CareCo Access-Tec MS09130 Manual de usuario

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

How does the Access Tec Ramp arrive?

The Access-Tec Ramp comes in 3 sizes: 5ft, 6ft and 7ft,

and they can all be assembled in the same way,

demonstrated below.

User Manual

Instruction and Assembly Manual

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Product Code: MS09130

Access-Tec Ramp with Handrail

Packaging

5 ft Access-Tec Ramp with Handrail

MS09130.5

5 ft

Product Code

Product Code: MS09130

Setup Guide

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

Parts Included:

4x Handrails

1x Ramp

8x Set Screws

8x Lock Nuts

2x Clevis Pins

4x Brackets

4x Vertical Posts

2x Allen Keys

8x 25mm Hex Bolt

16x Washers

98x Lock Washers

Fixing Kit

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

How to assemble the Access Tec Ramp:

• Firstly, turn the ramp upside down. Locate the 4 holes found on either side of the

ramp, as highlighted by the red circles.

• Slide one of the brackets onto the ramp from the corner, lining up the two holes

found on the bracket, with the two holes found in that corner of the ramp.

• The upper lip of the end of the bracket will extend into the groove under the

ramp side rail.

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

• You can then turn the ramp back over.

• Secure each bracket into place with 2x 25mm Hex Bolts, 2x Washers and 2x Lock

Washers (place the Lock Washer and then the Washer onto each Hex Bolt

before screwing in).

• The bolts can be tightened with the Allen key supplied in the kit.

• Repeat this process for all four brackets at every corner of the ramp.

• Next, you want to attach the 4x vertical posts.

• Attach the vertical post onto the ramp, by sliding the holes at the bottom of the post

through the studs on the outside of the ramp.

• Secure this with 2x Washers and 2x Lock nuts, using a 13mm socket.

• Repeat this process for all four vertical posts at each corner.

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

• Once the vertical posts are secured, you need to attach the handrails.

• First, remove the end caps so that the handrails can fit through the holes in the

vertical posts (IMG 1).

• The handrails should then be able to slide through, and can be secured by placing

the cap back onto the end (IMG 2).

• Repeat this so that there is an upper and lower hand rail on both sides of the ramp.

• Finally, to secure the handrails in place, fasten with the set screws as

displayed above.

IMG 1 IMG 2

www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

Fastening the ramp to the landing:

• Place the ramp’s top lip

transition plate so it extends

onto the landing as far

as possible.

If using wooden landing:

• Fasten the top lip transition plate by installing one ¼ “x1” long self-drilling, stainless

steel wood screw (not supplied) through each hole.

If using a concrete landing:

• Use two pre-drilled holes in the top lip as a template to mark the positions to drill.

Using a ¼ masonry bit, drill two holes at the market locations. Drill to a depth

specified by the pin anchor manufacturer’s instructions.

• Use the two pre-drilled holes in the top lip transition plate as a template to mark the

positions and drill two ¼ holes at least 1 ½ deep.

• After drilling, make sure that holes are free of any residue and/or debris.

• Insert the clevis pins (shown below) into the drilled holes through the holes in the

top lip transition plate.

Tabla de contenidos

Otros manuales de Ayuda a la movilidad de CareCo

CareCo

CareCo MS05016 Manual de usuario

CareCo

CareCo PRIMA WA04032 Manual de usuario

CareCo

CareCo iCONNECT STEALTH Manual de usuario

CareCo

CareCo GoodKnight BD06023 Manual de usuario

CareCo

CareCo TANDEM DUO 2.0 Manual de usuario

CareCo

CareCo BA07036 Manual de usuario

CareCo

CareCo Breeze 8 II Manual de usuario

CareCo

CareCo Pano 2.0 Manual de usuario

CareCo

CareCo Breeze 8 Manual de usuario

CareCo

CareCo Burly Manual de usuario

CareCo

CareCo FRONTIER MS01010033.TIM Manual de usuario

CareCo

CareCo Pano Walker Manual de programación

CareCo

CareCo ProLite Carbon X Manual de usuario

CareCo

CareCo Orbit WA01060 Guía del usuario

CareCo

CareCo BA09023 Manual de usuario

CareCo

CareCo ProLite NERO SPORT Manual de usuario

CareCo

CareCo SAMBA DUO Manual de usuario

CareCo

CareCo Sanandres Guía del usuario

CareCo

CareCo WA01057 Guía del usuario

CareCo

CareCo Deluxe Duo Manual de programación

CareCo

CareCo Kona Guía del usuario

CareCo

CareCo DL06107 Manual de usuario

CareCo

CareCo Evo Guía del usuario

CareCo

CareCo proLite VISAGE Manual de usuario

Manuales populares de Ayuda a la movilidad de otras marcas

Alber

Alber Scalamobil iQ Manual de usuario

Ferno

Ferno CCT-PX Manual de usuario

HEPRO

HEPRO Gripo Manual de usuario

Otto Bock

Otto Bock Pheon 3R62 Manual de usuario

NRS Healthcare

NRS Healthcare M11090 Manual de usuario

Medline

Medline MDS86835DSHEC Guía de instalación

Guldmann

Guldmann Twin Turner II Manual de usuario

Drive

Drive ROOMBA Manual de usuario

Gate

Gate Balder Manual de usuario

Decon wheel

Decon wheel TNS Notos Manual de usuario

ExoAtlet

ExoAtlet ExoAtlet-II Manual de usuario

Invacare

Invacare Storm Series Manual de instrucciones

Rhythm Healthcare

Rhythm Healthcare B3800F Manual de usuario

AMF-BRUNS

AMF-BRUNS PROTEKTOR Manual de usuario

Drive DeVilbiss Healthcare

Drive DeVilbiss Healthcare OTTER Manual de usuario

Rhythm Healthcare

Rhythm Healthcare C500U Manual de usuario

Lumex

Lumex RJ4200A Manual de usuario

Rebotec

Rebotec Jumbo Manual de usuario