Cateye PADRONE DIGITAL CC-PA400B Manual de usuario

SET 4

Using the app

Using the unit

Appendix

Cover,

Introduction

CATEYE

PADRONE

DIGITAL

CYCLOCOMPUTER

CC-PA400B

The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use

of such marks by CATEYE Co., Ltd. is under license. Other trademarks and trade names

are those of their respective owners.

• This instruction manual is subject to change

without notice. See our website for the latest

instruction manual (PDF).

• Please visit our website, where a detailed

Quick Start manual containing videos can be

downloaded.

http://www.cateye.com/products/detail/CC-PA400B/manual/

Setting up

the

PADRONE DIGITAL

Smartphone

PADRONE DIGITAL

Mounting

the PADRONE DIGITAL

Wearing

the heart rate sensor

Introduction

Starting measurement

Changing settings

Capabilities with a smart-

phone (Cateye Cycling™)

Warning / Caution

Product Warranty, etc.

SET 4

Using the app

Using the unit

Appendix

Cover,

Introduction

The PADRONE DIGITAL is a cyclocomputer that uses Bluetooth® SMART sensors. In

addition to the included sensors, optional or commercial sensors can also be connected

for use.

Mounting the PADRONE DIGITAL, Wearing the heart rate sensor

If you have purchased the double wireless kit

The model you have purchased does not come with the heart rate sensor and HR strap.

You can use all the functions written in this instruction manual, such as measurements

related to your heart rate, by using an optional heart rate sensor kit.

• Mount the bracket (Page 3)

• Mounting the speed/cadence sensor (ISC-12) (Page 5)

• Wearing the heart rate sensor (HR-12) (Page 9)

* For detailed explanations on how to use CATEYE sensors such as mounting, or pairing,

see the sensor’s Online Manual (on our website) or the Quick Start Manual (PDF/smart-

phone app).

Setting up the PADRONE DIGITAL

The ﬁrst time that you use this product, perform the initial setup from the PADRONE

DIGITAL or from a smartphone (Cateye Cycling™).

Use the method corresponding to your device to set up the PADRONE DIGITAL. You can

change the display of its measurement screen and its total distance value as necessary.

* If you have a smartphone, you can use the “Cateye Cycling™” smartphone app (free of

charge) to easily set up the PADRONE DIGITAL.

• If you do not have a smartphone

1. Setup with the PADRONE DIGITAL (Page 11)

2. Changing settings (Page 22)

• If you have a smartphone

1. Setup with a smartphone (Cateye Cycling™) (Page 15)

2. Capabilities with a smartphone (Page 31)

Introduction

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

1/8

• When mounting on handlebar

Mount the bracket

The bracket can be mounted on either the stem or the handlebar.

Mount the bracket

• When mounting on stem

Mounting the PADRONE DIGITAL

Cut

Cutting band after mounting

Caution!:

Cut the bracket band so

that cut end will not cause

injury.

Dial

Handlebar

Bracket band

Bracket

rubber pad

Stem

Bracket band

Bracket

rubber pad

Bracket band Bracket DialBracket rubber pad

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

2/8

Attach/detach PADRONE DIGITAL

Mounting the PADRONE DIGITAL

Mount the bracket

Hold PADRONE DIGITAL.

Push out so that front lifts up.

Click

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

3/8

• Mounting on top of chain stay

Mounting the speed/cadence sensor (ISC-12)

The speed (cadence) sensor can be mounted either on the top or bottom of the chain stay.

• Mounting on bottom of chain stay

Caution!:

If the speed (cadence) sensor is mounted on the bottom of the chain stay rather than

on the top, the adjustment range between the sensor and the magnet will be narrower.

* If using pedals with steel axles, the cadence magnet can be attached magnetically to the

pedal axle.

* For detailed explanations on how to use CATEYE sensors such as mounting, or pair-

ing, see the sensor’s Online Manual (on our website) or the Quick Start Manual (PDF/

smartphone app).

* The following mounting procedure gives instructions for mounting on the top of the

chain stay.

Mounting the PADRONE DIGITAL

Cadence magnet

Speed (cadence)

sensor

Speed (cadence) sensor

Wheel magnet

Cadence magnet

Nylon tie (x5)

Sensor rubber pad

Speed/Cadence

sensor

(ISC-12)

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

4/8

Temporarily attach the sensor to the left chain stay.

(1) Loosen the sensor screw using a Phillips screwdriver and check that the sen-

sor arm moves.

(2) Attach the sensor rubber pad to the sensor.

Sensor rubber pad

(3) Refer to the illustration and temporarily attach the sensor to the left chain stay

with nylon ties.

Caution!:

Do not fully tighten the nylon ties.

Once the nylon ties are fully tightened they cannot be removed.

Nylon tie

Sensor arm

Sensor screw

Left chain stay

Mounting the PADRONE DIGITAL

Mounting the speed/cadence sensor (ISC-12)

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

5/8

Temporarily attach the magnet.

Nylon tie

Sensor zone

(CADENCE) side Sensor zone (SPEED) side

Cadence

magnet Spoke

Wheel magnetSensor zone (CADENCE)

Sensor zone (SPEED)

(1) Using a nylon tie, temporarily attach the cadence magnet to the inside of the

left crank arm so that it faces the cadence sensor zone.

* If using pedals with steel axles, the cadence magnet can be attached mag-

netically to the pedal axle. In this case, remove the adhesive tape from the

magnet and do not use the nylon tie.

(2) Rotate the sensor arm and temporarily attach the wheel magnet to a spoke

facing the speed sensor zone.

* Reposition the sensor and the magnets if both magnets (speed and cadence)

cannot pass through their respective sensor zones.

Mounting the PADRONE DIGITAL

Mounting the speed/cadence sensor (ISC-12)

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

6/8

Adjust the gap between the sensor zone and the magnet.

(1) Tilt the sensor so that the gap between the cadence magnet and the cadence

sensor zone is approximately 3 mm, then fasten the sensor securely with

nylon ties. 3 mm

Cadence magnet

(2) Rotate the sensor arm so that the gap between the wheel magnet and the

speed sensor zone is approximately 3 mm, then tighten the sensor screw

securely. 3 mm

3 mm

Sensor screw

Wheel magnet

Secure all parts.

Securely tighten the sensor’s nylon ties, the sensor screw, the wheel magnet, and

the cadence magnet so that they do not move, and then check that these items are

not loose.

Trim off the excess nylon tie.

Mounting the PADRONE DIGITAL

Mounting the speed/cadence sensor (ISC-12)

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

7/8

Wearing the heart rate sensor (HR-12)

Heart rate is measured by wearing a heart rate sensor around the chest.

* The double wireless kit does not include a heart rate sensor. Purchase this item sepa-

rately.

Before wearing the heart rate sensor

Warning!!!:

Never use this device if you use a pacemaker.

• To eliminate measurement errors, it is recommended to moisten the electrode pads

with water or apply electrolyte cream to the pads.

• If you have sensitive skin, moisten the electrode pads with water and wear it over a

thin shirt.

• Chest hair may interfere with measurement in some cases.

* For detailed explanations on how to use CATEYE sensors such as mounting, or pair-

ing, see the sensor’s Online Manual (on our website) or the Quick Start Manual (PDF/

smartphone app).

Attach the sensor to the HR strap.

Press until you hear a clicking sound.

Heart rate sensor

HR strap

Heart rate sensor

(HR-12) HR strap

Cover,

Introduction

SET 4

Using the app

Using the unit

Appendix

8/8

Wear the HR strap by sliding the hook over the other end of

the strap.

Wind the HR strap around your body and adjust the length to suit your chest (un-

derbust). Overtightening the strap may cause discomfort during measurement.

Hook Back side

Electrode pads

* Wear the heart rate sensor so that TOP faces up.

* Ensure that the electrode pads are in close contact with your body.

* If you have dry skin or are wearing the sensor over a shirt, measurement errors

may result. In such cases, moisten the electrode pads with water.

Wearing the heart rate sensor (HR-12)

Otros manuales para PADRONE DIGITAL CC-PA400B

Tabla de contenidos

Otros manuales de Accesorios para bicicletas de Cateye

Cateye

Cateye MITY 3 Manual de usuario

Cateye

Cateye DOUBLE SHOT PRO Manual de usuario

Cateye

Cateye COMMUTER CC-COM10W Manual de usuario

Cateye

Cateye STEALTH EVO Manual de usuario

Cateye

Cateye CC-ED300 Manual de usuario

Cateye

Cateye CC-PA100W Manual de usuario

Cateye

Cateye STRADA CC-RD100N Manual de usuario

Cateye

Cateye MITY 2 Manual de usuario

Cateye

Cateye Vectra CC-VT100W Manual de usuario

Cateye

Cateye Strada Smart CC-RD500B Guía de configuración

Cateye

Cateye CC-AT100 (ALTIMETER) Manual de usuario

Cateye

Cateye Velo Wireless + Manual de usuario

Cateye

Cateye Enduro CC-ED400 Manual de usuario

Cateye

Cateye stealth 50 cyclocomputer CC-GL50 Manual de usuario

Cateye

Cateye CC-ED200N Manual de usuario

Cateye

Cateye HL-1600 Manual de usuario

Cateye

Cateye PADRONE SMART Manual de usuario

Cateye

Cateye CC-5000 SOLAR 2 Instrucciones de funcionamiento y mantenimiento

Cateye

Cateye CC-PA100W Manual de usuario

Cateye

Cateye Tomo CC ST-200 Manual de usuario

Cateye

Cateye CC-VL100 Manual de uso y mantenimiento

Cateye

Cateye TL-LD1000 Manual de uso y cuidado

Cateye

Cateye OS 1.1 Manual de usuario

Cateye

Cateye ROAD Manual de usuario

Manuales populares de Accesorios para bicicletas de otras marcas

Sigma

Sigma BC 16.16 Manual de usuario

Playcore

Playcore Dero Setbacks Manual de usuario

VDO Cyclecomputing

VDO Cyclecomputing x3dw Manual de usuario

buratti meccanica

buratti meccanica Clorofilla Trail Manual de usuario

Shimano

Shimano SG-8R20 Instrucciones de funcionamiento

BOB

BOB YAK Manual de usuario

APLIC

APLIC 303303/20190717TW012 Manual de usuario

SRAM

SRAM AXS BlipBox Manual de usuario

Garmin

Garmin EDGE 500 Manual de usuario

Shimano

Shimano FD-RX810 Manual de usuario

KMART

KMART 43115907 Manual de usuario

SIGMA SPORT

SIGMA SPORT Buster 2000 Manual de usuario

NVO Components

NVO Components STEM Manual de usuario

DAXYS

DAXYS BP188 Manual de usuario

XLC

XLC BV-W17 Manual de usuario

Deda Elementi

Deda Elementi SUPERBOX Manual de usuario

Akku Vision

Akku Vision e-bike vision 10046 Guía de inicio rápido

Squire

Squire Inigma Manual de usuario