© 2016 Cine Gears INC. All Rights Reserved
Cautions
Warning
Electrical Considerations
This instructional user manual and all the related documents are subject to change at the sole
discretion of SFAIMO (Guangzhou SunFieldAimo Electron Technology Co., Ltd.). SFAIMO inc.
reserves the right to make changes and improvements to any of the products described
without prior notice. Under no circumstances shall SFAIMO be responsible for any loss of
income or any special, incidental, consequential, or indirect damages howsoever caused. For
up-to-date product information, visit https://www.ghosteye.com and navigate to the support
page.
Please read this user introduction manual to become familiar with the features of the Ghost-Eye
series products before operation. Failure to operate the product correctly can result in damage
to the product, or interference with other devices. This is a sophisticated product which must
be operated with caution and common sense. Failure to operate this product properly might
children without direct adult supervision. Do not use with incompatible components, or alter
this product in any way outside of the documents provided by Ghost-Eye. These safety
guidelines contain instructions for installation, operation, and maintenance. It is essential to
read and follow all of the instruction in the manual, and all the notices and warnings regarding
Ghost-Eye series products prior to assembly, setup, or use to prevent any damage or
interference.
1. Do not use this product in extreme heat, cold, dusty, or humid environments.
2. Prevent friction against hard objects.
3. Prevent jarring, such as from falling from high places, or from improper packaging during
transportation.
4. These products are not waterproof; prevent moisture from getting in, on, or around the
unit(s).
5. Do not dismantle, assemble, or otherwise alter the product(s) arbitrarily.
1. When this device is sharing a power supply or battery with other equipment, please make
sure all signal and power cables are well connected before turning on the Ghost-Eye unit
power.
2. When this device is sharing a power supply or battery with other equipment, please make
cables from the Ghost-Eye unit.
3. When this device is sharing a power supply or battery with other equipment, please check the
polarity of the power connectors of all equipment to ensure the inside conductor is positive.
If the polarity of the power connector is unknown, please check the user manual to make sure
the outer conductor of the SDI or HDMI connector is connected to the negative of the power
supply. Otherwise, the equipment will not be able to share the same power supply with the
Ghost-Eye unit.
