Cine Gears Ghost Eye 150M Guía del producto
WIRELESS HDMI/SDI
VIDEO TRANSMISSION SUITE
MANUAL BOOK
© 2017 Cine Gears INC. All Rights Reserved.
Trademarks
Ghost-Eye Wireless Video Transmission SystemsTM are trademarks of Cine Gears
Inc. Web Interface.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, Cine
Gears Inc. reserves the right to make changes to the products described in this docu-
ment without notice.
Cine Gears Inc. does not assume any liability that may occur due to the use or applica-
tion of the product(s) or circuit layout(s) described herein.
FCC Compliance Notice: Radio Frequency Notice
The device has met the FCC 15.247 requirement. In order to comply with the FCC RF
exposure requirement, the user must keep 20cm away from the antenna.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
© 2017 Cine Gears INC. All Rights Reserved.
Information to the user
The user’s manual or instruction manual for an intentional or unintentional radiator
shall caution the user that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equip-
ment. In cases where the manual is provided only in a form other than paper, such as
on a computer disk or over the Internet, the information required by this section may
be included in the manual in that alternative form, provided the user can reasonably be
expected to have the capability to access information in that form.
© 2017 Cine Gears INC. All Rights Reserved.
Contents
Cautions
Ghost Eye Wireless Video Transmission Systems
Ghost Eye 150M Kit
About the 150M
150M User Manual
Ghost Eye 300M Kit
About the 300M
300M User Manual
Ghost Eye 400M Kit
About the 400M
400M User Manual
Troubleshooting
Disclaimers
Customer Support
1
2
3
4
5
10
12
13
16
18
19
24
27
28
30
© 2017 Cine Gears INC. All Rights Reserved.
Cautions
© 2017 Cine Gears INC. All Rights Reserved. 2
Warning
Electrical Considerations
Please read this user introduction manual to become familiar with the features of the
Ghost-Eye series products before operation. Failure to operate the product correctly
can result in disturbing other film equipment on set. This product is not intended for
use by children without direct adult supervision. Do not use with incompatible compo-
nents, or alter this product in any way outside of the documents provided by Cinege-
ars. These safety guidelines contain instructions for installation, operation, and mainte-
nance. It is essential to read and follow all of the instructions in the manual, and all the
notices and warnings regarding Ghost Eye series products prior to assembly, set up,
or use to prevent any damage or interference.
1. Do not use this product in extreme heat, cold, humidity, or environments with dust.
2. Do not drop the unit or cause impact against hard surfaces.
3. These products are not waterproof: do not expose the units to moisture.
4. Do not dismantle, assemble, or otherwise alter the products.
1. When this device is sharing a power supply or battery with other equipment, please
ensure all signal and power cables are well connected before turning on the Ghost Eye
units' power.
2. When this device is sharing a power supply or battery with other equipment, please
ensure the power switch is turned off before connecting or disconnecting any signal or
power cables from the Ghost Eye units.
3. When this device is sharing a power supply or battery with other equipment, please
check the polarity of the power connectors of all equipment to ensure the inside con-
ductor is positive. If the polarity of wer connectors of all equipment to ensure the inside
conductor is positive. If the polarity of the power connector is unknown, please check
the user manual to make sure the outer conductor of the SDI or HDMI connector is
connected to the negative of the power supply. Otherwise, the quipment will not be
able to share the same power supply with the Ghost Eye unit.
Ghost Eye HD Wireless Video Transmission Systems
© 2017 Cine Gears INC. All Rights Reserved. 3
Here at Cinegears, we supply some of the best wireless HD video transmitters and
receivers available. During the development of the Ghost Eye line of products, we
subjected our prototypes to rigorous testing on set with professional film crews, and
took customer feedback and suggestions into serious consideration. After careful
review, the Ghost Eye products have integrated all of the in-demand wireless video
transmission features recommended by you, the user. The fruit of our efforts are
catalogued below in the form of our unique Ghost Eye Wireless Video Transmission
Kits, across the affordable price range spectrum.
Ghost Eye Wireless Video Transmission Kits each fit a different set of wireless HD
video transmission needs. The most powerful video transmitters and receivers will
satisfy even the most high-end professional film crew, and our lightweight models fit a
more versatile brand of film set. Ghost Eye transmission kits transmit and receive
10-bit 4:4:4 video, support both HD and SD, and can broadcast with under 1
millisecond of latency.
