Carrier Micro-Link 5 Manual de usuario

ML5 WiFi Capabilities (Separate section inside the manual just for WiFi.

The ML5 controller offers connectivity thru WiFi 802.11 b/g/n. When the device is connected to

the WiFi the user can connect to the ML5 controller via the Data-Connect program. Additionally

the user can connect to the ML5 controller through your devices browser by accessing a

webpage that resides on the ML5 controller.

There are two types of operating systems that can connect to the ML5 controller, IOS and

Android. IOS systems require you to enter the password in your systems setting and enter the

password a second time when logging into the Data-Connect program or resident webpage. The

Android system only requires you to log into the devices WiFi settings.

The ML5 WiFi can be accessed through the Alt menu on the keypad. Select Alt and arrow

through the display until ‘net’ is displayed, select ENTER key. Scroll through the menu until “

EnbL” is displayed in the left display. On the right display the user can scroll up or down and

select “On” to enable WiFi or “OFF” to disable.

Steps to log into the controller network.

Start the refrigeration system.

Turn on your wireless device, tablet, cellphone, etc.

1) From your home screen, tap the Apps located at the upper-right of your tablet screen.

2) Tap on the Settings icon. ...

3) Tap on the Wireless and networks section, tap on Wi-Fi settings.

4) Tap on Wi-Fi: Turn on Wi-Fi.

5) Locate your wireless network by locating the Container ID in the available networks (SSID).

6) You’ll be prompted by your device at this point to enter the password.

To see the password access the controller keypad.

1) Press “Alt Mode”

2) use the down arrow to get “nEt” to show on the display.

3) Press “ENTER”

4) use the down arrow to get “PASSW EntR” to show on the display.

5) Press “ENTER”

6) wifi password translation…

Notes about the password:

WiFi password resets every 4 hour (hours 2,5,8,11 based on system clock)

Password is good for the customers fleet (assuming all clock are set properly)

If communicating at the password change time boundary, the session can run for an addition 4

hours without changing the password.

Data-Connect (internal app)………

- Add instruction to connect app to controller

Connecting with device browser……..

- Add instruction to open browser and open webpage

Controller Function Code:

WiFi User Interface:

1.1 Wireless menu in ALT. Mode

Below are the necessary (limited set of) parameters that are needed for wireless configuration

and status checks, accessible via the 7-seg LCD display.

More comprehensive wireless configuration and status are available via the embedded http

portal.

All the below parameters are available in ALT. Mode under the “nEt” menu.

Need to determine how to explain many of

these options to the user

TYPE

Display, Select

FUNCTION

WIRELESS ACCESS

MAIN MENU

Wireless Enable/ Disable, WiFi Role, WiFi

Access Point Status, WiFi Client Status (WiFi

Role = Station), Token (Derived Key), WiFi

Password

DEFAULT

Wireless Enable/ Disable

MAIN MENU DISPLAY

For Wireless Enable/ Disable: Left Display: “

EnbL”, Right Display: “ on”, “ OFF”

For WiFi Role: Left Display: “ roLE”, Right

Display: “ AP”, “ STA”, “ dUAL”

For WiFi Access Point Status: Left Display:

“APStA”, Right Display: “ OFF”, “ InIt”, “

IdLE”, “ Err”, “ Conn”

For WiFi Client Status: Left Display: “ CStA”,

Right Display: “ OFF”, “ Conn”, “ InIt”,

“IPCHk”, “ IdLE”, “ SrCH”, “ Err”

For Token (Derived Key): Left Display: “

toK”, Right Display: “ EntR”

When Enter is pressed: Left Display: <blank>,

Right Display: 4 digit numeric text (Phase 1),

“ COnF”

For WiFi Password: Left Display: “PASSW”,

Right Display: “ EntR”

When Enter is pressed: Left Display: 4 digit

alpha Right Display: 4 digit alpha

numeric text, numeric text, “-----“

SUBMENU DEFAULT

For Wireless Enable/ Disable: “ on”

For WiFi Role: “ AP”

For WiFi Access Point Status: “ OFF”

For WiFi Client Status: “ OFF”

For Token (Derived Key): “ EntR”

For WiFi Password: “ EntR”

DESCRIPTION

For Wireless Enable/ Disable:

This function code is used to enable or disable

Wireless.

Product name: Micro-Link 5 Controller

Model name: ML5

FCC ID: 2AK6N-MICROLINK5

ISED ID: 703A-MICROLINK5

FCC statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Important Note: To comply with the FCC RF exposure compliance requirements, no change to

the antenna or the device is permitted. Any change to the antenna or the device could result in

the device exceeding the RF exposure requirements and void user’s authority to operate the

device.

Caution: Exposure to Radio Frequency Radiation. To comply with FCC/IC RF exposure

compliance requirements, a separation distance of at least 20 cm must be maintained between the

antenna of this device and all persons. This device must not be co-located or operating in

conjunction with any other antenna or transmitter.

ISED statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two

conditions: (1) This device may not cause interference. (2) This device must accept any interference,

including interference that may cause undesired operation of the device.

Tabla de contenidos

Otros manuales de Controladores de Carrier

Carrier

Carrier KVBCN0101CLT Guía de configuración

Carrier

Carrier 50CO Series Manual

Carrier

Carrier 38CQ Manual de usuario

Carrier

Carrier KJR-12B/DP-E Manual de usuario

Carrier

Carrier COMFORT ZONE ZONEKIT4ZCAR Instrucciones y recetas

Carrier

Carrier RTU Open v3 Guía de configuración rápida

Carrier

Carrier WTC-RCI-S Manual de usuario

Carrier

Carrier 33ZCFANTRM Dimensiones y guía de instalación

Carrier

Carrier RTU Open v5 Manual de instalación

Carrier

Carrier SYSTEM PILOT 33PILOT-01 Manual de usuario

Carrier

Carrier 33ZCFANCOL Manual de instalación

Carrier

Carrier 3V VVT 33ZCVVTZC-01 Manual de instalación

Carrier

Carrier 42C Series Instrucciones y recetas

Carrier

Carrier RTU OPEN 11-808-427-01 Manual de instalación

Carrier

Carrier CRDISKIT001A00 Manual de usuario

Carrier

Carrier Infinity SYSTXCCUID01-A Manual de usuario

Carrier

Carrier 40VCI57FQEE Instrucciones de instalación

Carrier

Carrier Type C Manual de usuario

Carrier

Carrier MINIMUM LOAD CONTROL ACCESSORY 30XA080-500 Manual de usuario

Carrier

Carrier 30WI Manual de usuario

Carrier

Carrier VVT Bypass Manual de instalación

Carrier

Carrier 40BNC Manual de usuario

Carrier

Carrier D Series Manual de usuario

Carrier

Carrier CCU Manual de uso y mantenimiento

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario