Combi-Camp Country Manual de usuario
Instruction
Country
www.combicamp.com
Valley
Instruction 3
Before you set out 4
Hitching the COMBI-CAMP 5
Opening the trailer and erecting the tent 6
Final adjustment 7
Integrated sun canopy / awning 8
Integrated sun canopy / awning 9
Sun canopy as kitchen canopy 10
Accessories to the trailer tent 11
Kitchen 12-13
Maintenance 14-15
Technical data 16-17
Contents UK
2
We are delighted that you have chosen COMBI-CAMP and we wish
you many happy holidays in the years to come.
This booklet has been created to help you get this optimum from
your COMBI-CAMP trailer tent, and we advise you to read it carefully.
Get to know your COMBI-CAMP at home - erect the trailer tent a few
times, so that you have good knowledge of what to do before you
embark on the first trip.
ON YOU NEW COMBI-CAMP
CONGRATULATIONS
Instruction UK
3
4
BEFORE YOU SET OUT
Packing the COMBI-CAMP
• Inside the closed trailer there
is room for approx. 34 cubic feet
(1 cubic metre) worth of luggage
space. Furthermore, there is
luggage space on the roof rack
and in the cargo carrier fitted
under the bedroom floor. Please
note that packing must be carried
out in a way that ensures the
balance of the trailer.
• Heavy items should be placed on
the axle line even if only the roof
rack is used. The weight at the
hitch should be between 44-110
pounds (20 to 70 kg).
• Do not place lug-
gage too close to
the outer walls of
the trailer - there must be 8 inches
of space left to accommodate the
tent and frames. This will ensure
proper closure of the trailer lid.
• The approved gross weight
of all COMBI-CAMP trailer is 750
kg.
PLEASE NOTE!
Unzip the tent door and close the
vent flap when folding down the
trailer tent.
NEVER OVERLOAD THE TRAILER
Check points:
• Close and securely lock all locks on
trailer and kitchen
• Check the proper function of all road
lights before you start your trip
• It is important to tighten wheel nuts
after driving the first 200 km.
• If your COMBI-CAMP is equipped
with brakes, they must be adjusted
after driving the first 200 km.
• Check that your hitch is correctly
attached to the car.
• Check that the jockey wheel is
tightened and in it's upper position.
• Check your trailer speed limits
especially in foreign
countries and fit
your national
identification
plate.
Light
• Always remember the trailer's,
electrial plug must be inserted
to the vehicle. See diagram
page 18.
• The handle is, in the upper position
i.e. open, then the hitch is lowered
by using the jockey wheel on to the
vehicles tow bar.
• When the hitch is in the correct
position, the green indicator on the
front of the hitch will be visible and
the handle will automatically move
to the normal position.
• Remember to attach the safety
cable, which activates the brakes
in case the trailer becomes detached
from the tow bar.
HITCHING THE COMBI-CAMP
Before you set out UK
5
6
OPENING THE TRAILER AND
ERECTING THE TENT
• Opening the trailer tent should be
carried out on a fairly level site.
• Remember it is not recommenda-
ble to place the trailer under trees.
Objects can fall down and eventually
damage or discolour the tent canvas.
• When the COMBI-CAMP is unhitched
and placed on the desired spot,
using the front support leg or jockey
wheel if fitted to level the trailer
tent.
• Wind down the rear jack legs until
trailer is level, it is recommended
to have a jack plate to avoid the leg
going into the ground, then unhook
the roof rack.
• Lift the roof rack over the trailer all
the way.
• Now open the top of the trailer, pull
it towards and past the position of the
roof rack and further until it reaches the
ground.
Never use the roof rack as a lever. Walk
into the tent and push up the two
connect poles on the centre trailer frame
until the tent is fully erected and tighten
the handscrew.
• The tent canvas is now erected. Adjust
the internal frame adjusters as shown.
Adjust the jockey wheel in order to level
the tent floor so that it is supported by
the roof rack which is now situated below
the floor. If required the two rear jack
legs can also be adjusted.
• Pull the rain protection skirt out
over the trailer and adjust the
nylon skirt over the floor edge.
• All windows are complete with
ventilation panels fitted with mos-
quito nets. Should you wish ven-
tilation, role the canvas part to
side and tie. Should it rain, the
panel can be opened just a little
with use of a guy rope into the
"D" ring located at the bottom of
the panel.
• The zippers on both ends of the
hinge should always be closed by
approx 15 cm.
• Finally the outside vent can be
opened. Zip up and place the
fibreglass section into the sleeve
and bend the section and insert
into the pocket in the other side.
FINAL ADJUSTMENT
Opening and final UK
Extra checkpoint when
setting up the main tent
• The bands with buckles on
all corners of the main tent
should be tight to avoid
leaking on these spots.
Has the buckle come loose,
make sure you pull the
band until the roof is flat
and then close the buckle
again.
7
8
• The height is adjusted on the two
legs. Adjust the integrated frames
and lock the adjuster.
• The side can now be pegged or
rolled back to the trailer.
IMPORTANT: make sure the
elastic flap is covering the
zipper.
Erection of integrated,
sun canopy/awning
The frame system is shown in fig. 6
• The body canvas is lowered by use
of two thumb screws, so that all
force is reduced from the tent
canvas and the integrated frames
can move freely. The canvas is
now zipped on to the COMBI-
CAMP.
• The sun canopy is put on top of
the integrated frames, whilst they
are pulled out. Both the frames 25
mm and 22 mm are pulled out,
such as the little pressure spring is
engaged into the 25 mm frame
and this is pulled out 3/4 way.
• Hereafter the front section of the
frame is attached (fig. 6). Now the
frame is adjusted so that the
canvas is nice and tight.
Fig. 6
INTEGRATED SUN
CANOPY/AWNING
Sun canopy / awning
• The small elastic can
easily be attached to
the awning "D" rings.
• The draught skirt is
fitted below the
kitchen.
• When closing the trailer down,
to save time you may leave the
sun canopy attached and stored
on top of the trailer roof.
UK
INTEGRATED SUN CANOPY/AWNING
Important - when closing the integrated
frames they must be pushed all the way
back.
• To adjust the backrest/foot
of the lits jumeaux in the
Country, you can lift and fix
it in stages. To return to flat
position, first move it fully
towards you to unlock it.
9
10
Sun canopy as kitchen canopy
• If you are having a one night stop, for
ease you can move the integrated
frames halfway out and fold the rest
of the roof below the canopy roof.
• When the sun canopy is still on top
of the trailer, pull out the 22 mm
frame approx. 10 cm (4") until the
pressure spring becomes visible.
• Hereafter pull out the 25mm frame
approx. 1m (3'4").
• The sun canopy is pulled forward and
the frame is inserted into the small
grey PVC pockets.
SUN CANOPY AS
KITCHEN CANOPY
• Please note that the canopy must be on top
of all frames.
• The frame's adjusters are tightened and the
loose hanging sun canopy is tightened to the
trailer body canvas by using the ribbons.
• The sides can either be pegged or attached
to the body canvas.
Otros manuales para Country
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Carpa de Combi-Camp
