Chiayo RRS-2000 Manual de usuario

RRS-2000

RCC-2000

eXtra Long Range (XLR) Wireless Microphone System

ISO 9001

ISO

140 0 1

REGIS T E R ED

ISO 14001

O H S A S

180 0 1

REGIS T E R ED

OHSAS 18001

GREEN PRODUCT

Operation manual

-1-

Thank you and congratulation for purchasing CHIAYO’s professional XLR (eXtra Long Range)

cellular concept multi-diversity reception wireless microphone system. Please read this manual

thoroughly to familiarize with the function of each part before use.

Basic Concept

This system consists of two main parts:

1. Remote Control Center RCC-2000

2. Remote Receiver Station RRS-2000

The Remote Control Center RCC-2000 is the nerve center of the whole system. It is capable of

controlling up to 4 units of Remote Receiver Station RRS-2000, delivering power supply and

receiving / monitoring signal of the individual Remote Receiver via Cat 5e cable.

Each Remote Receiver Station RRS-2000 has an antenna divider plus power distribution and is

capable of holding 2 diversity receiver modules RR-2000M (CH A and CH B). An optional

outdoor waterproof mounting kit PRR-2000 is available for outdoor installation.

Various Installation Scenarios:

Parts and functions of RCC-2000

RCC-2000 Front Panel

12 3 45

1. Power switch.

2. CH A CH B RF signal indicator of the 2 remote receivers.

3. CH A CH B AF signal indicator of the 2 remote receivers.

4. LCD display

5. UP button

6. DOWN button

7. MENU button

8. SET button

ISO 9001 / ISO 14001 / OHSAS 18001

-2-

RCC-2000 Rear Panel

234

1. DC-input

2. Remote Receiver Station RRS connector (RJ-45 jack for CAT.5e)

3. Remote Receiver Station RRS connector (RJ-45 jack for CAT.5e)

4. Remote Receiver Station RRS connector (RJ-45 jack for CAT.5e)

5. Remote Receiver Station RRS connector (RJ-45 jack for CAT.5e)

6. Channel B balanced audio output (XLR)

7. Channel B unbalanced audio output (Ø 6.3mm)

8. Channel A balanced audio output (XLR)

9. Channel A unbalanced audio output (Ø 6.3mm)

Various settings on the remote control center RCC-2000

Adjusting the volume

Press MENU button to go to , then hold SET to enter setting.

Choose A or B by SET button, and UP/DOWN buttons to adjust the volume. The setting will be

automatically saved after five seconds.

Warning: In order for this function to work correctly, the volume of the remote receiver module

side should be manually fixed at an appropriate level beforehand!

Changing ON/OFF status of the remote stations

Press MENU button to go to , then hold SET to enter setting.

Choose A or B by SET button, and UP/DOWN buttons to switch ON/OFF status of individual

Remote Station R1,R2,R3 and R4. The setting will be automatically saved after five seconds

and shown at the individual.

Warning: This function is only possible when the remote receiver module is switched ON

beforehand!.

-3-

Changing the frequency

Press MENU button to go to , then hold SET to enter setting.

Choose A or B by SET button, and UP/DOWN buttons to change the frequency. The setting will

be automatically saved after five seconds and will be sent to and shown at all the connected

RR-2000M's 2-digit 7-segment LED display. CH A will be 01 and CH B will be 00 (for 100)

The display value indicates the RF signal strength.

Pointer ””indicates which RRS-2000’s module the audio comes

from. The item marked with “x” is power off on either the module itself or RCC-2000.

ISO 9001 / ISO 14001 / OHSAS 18001

-4-

Parts and functions of Remote Receiver Station RRS-2000 and RR-2000M

Each Remote Receiver Station RRS-2000 can hold up to 2 pieces of RR-2000M receiver modules!

RRS-2000 Front Panel

CH A CH B

3 4 5 6 7

RR-2000M RR-2000M

1. 7-segment LED display

2. Channel UP button

3. Channel DOWN button (RCC has priority and overrides this button for CH #)

4. AF signal indicator

5. RF signal indicator

6. Module power/volume control

Channel Name setting on the remote receiver RR-2000M

Each Remote Station RRS-2000 can hold up to 2 units of RR-2000M receiver modules. A

channel (CH A) is assigned on the left and B channel (CH B) assigned on the right of this rack.

If this unit is connected to the Remote Station's RS1of the RCC-2000, module A must be set to

A1 and module B to B1. If another RRS-2000 is connected to the RS2 RJ-45 connector, its

module A must be set to A2 and module B set to B2. And so on.

To do the setting, first hold both UP and DOWN buttons till the LED flashes. Then press UP

button to select A or B and DOWN button to select 1/2/3/4.

Precisely, the two receivers of 1st Station should be named as A1 and B1, for 2nd station A2

and B2, for 3rd Station A3 and B3, for 4th Station A4 and B4. This should be done so in

accordance with the preset programming in the Remote Control Center RCC-2000.

(RCC has priority and overrides this button for CH #)

After name setting, the LED will return back to the allocated channel number programmed at

the RCC-2000.

-5-

RRS-2000 Rear Panel

123

1. Antenna B (TNC)

2. RJ-45 jack CAT.5e cable.

3. Antenna A (TNC)

Rack Mounting for RCC-2000

RCC-2000 has a half-19"-casing design. It can be cabinet-mounted with either one or two units.

Individual kits for mounting one or two units are available and please refer to following

assembly illustration.

ISO 9001 / ISO 14001 / OHSAS 18001

-6-

Outdoor weatherproof mounting of Remote Receiver Station RRS-2000

Remote Station can be mounted outdoor in a weatherproof casing PRR-2000 as follow:

-7-

UHF handheld microphones（SQ-SQ-6100/SQ-7100）

Parts and functions

1 2 3 4 5 6 91011

7 8

Microphone parts and functions

SQ-6100

SQ-7100

Cartridge

Battery weak/power LED

Power switch

LCD

Battery compartment

Bottom cap

Locking button

Audio mute switch

Setting button

Up button

Down button

Charging port

Battery installation

Insert or replace the batteries according to the correct polarity after opening the compartment.

Many batteries are known to have leakage problem of conductive and corrosive liquid. So

please remove the batteries if they are not to be used for a long period.

Other settings

1. Channel setting

Use UP or DOWN button to go to the CHANNEL/ FREQUENCY page.

The cursor will flash to allow changes to be made. Pressing UP or DOWN button will increase

or decrease the channel number. The corresponding frequency will change accordingly. When

a desired channel is selected, it will be automatically saved and stored in the memory.

2. Making changes to Battery selection

Use UP or DOWN button to go to the Battery selection page.

Press UP or DOWN button to move the cursor to either NiMH (rechargeable battery) or AKLN

(Alkaline battery) position.

When the desired battery has been selected, it will be automatically saved and stored in the

memory.

ISO 9001 / ISO 14001 / OHSAS 18001

-8-

Remark: NiMH battery must be selected when rechargeable battery is being used. Never

select AKLN (Alkaline) when microphone is intended for charging as Alkaline battery can’t be

charged. Wrong selection of battery will result in battery sensing electronics to display wrong

and misleading status information.

3. Making changes to Sensitivity Level

Use UP or DOWN button to go to the SENS SET page.

Press UP or DOWN button to increase or decrease the Sensitivity Level of the microphone.

The MAX level is 4 and the MIN level is 1.When a desired sensitivity level has been selected

for your application, it will be automatically saved and stored in the Memory.

Remark: When selecting Sensitivity level, please bear in mind that Level 1 is for close

proximity singing purposes whereas Level 4 is for use of microphone on tripod mount for

speech purposes. When Level 4 setting is used for close proximity singing, high SPL input will

result in undesirable distortion in the output.

After performing setting changes, you could turn the protective cover 180°in either direction to

block the buttons from being accidentally adjusted.

-9-

UHF belt-pack transmitters（SM-7100）

Parts and functions

234

15 15

Transmitter parts and functions

SM-7100

Antenna

Battery weak/audio mute indicator

Audio mute switch

(Lavalier microphone) Mini XLR connector

LCD

Charging port

Cover release button

Power switch

Gain control (GT, high impedance)

Gain control (MT, low impedance)

Setting button

Up button

Down button

Battery compartment

Charging contacts

Este manual sirve para los siguientes modelos

Otros manuales de Sistema de micrófono de Chiayo

Chiayo

Chiayo NDR-3100 Manual de usuario

Chiayo

Chiayo Live-100 series Manual de usuario

Chiayo

Chiayo SDR-6200 IrDA Manual de usuario

Chiayo

Chiayo SDR-5100 IrDA Manual de usuario

Chiayo

Chiayo SDR-5216 Manual de usuario

Chiayo

Chiayo IWM-202 Manual de usuario

Chiayo

Chiayo Q-818 Manual de usuario

Chiayo

Chiayo Artist Manual de usuario

Chiayo

Chiayo SDR-8200 Manual de usuario

Chiayo

Chiayo AIR-812 Manual de usuario

Chiayo

Chiayo COACH PRO Manual de usuario

Chiayo

Chiayo SDR-6200 IrDA Manual de usuario

Chiayo

Chiayo QR-4000N Manual de usuario

Chiayo

Chiayo IrDA-9000 Manual de usuario

Chiayo

Chiayo QR-4000 U Manual de usuario

Chiayo

Chiayo R-1001 Manual de usuario

Chiayo

Chiayo IWR-320 Manual de usuario

Chiayo

Chiayo DWR-5420 Manual de usuario

Chiayo

Chiayo UDR-500 Manual de usuario

Chiayo

Chiayo QR-2000N Manual de usuario

Chiayo

Chiayo IRX2 Manual de usuario

Chiayo

Chiayo R-1010 Manual de usuario

Chiayo

Chiayo DH2400 Manual de usuario

Chiayo

Chiayo IRX2 Manual de usuario

Manuales populares de Sistema de micrófono de otras marcas

Paso

Paso R824 Manual de usuario

Naxa

Naxa NAM-982 Manual de usuario

Motorola

Motorola PMNN4461 Manual de usuario

Xvive

Xvive U3 Manual de usuario

Tekon

Tekon DUOS Manual de usuario

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Manual de usuario

Devine

Devine WMD-IE Manual de usuario

LG LF-D7150 Manual de usuario

GE S768DAV Manual de usuario

LD U305 HBH 2 Manual de usuario

Chainway

Chainway URA8 Manual de usuario

ORATOR

ORATOR D860TD Manual de usuario

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Manual de usuario

Alpha Technologies

Alpha Technologies RBMS Manual de usuario

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Manual de usuario

Shure

Shure UA844 Manual de usuario

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manual de usuario

Pyle

Pyle PDWM5000 Manual de usuario