CDA hn9625 Manual de referencia
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
hn9625 Induction Hob
Manual for Installation, Use and Maintenance
2
Important
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note
that CDA reserve the right to invalidate the guarantee supplied with
this product following incorrect installation or misuse of the appliance
or use in a commercial environment.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had
supervision or instructions on how to use the appliance by someone
who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
CE Declarations of Conformity
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation, including Electrical safety (LVD)
2006/95/EC and Electromagnetic interference compatibility (EMC)
3
2004/108/EC. Parts intended to come into contact with food conform
to 89/109/EC.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must be taken to a special
local authority waste collection centre or to a dealer providing
appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin.
Please note:
•Induction hobs become hot and remain hot during and immediately
after use. Do not touch the hob until it has been allowed to cool.
•Keep children away from the appliance when in use.
•Never use the hob top for storage.
•Pan handles should never stand out beyond the edge of the
worktop. This will ensure children cannot reach them.
•Do not lean over the hob when it is in use.
•Follow the cleaning instructions carefully.
•Ensure the base of the saucepan is clean and dry before placing it
on the hob.
•Avoid hard shocks from cookware – the vitroceramic glass surface
is highly resistant but not unbreakable.
4
•Do not place hot lids flat on the hob top. A “suction” eect could
cause damage to the hob.
•Do not drag cookware across the hob top: in the long term, this
could cause damage to the hob.
•Do not store cleaning or flammable products in the unit below the
hob.
•Always use appropriate cookware.
•Do not cook unopened tins of food directly on the hob.
•Never put cooking foil or plastic materials on the ceramic surface
when the hob is hot. These materials could melt and cause
damage to the hob.
•This hob (Class 3) has been designed for use only as a cooking
appliance. Any other use should be considered incorrect and
therefore dangerous.
FOR THOSE WITH HEART PACEMAKERS OR ACTIVE IMPLANTS:
The function of this hob conforms to current electromagnetic
interference standards and thus is in total compliance with legal
requirements (2004/108/CE directives).
To avoid interference between your hob and a pacemaker, your
pacemaker must be designed and programmed in compliance with
the regulations that apply to it. As such, CDA guarantee only that our
product is compliant.
With regard to the compliance of the pacemaker or any potential
incompatibility, you should obtain information from the manufacturer
or your attending physician.
5
Important
•Do not use the hob if the glass surface is cracked or damaged to
prevent the risk of electric shock. Disconnect it from the power
supply.
•Ensure that the power cable of a connected electrical appliance
near the hob is not in contact with the cooking zones.
6
Cooking on Induction
The principle of induction cooking is based on magnetic eect.
When you put your cookware on an induction zone and switch it on,
the electronic boards in the hob produce induced currents in the base
of the cookware and instantly raise its temperature. This heat is then
transferred to the food inside the cookware.
The best cookware to use with induction cooking has thick flat bases,
as the heat will be better distributed so cooking more evenly.
Most cookware is compatible with induction cooking.
There are three ways to check the suitability of your cookware:
1. Using a magnet to see if the base of the pan is magnetic: If the
magnet sticks, then the cookware is compatible.
2.Place the pan on one of the cooking zones and switch the zone
on. If the display continues to show the selected power level then
the cookware is compatible. If the display shows “ ”, the cookware
cannot be used on an induction hob.
3.Check the instructions or packaging of the pans for the symbols
indicating suitability for use with induction.
7
Using Your Hob
Power level Type of cooking
0 Switched o
1/2 For melting (butter/chocolate) or keeping food warm
2/3 Keeping food hot or to heat small quantities of liquid
3/4 Heat larger quantities of liquid (sauces etc.)
4/5 Slow boiling, e.g spaghetti, soups, stews, potatoes
6/7 Gentle frying
7/8 Browning meats, frying fish, omelettes
9 Fast frying steaks
Fig.1
5 6 7 8
Control panel:
1. Front left 2.3-3kW 200mm
2 Centre left 1.4kW 160mm
3. Centre right 1.4kW 160mm
4. Front right 2.3-3kW 200mm
5. Power key
6. Slider control
7. Booster key
8. Pause/restart key
9. Timer key/display
10. Zone key/displays
1
2 3
4
8
Using Your Hob
To switch the hob on
•To switch the power on, touch and hold for approximately two
seconds. The hob will beep and all four zone displays will show “0”.
Please note: If a power level is not set within twenty seconds, the hob
will switch off automatically.
To set the power level
•Touch the zone display for the required zone. The hob will beep
and the zone display will show a "." (dot) in the bottom right corner.
•Then touch the slider control at the required point, or move up or
down the slider until the zone display shows the required power
level from 1 (minimum) to 9 (maximum).
Please note: After zone selection, the zone will remain active for
approximately ten seconds. If no key is touched during this time, the
zone will become inactive, and the hob will switch off automatically
after a further ten seconds if no zones are in use.
To turn the power off
•To switch off a single zone, touch the zone display to make the
slider active for the required zone, then set the slider to “0”
for the zone no longer required. When all the zones are at “0”, the
hob will switch off automatically after approximately twenty seconds.
•Alternatively, to switch off the hob immediately, touch and hold
for approximately two seconds.
9
Booster
•The hob is equipped with a booster function on the front left and
front right zones, allowing a higher power level than the maximum
for approximately five minutes. To turn on the booster function,
touch the zone display for the required zone then touch . “P” will
show in the zone display whilst the booster is on. To cancel the
booster at any time, touch the zone display to activate the slider,
then set the required power level.
Auto-heat
•Every zone is equipped with an auto-heat function, which reduces
the warming up time for the zone. To turn on the auto- heat
function, touch the zone display for the required zone, then set the
power level to “9” using the slider control.
•Touch the “9” position on the slider control again and the display
will alternate between “9” and “A”.
•Then select the power level required. The display will alternate
between the set power level and “A” for a preset period of time,
before reducing the power to the level required.
•If no final power level is set, the auto heat is switched off and the
zone will remain on power level “9”.
10
Timer/Minute Minder
The hob is equipped with a timer that allows a finish time to be set for
the end of cooking on any zone, between a minimum of one minute
and a maximum of 99 minutes. This timer can be used separately for
each zone, and an LED will indicate the zone positions for each of the
active timers. Once the timers are set, the timer display will show the
time remaining on the first zone to finish cooking. The timer can also
be used as a minute minder to countdown time, when the zones are
not in use.
To set the timer
•First switch on the hob and set the zone to the power level
required.
•Touch the timer display. The display will show “0-” for approximately
ten seconds and the timer display LED will illuminate for the
required zone. If no timer is set, the timer display will become
inactive and the zone will continue cooking.
•Touch the slider control to set the individual minutes between 0
and 9. The selection will confirm in approximately 2 seconds, the
display will show “–” and the minutes set.
•Touch the slider control again to set the tens of minutes between 1
and 9. The selection will confirm in approximately 2 seconds, the
timer display will show the timer set and the countdown will start.
At the end of the timer, the selected zone will switch o, the timer
display and the zone timer LED will flash. The hob will beep for
approximately two minutes. To switch o the beep and the flashing
displays, touch any key.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Quemador de CDA
CDA
CDA HN9611FR Guía de inicio rápido
CDA
CDA Matrix MHN101FR Manual de usuario
CDA
CDA HG7250 Guía de inicio rápido
CDA
CDA HG6250 Guía de inicio rápido
CDA
CDA HN9850FR Instrucciones de instalación y funcionamiento
CDA
CDA HC6211FR Guía de inicio rápido
CDA
CDA hn6110 Manual de referencia
CDA
CDA hc3620 Manual de referencia
CDA
CDA HN6731FR Instrucciones de instalación y funcionamiento
CDA
CDA HC9606FR Hoja de especificaciones
CDA
CDA he6050ss Manual de referencia
CDA
CDA HC6621FR Hoja de especificaciones
CDA
CDA PEB4.7SVR Manual de usuario
CDA
CDA HCC762 Manual de referencia
CDA
CDA HC3621FR Manual de usuario
CDA
CDA HNE8FR Instrucciones de instalación y funcionamiento
CDA
CDA Domino HE3140SS Guía de inicio rápido
CDA
CDA HC7600 Hoja de especificaciones
CDA
CDA HCN510 Manual de referencia
CDA
CDA hc9625 Manual de referencia
