using an external microphone, the internal microphone is automatically turned o
7
1. Work with Camera:
Adjust the antenna angle; Fix the receiver through the belt clip to the camera's hot shoe mount, then connect the
receiver with camera through the 3.5mm TRS-TRS audio cable; Insert the headphone into the monitoring port for
monitoring
Receiver (RX)
3.5mm TRS-TRS Audio Cable
Rotate 90 degrees for the best signal
8
Tabla de contenidos
Otros manuales de Micrófono de Comica
Comica
Comica CVM-VS50 Manual de usuario
Comica
Comica STA-U2 Manual de usuario
Comica
Comica CVM-WM200 Manual de usuario
Comica
Comica CVM-VM30 Manual de usuario
Comica
Comica CVM-VM10-K1 Manual de usuario
Comica
Comica VDLive 10 USB Manual de usuario
Comica
Comica SIG.LAV V05 Manual de usuario
Comica
Comica Traxshot Manual de usuario
Comica
Comica STA-X2D Manual de usuario
Comica
Comica VS09 MI Manual de usuario
Comica
Comica CVM-WM100 PLUS Manual de usuario
Comica
Comica CVM-WM300C Manual de usuario
Comica
Comica SIG.LAV V05 MI Manual de usuario
Comica
Comica Vimo S-UC Manual de usuario
Comica
Comica BoomX-U QUA Manual de usuario
Comica
Comica CVM-WM300 Manual de usuario
Comica
Comica CVM-WM300A Manual de usuario
Comica
Comica SIG.LAV V05 MI Manual de usuario
Comica
Comica CVM-WM200 Manual de usuario
Comica
Comica CVM-WS60 COMBO Manual de usuario
