Cisco NCS 1004 Manual de instalación

Command Reference for Cisco NCS 1004

First Published: 2019-08-30

Last Modified: 2020-04-14

Americas Headquarters

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

http://www.cisco.com

Tel: 408 526-4000

800 553-NETS (6387)

Fax: 408 527-0883

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS,

INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND,

EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH

THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY,

CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.

The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB's public domain version of

NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS" WITH ALL FAULTS.

CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF

MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.

IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT

LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS

HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network

topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional

and coincidental.

All printed copies and duplicate soft copies of this document are considered uncontrolled. See the current online version for the latest version.

Cisco has more than 200 offices worldwide. Addresses and phone numbers are listed on the Cisco website at www.cisco.com/go/offices.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL:

https://www.cisco.com/c/en/us/about/legal/trademarks.html. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a

partnership relationship between Cisco and any other company. (1721R)

CONTENTS

Commands 1

CHAPTER 1

Reference 3

aaa authentication login 4

aaa authorization 5

active 6

address 7

cipher-suite 8

controller coherentDSP 9

controller HundredGigECtrlr 11

controller ODU4 13

controller optics 15

destination address 19

destination ipv4 unicast 20

destination transport-method 21

dh 22

dwdm-carrier 23

encryption 24

fault-profile 25

fault-profile apply 27

gmpls optical-uni 28

http-proxy 29

hw-module 30

ikev2 policy 33

ikev2 profile 34

ikev2 proposal 35

integrity 36

Command Reference for Cisco NCS 1004

iii

interface gcc0 37

interface gcc2 38

ipcc routed 39

ipv4 access-group 40

ipv6 access-group 41

keyring 42

license smart register 43

license smart renew 44

license smart deregister 45

lifetime 46

link-id ipv4 unicast 47

lmp 48

match address local 49

match identity remote address 50

neighbor interface-id unnumbered 51

neighbor link-id ipv4 unicast 52

neighbor 53

otnsec policy 54

path-option 55

peer 56

pm 57

pre-shared-key 62

prf 63

router-id ipv4 unicast 64

sak-rekey-interval 65

security-policy 66

session-id 67

show alarms 68

show controllers 70

show access-lists ipv4 80

show access-lists ipv6 82

show environment 84

show hw-module 87

show inventory 90

Command Reference for Cisco NCS 1004

Contents

show led 97

show platform 98

signalling refresh out-of-band interval 101

signalling refresh out-of-band missed 102

tunnel-id 103

tunnel-properties 104

Command Reference for Cisco NCS 1004

Contents

Command Reference for Cisco NCS 1004

Contents

Commands

•Reference, on page 3

•aaa authentication login, on page 4

•aaa authorization, on page 5

•active, on page 6

•address, on page 7

•cipher-suite, on page 8

•controller coherentDSP, on page 9

•controller HundredGigECtrlr, on page 11

•controller ODU4, on page 13

•controller optics, on page 15

•destination address, on page 19

•destination ipv4 unicast, on page 20

•destination transport-method, on page 21

•dh, on page 22

•dwdm-carrier, on page 23

•encryption, on page 24

•fault-profile, on page 25

•fault-profile apply, on page 27

•gmpls optical-uni, on page 28

•http-proxy, on page 29

•hw-module, on page 30

•ikev2 policy, on page 33

•ikev2 profile, on page 34

•ikev2 proposal, on page 35

•integrity, on page 36

•interface gcc0, on page 37

•interface gcc2, on page 38

•ipcc routed, on page 39

•ipv4 access-group, on page 40

•ipv6 access-group, on page 41

•keyring, on page 42

•license smart register, on page 43

•license smart renew , on page 44

Command Reference for Cisco NCS 1004

•license smart deregister, on page 45

