Cartoni MAXIMA 5.0 Manual de usuario
PROFESSIONAL CAMERA SUPPORT
USER’S MANUAL & Maintenance
2
3
Index
1.
IntroductIon 5
2.
operatIng elements 6
3.
procedures 8
4.
specIfIcatIons 9
5.
maIntenance 10
6.
Warranty 10
7.
accessorIes & product lIne 11
CARTONI ®
All rights reserved ©
4
5
1. IntroductIon
The new MAXIMA 5.0 is the ulmate answer for Digital Cinematogra-
phy with heavy duty packages. Its outstanding patented counterbalance
compensates payloads from zero to 50 kg, with “perfect balance” through-
out the 180° lt range. The patented connuous uid drag system per-
forms from almost freewheeling to extremely consistent drag for maximum
versality and perfect diagonal shots.
The MAXIMA 5.0 knobs and levers are ergonomically placed to ensure
camera operators complete ease-of-use in any situaon, whether in the
studio, locaon or during outside shoong. Drag and counterbalance set-
ngs are monitored on a large digital display.
The large sliding camera plate is compable with Arri, Sony and O’Con-
nor slides. The head comes with a telescopic pan bar and a short front pan
bar. With the classic Mitchell base the MAXIMA 5.0 interfaces with all at
base Mitchel tripods and plaorms.
Oponal 150mm bowl base can be easily applied.
Before using the MAXIMA 5.0 Fluid Head, please make sure to read
this user’s & maintenance manual;
Before installing the Fluid Head on the tripod check the tripod
stability;
Check that the Camera payload (including lenses and accesso-
ries) is lower than the maximum capacity of the MAXIMA 5.0
Fluid Head;
Before installing the Camera make sure the MAXIMA 5.0 is in
good condions and bares no evident damages.
6
⓳
⓯
❶
❷
❸
❹ ❺ ❻ ❼ ❽ ❾ ⓲
❿
⓫
2. operatIng elements
1
Slide lock lever
2
Horizontal lock lever
3
Counterbalance selector
4
Pan lock lever
5
Pan drag selector
6
Tilt lock lever
7
Illuminated bubble level
8
Illuminated bubble level
and display light buon
9
Digital display
10
Extensible handle
aachment lever
7
⓱
⓴
⓮ � ⓰
⓭
�
⓬
11
Extensible pan handle
12
Short handle
13
Short handle aachment lever
14
Short handle aachment rosee
15
Camera plate
16
Tool box aachment
17
Handle aachment lever
18
Handle aachment rosee
19
Safety buon slide lock lever
20
Tilt drag selector
21
Tie down knob
22
Baery housing
21 22
8
Open the tripod to the desired height and lock all the safety knobs.
Place the MAXIMA 5.0 Fluid Head on the tripod base and rotate unl
it matches the steel notch; ghten the Head rmly by screwing in
the knob (21) underneath the at base. Check the illuminated bubble
level (7) and modify the legs angle if needed. In case of low visibility,
press buon (8) for illuminated bubble level and to acvate the digital
displays (9). Lights will turn o automacally aer approximately 30
seconds.
Lock the horizontal posion with lever (2) red posion, insert pan
lock (4) and turn both lt drag selector (20) and counterbalance se-
lector (3) to posion “0”.
To release the Camera plate (15) push the red safety buon (19) and
open the slide lock lever (1) completely ll to posion 2, then remove
the Camera plate.
Aach the Camera plate under the Camera assembly and rmly se-
cure it with both screws. Try to place the Camera plate centered un-
der the Camera system, keeping in mind the posion of the center of
gravity (CG).
Place the Camera on the top of the MAXIMA 5.0, leaning sidewards
against the le side of the head (slide lock side), then push the as-
sembly into horizontal posion unl you feel the click of the slide
lock lever (1), which will be in posion 1 (at this point the Camera
plate is clamped but sll moving fore-and-a).
3. procedures
9
Holding the pan bar (11) rmly, disengage lever (2) to green posion
and nd the correct center of gravity (CG) sliding the Camera assem-
bly fore-and-a. Lock the slide lock lever (1) all the way in.
Set the counterbalance system by turning the counterbalance selec-
tor (3) to the appropriate tension. The Camera has to stay sll at any
lt angle. If needed, ne tune the balance by adjusng the sliding
plate.
Push buon (8) to acvate illuminated digital displays (9), unlock Pan
lock (4) and select the desired Fluid drag intensity on both Pan and lt
by turning Pan selector (5) and lt selector (20).
Minimum payload 0 Kg 0 lbs
Maximum payload 50 Kg 110 lbs
Weight 13 Kg 28.7 lbs
Bowl diameter Flat base
Fluid control Connuous
Counterbalance Connuous
Pan range 360°
Tilt range +/-90°
Temperature range -40 /+60 °C -40 /+140 °F
4. specIfIcatIons
10
5. maIntenance
6. Warranty
When needed, with indoor use just clean the Head and Tripod with a
so cloth. Dirt accumulated during storage may be removed using a brush
or Air spray.
CARTONI products main mechanisms are sealed as they are also built
for professional outdoor use.
However, use under rough condions they will require special care. Salt
water is very corrosive and can cause extreme damages. In aempt to avoid
further damage the Fluid Head should be washed o with fresh water at
the earliest opportunity and perfectly dried before storage.
Sand and dirt are abrasive and should be removed using a semi-s
brush or Air spray.
Disconnect the illuminated display & bubble level baery during long
term storage; for baery replacement access the baery compartment (22).
All CARTONI Fluid Heads & Pedestals have a free of charge three (3)
year warranty. Register your product at www.cartoni.com within 30 days
from date of rst purchase/invoice to receive further two (2) year warranty
for the unsurpassed free ve (5) year warranty.
Tripods, spreaders, dollies and all accessories are guaranteed one (1)
year from the date of rst purchase/invoice.
CARTONI warrant that the product supplied will - under proper use -
be free from defects in workmanship and materials and agrees that it will,
Tabla de contenidos
Otros manuales de Accesorios para cámaras de Cartoni
Cartoni
Cartoni P70 PLUS Instrucciones de montaje
Cartoni
Cartoni Master MK2V Manual de usuario
Cartoni
Cartoni MASTER 40 Manual de usuario
Cartoni
Cartoni MASTER 65 FLUID HEAD Manual de usuario
Cartoni
Cartoni focus hd Manual de usuario
Cartoni
Cartoni HiDV Manual de usuario
Cartoni
Cartoni UV-C BOXER Manual de usuario
Cartoni
Cartoni Focus 10 Guía
Cartoni
Cartoni MASTER MK2 Manual de usuario
Cartoni
Cartoni Focus Manual de usuario
Cartoni
Cartoni Focus 8 Manual de usuario
Cartoni
Cartoni MAXIMA 30 Manual de usuario
Cartoni
Cartoni MAGNUM Manual de usuario
Cartoni
Cartoni Master 25 Manual de usuario
Cartoni
Cartoni LAMBDA 50 Manual de usuario
Cartoni
Cartoni SPORT 2000 Manual de usuario
Cartoni
Cartoni P20 Manual de usuario
Cartoni
Cartoni FOCUS 8S Manual de usuario
Cartoni
Cartoni Sigma Manual de usuario
Cartoni
Cartoni Canon DIGISUPER XJ27X6.5B Manual de programación
