CDA CST62 Instrucciones de instalación y funcionamiento
CST62
Standard extractors
Installation, use and maintenance
Contents
Important
Declaration of Conformity & product disposal
Notes
Using your extractor
Care and maintenance
Removing and cleaning the grease filters
Changing a charcoal filter
Extractor lighting
Notes on operating modes
Mains electrical connection
Electrical information
Troubleshooting
Determining the position of your extractor
Fixings provided
Product dimensions
Installation steps
Energy Eciency Information (product fiche)
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
2|Instruction Manual
Important
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that
CDA reserves the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance or use
in a commercial environment.
This appliance is not designed to be used by people (including children)
with reduced physical, sensory or mental capacity, or who lack experience
or knowledge about it, unless they have had supervision or instructions on
how to use the appliance by someone who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Please enter the details on the appliance rating plate below for reference,
to assist CDA Customer Care in the event of a fault with your appliance
and to register your appliance warranty.
Appliance information
Appliance model
Serial number
Instruction Manual |3
This appliance has been designed and manufactured to comply with all
applicable UK and EU legislation,
Low voltage Directive, 2014/35/EU
Electromagnetic compatibility Directive, 2014/30/EU
ErP Directive, 2009/125/EC
RoHS Directive, 2011/65/EU
and has been marked with the following symbols.
EU Declarations of Conformity
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a special
local authority waste collection site, or to a dealer providing appliance
recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both
energy and resources. As a reminder of the need to dispose of
household appliances separately, the product is marked with a
crossed-out wheeled dustbin.
4|Instruction Manual
Under no circumstances should the extractor be connected to any gas
ventilation system, flue system or hot air ducting system.
Do not vent the extractor into an attic or loft space.
Only house the extractor in rooms with adequate ventilation. Remember
that the extractor is powerful and whatever air is extracted needs to be
replaced.
Do not tile the extractor in. It should be removable for service or
maintenance.
Do not use silicone sealant to secure the hood to the wall.
You must be able to isolate the extractor from the mains electrical
supply after installation.
This extractor has been designed to be used in a room with a volume
of less than 36m3.
Steam cleaners must not be used when cleaning this appliance.
The performance of your extractor will vary depending on several
factors. These include type of extraction, length of ducting, room
volume, ventilation available and cleanliness of the filters.
The extractor should be cleaned regularly to prevent build-up of
grease. We recommend cleaning both inside and outside the appliance
monthly. Failure to observe the requirements specified in this manual
can result in a fire risk.
■
■
■
■
■
■
■
■
■
■
Please note
Instruction Manual |5
Please enter the details on the appliance rating plate below for reference,
to assist CDA Customer Care in the event of a fault with your appliance
and to register your appliance warranty.
Control Panel
Using your extractor
For best performance, you should switch on the extractor 15 minutes
before starting to cook and leave it to run for approximately 15 minutes
after the end of cooking.
Press the “Lamp” indicator button.
To switch the extractor light on or o
Press the “O” button.
To switch the extractor o
IMPORTANT: THE LIGHTS ON YOUR EXTRACTOR ARE TO BE USED
ONLY FOR THE DURATION OF COOKING. THEY ARE NOT FOR USE
AS AMBIENT LIGHTING.
IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF
THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICI-
TY SUPPLY.
Press the relevant button for the “Low”, “Mid” or “Max” speed level as
required.
To switch on the extractor or to change the speed at any time
when the extractor is running
Fig 1.
6|Instruction Manual
You should use a non-abrasive cleaner. Any abrasive cleaner (including
Cif) will scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution
of water and mild detergent and drying to a shine with a clean cloth.
Ensure that the extractor is dry after cleaning.
Cleaning
To remove the grease filter,
pushing the button on the
handle and then pull down on
the filter at the front, as shown in
figure 2. Once released at the
front it can be pulled completely
away.
Removing the grease filter
The grease filter should be kept clean to minimise the risk of fire. At
least once a month you should remove and clean the grease filter with
hot soapy water. You can also wash the grease filter in a dishwasher,
ensuring that you place it in an upright position to prevent damage from
other items in the dishwasher. After rinsing and drying, replace the filter.
Please note that cleaning the grease filter(s) in a dishwasher may cause
the filters to discolour. This is normal and does not constitute a fault with
the appliance.
Cleaning the grease filter
Fig 2.
Instruction Manual |7
To ensure the best performance of your extractor, you should replace
the charcoal filter every three to six months, depending on the frequency
of use and the style of cooking. To attach new charcoal filters, first
remove the grease filter(s) as described on the previous page. Fix the
three charcoal filter holders with screws as shown in figure 3, turning it
clockwise until it locks in place.
Please note that charcoal filters are only required when the extractor is
being used in recirculation mode. Charcoal filters are not supplied and
are available to purchase from our Customer Care team.
Changing the charcoal filter
The lighting on your extractor uses energy ecient LED technology
and is designed to last the lifetime of the product. If the LED system
malfunctions, please contact CDA Customer Care.
The LED units must only be replaced by a
competent appliance service engineer.
Extractor lighting
LED LED
Fig 3.
8|Instruction Manual
Your extractor can be used in either of two modes - recirculation or
extraction. The choice often depends on the specific installation
requirements. Your installer will be able to advise which is best for you.
Operating modes
Fig 5.
Extraction mode
(ducted outside)
Fig 4.
Recirculation mode
(no ducting)
Instruction Manual |9
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Campana de ventilación de CDA
CDA
CDA EVG Series Manual de referencia
CDA
CDA EVCK4 Manual de usuario
CDA
CDA EVC41SS Manual de usuario
CDA
CDA EVPK90 Hoja de especificaciones
CDA
CDA EXG60BL Guía del usuario
CDA
CDA EVPK9 Manual de referencia
CDA
CDA EVP6 Manual
CDA
CDA 3Z9 Manual de referencia
CDA
CDA CHX10 Manual de usuario
CDA
CDA 3D9BL Manual de referencia
CDA
CDA EVPC9 Manual de referencia
CDA
CDA EVC4 Manual de usuario
CDA
CDA ECN62 Manual de referencia
CDA
CDA EVB9 Manual de usuario
CDA
CDA CIGE9 Manual de usuario
CDA
CDA CIGE9 Manual
CDA
CDA EDD62 Guía de inicio rápido
CDA
CDA CTE Series Manual de referencia
CDA
CDA CTE61 Manual
CDA
CDA EZA60BL Guía de inicio rápido