•lifetime, on page 46

•link-id ipv4 unicast, on page 47

•lmp, on page 48

•match address local, on page 49

•match identity remote address, on page 50

•neighbor interface-id unnumbered, on page 51

•neighbor link-id ipv4 unicast, on page 52

•neighbor, on page 53

•otnsec policy, on page 54

•path-option, on page 55

•peer, on page 56

•pm, on page 57

•pre-shared-key, on page 62

•prf, on page 63

•router-id ipv4 unicast, on page 64

•sak-rekey-interval, on page 65

•security-policy, on page 66

•session-id, on page 67

•show alarms, on page 68

•show controllers, on page 70

•show access-lists ipv4, on page 80

•show access-lists ipv6, on page 82

•show environment, on page 84

•show hw-module, on page 87

•show inventory, on page 90

•show led, on page 97

•show platform, on page 98

•signalling refresh out-of-band interval, on page 101

•signalling refresh out-of-band missed, on page 102

•tunnel-id, on page 103

•tunnel-properties, on page 104

Command Reference for Cisco NCS 1004

Commands

Reference

This guide describes the commands supported in Cisco NCS 1004. For information on Cisco IOS XR

commands, see here.

Command Reference for Cisco NCS 1004

Commands

Reference

aaa authentication login

To configure authentication, authorization, and accounting (AAA) authentication at login, use the aaa

authentication login command in global configuration mode.

aaa authentication login { default | list-name }method-list

Syntax Description Sets authentication for login.login

Uses the listed authentication methods that follow this keyword as the default list of methods

for authentication.

default

Character string used to name the authentication method list.list-name

Method used to enable AAA system accounting. Method list types are entered in the preferred

sequence. The value is one of the following options:

•group tacacs+ — Specifies a method list that uses the list of all configured TACACS+

servers for authentication.

•group radius — Specifies a method list that uses the list of all configured RADIUS

servers for authentication.

•group named-group — Specifies a named subset of TACACS+ or RADIUS servers for

authentication.

•local — Specifies a local username or password database for authentication.

•line — Specifies a line password or user group for authentication.

method-list

Command Default No authentication is performed.

Command Modes Global configuration

Command History ModificationRelease

This command was introduced.R7.0.1

Example

The following example shows how to specify the default method list for authentication, and also

enable authentication.

configure

aaa authentication login default group tacacs+

exit

commit

Command Reference for Cisco NCS 1004

Commands

aaa authentication login

Otros manuales para NCS 1004

Tabla de contenidos

Otros manuales de Hardware de red de Cisco

Cisco

Cisco ASR 9000 Series Manual de usuario

Cisco

Cisco 1230AG - Aironet - Wireless Access Point Manual de usuario

Cisco

Cisco 5400 Manual de instrucciones

Cisco

Cisco Wide Area Virtualization Engine 274 Manual

Cisco

Cisco Linksys Business Series Network Storage System... Manual de usuario

Cisco

Cisco SCE 2000 4/8xFE Manual de usuario

Cisco

Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch... Manual de usuario

Cisco

Cisco NCS 1004 Manual de usuario

Cisco

Cisco ONS 15454 Hoja de instrucciones

Cisco

Cisco NSS2000 Series Manual de usuario

Cisco

Cisco WEC600N Manual de usuario

Cisco

Cisco Firepower 9300 Guía de mantenimiento y servicio

Cisco

Cisco WAE-674-K9 - Wide Area Application Engine... Manual

Cisco

Cisco Firepower 1010 Manual de usuario

Cisco

Cisco Versatile Interface Processor (VIP6-80)... Manual del operador

Cisco

Cisco Secure Firewall Management Center 1700 Manual de usuario

Cisco

Cisco NCS 1004 Manual de usuario

Cisco

Cisco Aironet 340 Series Cómo utilizar

Cisco

Cisco NCS 2006 Manual

Cisco

Cisco ON100 Network Agent Manual de usuario

Cisco

Cisco Aironet 340 Series Manual de usuario

Cisco

Cisco Nexus 93180LC-EX Manual de usuario

Cisco

Cisco 220 Series Smart Plus Manual de usuario

Cisco

Cisco ONS 15454 Manual de instrucciones

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario