Cisco TelePresence SpeakerTrack 60 Manual de usuario
Cisco TelePresence
SpeakerTrack 60
INSTALLATION GUIDE
The SpeakerTrack 60 uses a unique dual-camera
technique to quickly view a close-up of the active
speaker in the meeting room.
78-100223-02E0 | OCTOBER 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Installation
We invite you to explore the Project Workplace guide to inspire you on room design and room
setup. Go to: www.cisco.com/go/projectworkplace
Main box contents
A. 1 × Cover plate
B. 1 × Microphone panel with four
biult-in microphones
C. 2 × Precision 60 Camera
D. 1 × Base unit, with connectors
1 × Accessories box
1 × Installation Guide
Accessories
E. 2 × Camera interface plate
F. 1 × Wall bracket
G. 1 × DC Power cable w/ barrel plug,
20 cm / 7.87 in
H. 1 × DC Power cable w/ barrel plug,
45 cm / 17.72 in
I. 1 × Ethernet cable, 20 cm / 7.87 in
J. 1 × Ethernet cable, 35 cm / 13.78 in
K. 1 × Power adapter and power cable
L. 1 × Gloves
M. 1 × Torx Key (T20)
N. 1 × Allen Key
O. 2 × Thumb nut, M4
P. 4 × Pan headed screw, M4 16 mm
Q. 2 × 1/4” UNC screw
R. 1 × Template for attaching the
wall bracket (not shown)
B
D
FE
G
I
H
J
C
A
K
L NM
O QP
WARNING: Use Ethernet cable only when connecting to the Ethernet port on the
camera. Do not connect a serial VISCA cable to the Ethernet port on the camera, as
this will cause severe damage to the camera.
Safety instructions
NOTE
• It is of great importance that the wall mount unit is safely installed, that the wall
is able to support the product and that the screws or mounting means used are
suitable for the wall and the weight of the product.
• This type of equipment is to be installed by the submitter’s/dealer’s qualied
installer. The installer is responsible for obtaining safety inspection of the
structural integrity of the installation by the local authority/inspection department.
• Note that the surface is hot when the camera is in operation.
Horizontal eld of view
The participants should be seated within the horizontal eld of view. Participants seated
outside the horizontal eld of view will not have optimal audio tracking.
Horizontal eld
of view 80°
Microphone range
The participants should be seated within the maximum microphone range. For optimal audio
tracking the SpeakerTrack 60 should be mounted at some distance from the side walls.
Maximum microphone range
900 cm / 354 in
Minimum distance to the side walls
120 cm / 47.25 in
Mounting height not above
183 cm / 72 in
SpeakerTrack 60 mounted above the monitor
Mounting height not below
107 cm / 42 in
SpeakerTrack 60 mounted below the monitor
Option 1: Mount the camera on the wall
The SpeakerTrack 60 can be mounted above or below the monitor. For large monitors (70” and
above), we recommend mounting the SpeakerTrack 60 below the monitor.
Select a mounting height for SpeakerTrack 60 that provides clear line of sight, to all four
edges of the microphone panel, from all appropriate positions in the meeting room.
NOTE: Obstacles placed in front of the microphone panel, or in the sight line of the
microphones, will cause severe loss in the speaker track performance.
Minimum distance to the ceiling
40 cm / 15.75 in
Option 2: Mount the camera in a recess
The recommendations for mounting the camera in a recess are the same as for mounting it
on the wall, with the following addition: If mounted in a recess, the sound from any participant
in the room must reach at least three of the four microphones on the microphone panel. To
achieve this, the recess should have slanted walls*.
SpeakerTrack 60 mounted in a recess above the monitor
• The bottom wall of the recess is slanted 17°
• The side walls of the recess are slanted 45°
• The maximum depth of the recess is 218 mm (8.56 in). If less the camera will protrude
from the wall. Follow local building regulations and accessibility requirements.
82 cm (32.3 in)
32 cm
(12.6 in)
SpeakerTrack 60 mounted in a recess below the monitor
82 cm (32.3 in)
32 cm
(12.6 in)
• The upper wall of the recess is slanted 17°
• The side walls of the recess are slanted 45°
• The maximum depth of the recess is 218 mm (8.56 in). If less the camera will protrude
from the wall. Follow local building regulations and accessibility requirements.
* CAD drawings with details and dimensions: http://www.cisco.com/go/telepresence/docs and
navigate to: Collaboration Endpoints > Collaboration Peripherals > TelePresence Peripherals >
TelePresence SpeakerTrack 60 > Technical References
Mount the wall bracket
NOTE: Read the mounting guidelines and safety instructions before you start mounting the
wall bracket (F).
Use the Template for attaching the wall bracket (R), found with the accessories, and follow
the instructions on the template when mounting the wall bracket.
78-100272-01A0 | FEBRUARY 2014.
Copyright © 2014 Cisco Systems, Inc. All rights reserved.
M6
78-100272-01A0 | FEBRUARY 2014.
Copyright © 2014 Cisco Systems, Inc. All rights reserved.
M6
Template for attaching wall bracket for SpeakerTrack 60
Gabarit de xation du support mural pour SpeakerTrack 60
Check that the unit is level.
Vériez que l’appareil est à niveau.
SpeakerTrack 60
rear panel
SpeakerTrack 60
panneau arrière
The monitor
center point
Template for drilling holes
(found overleaf)
Modèle pour les trous de forage
(qui se trouve au verso)
Wall bracket
Support mural
Find the center point of the
monitor and the top center point of
the SpeakerTrack 60 rear panel.
Localisez le centre du moniteur
et le centre supérieur du
SpeakerTrack 60.
Use the template on the other side of
this sheet when drilling holes for the
wall bracket. Screw dimension M6.
Utilisez le modèle au verso de cette
page pour le perçage des trous de la
xation murale. Vis dimension M6.
Select the type of attachment for
the wall bracket on the basis of the
type of material the wall is made of
(wood, concrete, gypsum).
Sélectionnez le type de xation du
support mural en fonction du type
de matériau du mur (bois, ciment,
gypse).
Template Page 1
Template Page 2
Mount the base unit
Place the microphone panel (B) on a clean and stable surface (for example a table) with the
microphone cables headed up and the textile headed down.
Remove the cover plate (A) from the base unit before this
operation. Hold the base unit (D) as illustrated and slide in
place. Make sure the guide-pins positions correctly.
Use the four pan headed screws (P) when fastening the base unit.
Use the Torx Key (M) and tighten the screws.
Use the supplied
gloves (L).
Mount the cables
Connect the cables to the connector panel on the base unit:
1. Find the Ethernet cables (I, J) and the power cables (G, H) in the accessories box.
Connect the short cables to the connectors marked R ( ) and the long cables to the
connectors marked L ( ). Lead them through the open slot to make them available for
camera mounting.
2. Connect the microphone cables coming from the microphone panel.
3. Find the power adapter and the power cable (K) in the accessories box. Connect the
power cable to the base unit.
4. Connect an Ethernet cable (not included) to the Ethernet port on the base unit. Connect
the other end directly to the codec. If you do not have any free Ethernet port on the
codec (typically if a Touch device is connected) you will need a network switch. Connect
the switch to the Ethernet port on the codec, and connect the Touch device and
SpeakerTrack 60 to the switch. We recommend using a Cisco switch.
1 2
3 4
Rear view
Connect the short Ethernet and
power cables to the right camera,
and the long Ethernet and power
cables to the left camera.
Connect the microphone
cables that comes from
the microphone panel.
Connect the
power cable.
Connect the Ethernet
cable (not included)
directly to the codec
(Eth2/Eth3).
Mount the interface plate to the cameras
Place the camera (C) on a stable surface as illustrated. Use the 1/4” UNC screw (Q) and
Allen Key (N) and mount the camera interface plate (E) to the camera.
Repeat these steps for the second camera (C).
Mount the assembly to the wall
Hold and lift the unit as illustrated. Carefully place the unit onto the wall bracket.
Check that the unit is level. If not,
you can adjust the unit sideways.
Otros manuales para TelePresence SpeakerTrack 60
3
Tabla de contenidos
Otros manuales de Sistema de conferencias de Cisco
Cisco
Cisco TelePresence CE9.13 Manual de usuario
Cisco
Cisco EX90 Manual de usuario
Cisco
Cisco Tandberg 1700 MXP Instrucciones de montaje
Cisco
Cisco MXP Series Manual de usuario
Cisco
Cisco TelePresence SX10 Manual de usuario
Cisco
Cisco TelePresence DX80 Manual de usuario
Cisco
Cisco Webex Room 70 Dual Manual de usuario
Cisco
Cisco 8865 Manual de usuario
Cisco
Cisco Aironet 1000 Series Manual de instalación y operación
Cisco
Cisco SX80 Manual de usuario
Cisco
Cisco MX200 G2 Manual de usuario
Cisco
Cisco SX80 Manual de usuario
Cisco
Cisco Webex Room Kit Plus Manual de usuario
Cisco
Cisco Telepresence MX200 Manual de servicio
Cisco
Cisco SX80 Manual de servicio
Cisco
Cisco TelePresence SX20 Manual de servicio
Cisco
Cisco 3545 MCU Manual de instalación y operación
Cisco
Cisco TelePresence System Codec C90 Manual de servicio
Cisco
Cisco TelePresence MXP Series Manual de servicio
Cisco
Cisco Spark Room 55 Manual de usuario
Manuales populares de Sistema de conferencias de otras marcas
Kramer
Kramer VIA GO Manual de usuario
AVT
AVT MAGIC AC1 Go Manual de usuario
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Manual de usuario
Sony
Sony PCS-I150 Manual de usuario
Middle Atlantic Products
Middle Atlantic Products VTC Series Manual de usuario
Prentke Romich Company
Prentke Romich Company Vanguard Plus Guía