WIRELESS HDMI/SDI
VIDEO TRANSMISSION SUITE
GHOST EYE 150M V2.03 KIT
© 2017 Cine Gears INC. All Rights Reserved. 4
FULL HD
VIDEO
SDI &
HDMI
EU Environmental Protection
<1MS
LATENCY
PLUG &
PLAY
RUGGED
DESIGN
22
PAP
Waste electrical products shold not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Product Description
What is Included
About the 150M
© 2017 Cine Gears INC. All Rights Reserved. 5
The Ghost-Eye 150M Wireless HDMI/SDI Transmission Suite utilizes today's most
advanced wireless video transmission technology, broadcasting uncompressed 3G
SDI/HDMI HD video signals with zero delay. The suite includes one transmitter and
one receiver; where the transmitter provides a 3G SDI/HDMI HD input, the receiver
provides 3G SDI/HDMI output. The Ghost-Eye 150M suite has 2 external stick
antennas on the transmitter and 5 internal antennas inside the receiver. The
transmission suite functions in the 5.1-5.9GHz frequency band and can be flexibly
configured to licensed or ISM band frequencies around the globe. The side panel of
the transmitter and receiver units have a frequency selection knob that provides a
maximum of 4 workable frequency channels, and supports a maximum of 4 simultane-
ous receiver units per transmitter unit. The wireless suite can accommodate a wide
range of DC power input, including many kinds of camera battery models. The suite
can also sustain ~8kV ESD (HBM, contact discharge), the industry class metal case
and professional heatsink design guarantees robust reliability.
• Transmitter Unit x 1
• Receiver Unit x 1
• 5GHz Omni-Directional High Efficiency Antennas (SMA Female) x 2
• 15-27mm Mounting Bracket x 1
• 2-Pin Lemo Power Cable x 2
• User Manual x 1
• Waterproof Custom Fit Hard Case (310x190x93mm) x 1
About the 150M
© 2017 Cine Gears INC. All Rights Reserved. 6
Features
• Uses License-Free 5GHz ISM frequency band, maximum 4 frequency channels
manual selection, coexist with WIFI.
• Highest resolution 10bits color depth 4:4:4, 1080p 60FPS HDMI and
SD/HD/3G SDI input and output, HDMI SDI cross conversion is supported.
• Supports wireless 10 bit HD video with no compression and no delay up to 300m
(984ft).
• Uncompromised picture quality with very low latency, <1ms
• Supports point to point, and point to multi points network topology, multiple receiver is
supported with up to 4 receivers.
• Cross compatibility with all Ghost Eye models.
• Support professional audio formats include Dolby True HD, DTS-master, etc.
• AES-128 encryption with air interface HD video data stream.
• Time Code, tally is supported for broadcast or live event streaming production.
• Wide range power voltage input, compatible with most kinds of camera batteries,
optional Standard V-mount, Anton Bauer, or ¼ bolt Mount battery plate can be
installed.
• Sony F970 battery buckle, convenient for field battery install and replacement.
• All input and output ports have ±8 kV ESD protection level (HBM, contact discharge).
• Plug & Play - no software is required.
• Professional standard 2-pin LEMO power plugs.
• Each RX (receiver) paired to the unique TX(transmitter) in factory Industrial metal
case, stable and reliable.
• RX built-in directional antenna.
• Signal indicators for wireless power status, Video status and receiver RSSI.
• Water and mist proof, shock proof production case with form insert ready for traveling
• CE, FCC, RoHS certified product, safe to use worldwide.
About the 150M
© 2017 Cine Gears INC. All Rights Reserved. 7
Diagram - Transmitter
About the 150M
Diagram - Transmitter
1
1
2
3
4
5
6
7
8
9
Transmitter
1) 1/4-20 Screw Hole
2) RP-SMA male antenna connector
3) Video input indicator, 1 yellow LED
4) Power indicator, 1 green LED
5) Frequency selection knob,0-9
6) SD/HD/3G SDI input
7) HDMI Input
8) DC power switch
9) DC input, LEMO 4-pin B series connector
Video
Power
SDI in
HDMI in
DC in
0
1
2
4
6
7
8
9
5
3
© 2016 Cine Gears INC. All Rights Reserved
Transmitter
1) 1/4-20 Screw Hole
2) RP-SMA male antenna connector
3) Video input indicator, 1 yellow LED
4) Power indicator, 1 green LED
5) Frequency selection knob,1-4
6) SD/HD/3G SDI input
7) HDMI Input
8) DC power switch
9) DC input, LEMO 4-pin B series connector
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Transmisor de Cine Gears
Manuales populares de Transmisor de otras marcas
Dejero
Dejero EnGo 3x Manual de usuario
Rosemount
Rosemount 4600 Manual de usuario
Speaka Professional
Speaka Professional 2342740 Manual de usuario
trubomat
trubomat GAB 1000 Manual de usuario
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Manual de usuario
Rondish
Rondish UT-11 Manual de usuario
