Cisco SPA3000 Manual de usuario

Set Up the SPA3000

Document ID: 108740

Contents

Introduction

How do you initially set up an SPA3000?

Related Information

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business

products (formerly Linksys Business Series).

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Q. How do you initially set up an SPA3000?

A. In setting up the SPA3000, make sure you have a one touch tone analog phone, your

NodePhone account details, and access to a standard phone port. You should also have these

package contents:

Phone Adapter Unit♦ Ethernet Cable Standard Phone Cable♦ A 5 Volt Power Adapter♦

Note: This guide has been prepared with firmware 2.0.13, the current supported firmware

release for NodePhone. If you are using an earlier firmware, the web configuration screen

might not look the same as the images in this document. Cisco recommends upgrading your

SPA3000 to version 2.0.13, which is available from the Cisco Download Center ( registered

customers only) .

In order to set up the SPA3000, complete these steps:

Ensure the SPA3000 Power Supply is Connected Properly1. Connect the SPA30002.

Ensuring the SPA3000 Power Supply is Connected Properly

Make sure the power adapter is plugged to an available power outlet.1.

After the plug is connected to the power adapter, connect the SPA3000. For

instructions, complete the next steps.

2.

Connecting the SPA3000

Connect the phone cable to the wall jack with ADSL service, and then connect the

other end to the LINE port of the gateway. Then, connect the Ethernet cable from the

SPA3000 to one of the Ethernet ports (1,2,3 or 4 ) of the Linksys gateway.

1.

Connect the phone cable to the wall jack with ADSL service, then connect the other

end to the line port of the ADSL line filter.

2.

Connect the ADSL modem line to the ADSL port of the ADSL router, and the local

phone line should be connected to the LINE port of the SPA3000.

3.

Connect the phone to the PHONE port on the SPA3000.4.

The PSTN phone line goes from the Local phone port of the Line Filter to the Line

port on the SPA3000. The Phone is connected to the Phone port of the SPA3000. The

Ethernet cable is connected between the ADSL router and the SPA3000.

5.

Related Information

Technical Support & Documentation − Cisco Systems•

Contacts & Feedback | Help | Site Map

© 2013 − 2014 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of

Cisco Systems, Inc.

Updated: Dec 12, 2008 Document ID: 108740

Tabla de contenidos

Otros manuales de Puerta de Cisco

Cisco

Cisco Meraki Z3C Manual de usuario

Cisco

Cisco ATA 186 Manual del operador

Cisco

Cisco ASR 5000 Series Manual de instrucciones

Cisco

Cisco RF Gateway 1 Modules Manual de usuario

Cisco

Cisco DPC Manual de usuario

Cisco

Cisco 3825 - Voice Bundle Router Manual de usuario

Cisco

Cisco DPC2325 Manual de usuario

Cisco

Cisco SIEMENS HICOM 330E Instrucciones de instalación y funcionamiento

Cisco

Cisco Catalyst 8200 Series Manual de usuario

Cisco

Cisco IG21 Series Manual de instrucciones

Cisco

Cisco TES301 Manual de usuario

Cisco

Cisco Linksys WAG310G Manual de usuario

Cisco

Cisco EPC3928 DOCSIS Manual de usuario

Cisco

Cisco DPC3848 Manual de usuario

Cisco

Cisco IntraPort Carrier-8 Manual de servicio

Cisco

Cisco VG224 - Analog Phone Gateway Manual de usuario

Cisco

Cisco DPC3940 Manual de usuario

Cisco

Cisco 3545 PRI Manual de instalación y operación

Cisco

Cisco Linksys WAG310G Manual de usuario

Cisco

Cisco Linksys WAG310G Manual de usuario

Cisco

Cisco AS5850 Manual

Cisco

Cisco Firepower 1100 Manual de usuario

Cisco

Cisco SPA8000-G1 Manual de usuario

Cisco

Cisco IR510 Manual

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario