Carrier 33CSSP3-FC Manual de usuario
Table of Contents
Front Panel .......................................................................................2
Display..............................................................................................3
Quick Start Set the clock and go .............................................................6
Selecting the Heat or Cool Mode ........................................................7
Basic Operation...............................................................................11
Overriding the Daily Schedule..........................................................12
Programming Occupied / Unoccupied ....................................................13
Advanced Setup ..............................................................................18
About Advanced Features & Operation.............................................24
This equipment has been tested and found to comply
with the limits for a Class A digital device pursuant to
Part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against
harmful interference when this equipment is
operated in a commercial environment.This
equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to cause
harmful interference, in which case the user
will be required to correct the interference at his/her
own expense.
This Class (A) digital apparatus meets
all the requirements of the Canadian
Interference-Causing Equipment
Regulations.
Cet appareil numérique de la Classe
(A) respecte toutes les exigences du
R`eglement sur le matériel brouilleur
du Canada.
Follow Installation Instructions carefully. Disconnect
Power to the Heater/Air Conditioner before removing
the old thermostat and installing the new thermostat.
CAUTION
IMPORTANT
North American Emissions Compliance
United States Canada
© Copyright 2014, All Rights Reserved P/N 33CSSP3-FC
1
Downloaded from ManualsNet.com search engine
Display
3
1Mode Indicators - Page 7-10
Selects the operational mode of the equipment.
HEAT - Indicates the heating mode.
COOL - Indicates the cooling mode.
AUTO - Indicates the system will automatically changeover between
heat and cool modes as the temperature varies.
PROGRAM ON - Indicates the time period program is enabled to run.
OFF - Indicates heating and cooling are turned o.
2 Clock with Day of theWeek - Page 6
Indicates the current time and day. This clock is also used to
program the time period schedules.
3Room Temperature Display
Indicates current room temperature.
4Desired Set Temperature - Page 11
Indicates desired room temperature(s).
OUTSIDE
3
1
24
1
1
1
4
Downloaded from ManualsNet.com search engine
Display
4
5Override icon - Page 12 & 21
Indicates the program is currently being overriden for up to six hours.
6Occupied & Unoccupied icons - Pages 13-16
Indicates the program number: Occupied 1, 2, 3, or Unoccupied.
7Setup icons - Pages 18-22
Indicates the thermostat is in the advanced setup mode.
8Fan icon - Page 11
Indicates fan operation.
Fan = low speed
Fan = medium speed
Fan = high speed
When only the Fan icon is displayed, the fan is in the Auto mode and
will run only when necessary to heat or cool.
OUTSIDE
8
67
5
Downloaded from ManualsNet.com search engine
Display
5
9Start & Stop icon - Page 14 & 16
Appear when programming occupied time periods.
10 Locked icons - Pages 30
Indicates keypad has been locked.
11 Outside icons - Pages 21-31
Indicates the temperature displayed is from the optional outside sensor.
OUTSIDE
910
11
Downloaded from ManualsNet.com search engine
Quick Start Set the Clock and Go
6
Press the MODE and FAN buttons at the same time
for two seconds to enter Setup screens.
During Setup and
Programming: Pressing
the UP or DOWN button
will modify the ashing
selection.
Tip: To change hours
quickly, press and hold
the FAN button and
press the UP or DOWN
button.
Press the MODE and FAN
buttons at the same
time to return to normal
operation.
The thermostat is preprogrammed from the factory to operate a 4 pipe system without
the need for further programming.To optimize the installation of this thermostat for a
2 pipe system, follow the instructions in the Advanced Setup section. Page 19
FAN
FAN
MODE
MODE
Setting the Clock
Setting the Day MODE
Press
To adjust the
Clock or Day,
Use
Downloaded from ManualsNet.com search engine
Selecting the Heat or Cool Mode 4-Pipe Operation
7
Heating Only
The HEAT setting indicates the temperature
that the room has to fall to before the heat-
ing source will turn on to heat the room.
Cooling Only
The COOL setting indicates the temperature
that the room has to rise to before the cool-
ing source will turn on to cool the room.
Heating or Cooling
AUTO will automatically select heat or cool
based on room temperature demand.
Time Schedule for Heating or Cooling
Program On will activate the stored timer
operation for the heating and cooling
setpoints (occupied or unoccupied periods).
O
OFF indicates both heating and cooling are
turned o.
Press
MODE
Press
MODE
Press
Press
MODE
MODE
Fan
Fan
Fan
Fan
Select Mode by Pressing the MODE Button
Downloaded from ManualsNet.com search engine
Selecting the Heat or Cool Mode 2-Pipe Operation
8
Heat Only
Step #6 = 1 in the Advanced Setup section, page 19.
Heating Only
The HEAT setting indicates the temperature
that the room has to fall to before the heating
source will turn on to heat the room.
Time Schedule for Heating or Cooling
Program On will activate the stored timer
operation for the heating and cooling
setpoints (occupied or unoccupied periods).
OFF
OFF indicates both heating and cooling
are turned o.
Press
MODE
Press
MODE
Fan
Fan
Downloaded from ManualsNet.com search engine
Selecting the Heat or Cool Mode 2-Pipe Operation
9
Cool Only
Step #6 = 2 in the Advanced Setup section, page 19.
Cooling Only
The COOL setting indicates the temperature
that the room has to rise to before the cooling
source will turn on to cool the room.
Time Schedule for Heating or Cooling
Program On will activate the stored timer
operation for the heating and cooling
setpoints (occupied or unoccupied periods).
OFF
OFF indicates both heating and cooling
are turned o.
Press
MODE
Press
MODE
Fan
Fan
Downloaded from ManualsNet.com search engine
Otros manuales para 33CSSP3-FC
1
Tabla de contenidos
Otros manuales de Termostato de Carrier
Carrier
Carrier 5+2 DAY PROGRAMMABLEDIGITAL THERMOSTAT Manual de usuario
Carrier
Carrier Infinity SYSTXCCITW01 Manual de usuario
Carrier
Carrier A94134 Instrucciones y recetas
Carrier
Carrier 33CS Manual de usuario
Carrier
Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL... Manual de usuario
Carrier
Carrier Cool Share Web-Programmable Thermostat Manual de usuario
Carrier
Carrier KSACN0401AAA Manual de usuario
Carrier
Carrier A99068 Instrucciones de montaje
Carrier
Carrier debonair 33cssn2-wc Manual de usuario
Carrier
Carrier AC Instrucciones y recetas
Carrier
Carrier Debonair 33CS250-01 Manual de usuario
Carrier
Carrier ComfortVu TB-24 Instrucciones de funcionamiento
Carrier
Carrier Totaline Star P474-1010 Manual de usuario
Carrier
Carrier HYPERSTAT Manual de usuario
Carrier
Carrier Performance TP-NHP Manual de usuario
Carrier
Carrier 33CSSP3-FC Manual de usuario
Carrier
Carrier AQUAZONE 50QE900 Manual de usuario
Carrier
Carrier NON-PROGRAMMABLE DIGITALTHERMOSTAT Manual de usuario
Carrier
Carrier TSTAT Instrucciones y recetas
Carrier
Carrier Performance TP-NHP Manual de usuario
Manuales populares de Termostato de otras marcas
EWELLY
EWELLY EW-181 Manual de usuario
Prolon
Prolon T1100 Instrucciones de instalación
Computherm
Computherm Q20 Manual de usuario
Heatmiser
Heatmiser neoStat Manual de usuario
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario
