Caraudio-Systems V5-NBT Manual de usuario

Version 21.12.2016 V5-NBT

v.LOGiC Intelligent Solution

Interface

V5-NBT

compatible with the F-series BMW with

navigation system or radio and 6.5”, 7”, 8.8” or

10.25” monitor with 4+2pin HSD2 LVDS

connector

Version 21.12.2016 V5-NBT

Page1

Product features

Own on-screen display and setup

Rear-view camera input

Automatic switching to rear-view camera input on engagement of reverse gear from

all operation modes

Front camera input

Manual switching to rear-view camera (only for vehicles with PDC button)

Manual return from rear-view and front camera (cancellation of automatic switching)

2 trigger outputs (+12V max. 1A), separately adjustable switching events (CAN, ACC,

camera, reverse gear)

Picture-in-picture mode combining after-market rear-view and front camera

picture(s) with factory parking sensor graphics

Interactive lane lines

Compatible with all factory video accessories (e.g. rear-view camera, Top-View,

nightvison, DVD-changer, TV-tuner)

USB update-port for software-updates by consumer

Version 21.12.2016 V5-NBT

Page2

Contents

1. Prior to Installation

1.1. Delivery contents

1.2. Check compatibility of vehicle and accessories

1.3. Setting the dip switches of the interface-box V5C-M637

1.4. LED’s of the interface-box V5C-M637

2. Connection schema

3. Installation

3.1. Connecting interface-box and harnesses

3.2. LVDS connection

3.2.1. After-market front camera

3.2.1.1. Connection to the after-market front camera

3.2.1.2. Settings for connecting an after-market front camera

3.2.2. After-market rear-view camera

3.2.2.1. Connection to the after-market rear-view camera

3.2.2.2. Settings for connecting an after-market rear-view camera

3.2.2.3. Settings for OEM rear-view camera

3.2.3. After-market navigation

3.2.4. Configurable trigger outputs

3.3. Interactive lane lines

3.4. Picture settings

4. Operation

4.1. OSD –On-screen display

4.1.1. OSD –Operation

4.1.1.1. iDrive High

4.1.1.2. iDrive Low

4.1.2. iDrive selection

4.1.3. OSD –Additional setting options

4.2. Video-in-motion function

4.3. Selecting the interface as current video source

5. Specifications

6. Connections (interface-box)

7. Technical support

Version 21.12.2016 V5-NBT

Page3

Legal Information

By law, watching moving pictures while driving is prohibited, the driver must not be

distracted. We do not accept any liability for material damage or personal injury resulting,

directly or indirectly, from installation or operation of this product. This product should only

be used while standing or to display fixed menus or rear-view-camera video when the

vehicle is moving, for example the MP3 menu for DVD upgrades.

Changes/updates of the vehicle’s software can cause malfunctions of the interface. We

offer free software-updates for our interfaces for one year after purchase. To receive a free

update, the interface must be sent in at own cost. Labor cost for and other expenses

involved with the software-updates will not be refunded.

Version 21.12.2016 V5-NBT

Page4

1. Prior to installation

Read the manual prior to installation. Technical knowledge is necessary for installation. The

place of installation must be free of moisture and away from heat sources.

1.1. Delivery contents

1.1. Check compatibility of vehicle and accessories

Interface-box

V5C-M637

HW_____ SW_____

Take down the SW-version and HW-version of the interface boxes, and store this

manual for support purposes.

Requirements

Navigation F-series with navigation system or radio with 6.5”, 7”, 8.8“ or

10.25“ monitor with 4+2pin HSD2 LVDS connector

Note ”PDC – picture in picture” and “interactive lane lines” function is

not simultaneously usable

V5C-UNI01

harness

LVDS cable

CAB-HSD2-RR148

Version 21.12.2016 V5-NBT

Page5

1.2. Setting the dip switches of the interface-box V5C-M637

Dip 1 and 2 on the back of the interface-box V5C-M637 are used to set the monitor type. The

default setting is:

Vehicle/ navigation

Dip 1

Dip 2

Dip 3

6.5“ monitor.

OFF

No function

7“ monitor

OFF

No function

8.8“ monitor

OFF

No function

10.25“ monitor (ver.1)

OFF

No function

10.25“ monitor (ver.2)

No function

After each change of the dip switch settings you have to execute a power reset of the

interface-box!

1.3. LED‘s of the interface-box V5C-M637

Validinput source

CAN ok

Power

Version 21.12.2016 V5-NBT

Page6

2. Connection schema

Rear-view

camera

Interface-box

V5C-M637

FRONT

Frontcamera

Quadlock female

vehicle harness

Masse

+12V

CAN(2)

+12Vswitching

outputs

Rear gear signal

input (+12V)

V5C-UNI01

harness

CAN(1)

Quadlock male

onrear site of

the NBTunit

Version 21.12.2016 V5-NBT

Page7

Interface-box

V5C-M637

FRONT

4+2PinHSD2

LVDSfemale

vehicle harness

Backof factory

monitor

LVDScable

CAB-HSD2-RR148

Version 21.12.2016 V5-NBT

Page8

3. Installation

Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent

12V source. If according to factory rules disconnecting the battery is to be avoided, it is

usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show

success, disconnect the battery with a resistor lead.

If power source is not taken directly from the battery, the connection has to be checked

for being start-up proven and permanent.

Prior to wire and device installation we suggest to connect and test correct function of all

after-market and factory infotainment equipment!

The interface is installed on the backside of the head unit.

3.1. Connecting interface-box and harnesses

CAN-LOW(2)

Interface-box

V5C-M637

FRONT

Quadlock female

vehicle harness

Ground

+12V

CAN-HI(2)

V5C-UNI01

harness

CAN-HI(1)

CAN-LOW(1)

Quadlock maleon

rear side of the

HeadUnit

Cut off the 8 pin Molex connector from V5C-UNI01

harness (is not needed).

Version 21.12.2016 V5-NBT

Page9

Cut the CAN bus wires of the vehicle harness and connect them in series according to

the pin assignment (see below) with the CAN bus wires from the V5C-UNI01 harness.

Connect red wire with +12V (pin 15) and black wire with ground (pin 12).

Connect female 12pin AMP connector of the harness V5C-UNI01 to the

front site of the V5C-M637 interface box.

Connect the female Quadlock connector of the vehicle harness on the rear side of the

head unit.

Pin assignment:

Cable colour

Assignment

●Red

+12V permanent input - Pin15

●Black

Ground - Pin 12

●●Yellow/Black

CAN HIGH Pin 11 - to the vehicle side

●●Blue/Black

CAN LOW Pin 9 - to the vehicle side

● Yellow

CAN HIGH Pin 11 - to the head-unit side

●Blue

CAN LOW Pin 9 - to the head-unit side

●Green

+12V power output

●Pink

+12V power output

●White

Rear gear signal input (+12V)

Quadlock

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Caraudio-Systems

Caraudio-Systems

Caraudio-Systems RL-LR17-TF Manual de usuario

Caraudio-Systems

Caraudio-Systems AC-AUX-FM Manual de usuario

Caraudio-Systems

Caraudio-Systems TF-LR15 Manual de usuario

Caraudio-Systems

Caraudio-Systems blueLOGiC BT-AU02 Manual de usuario

Caraudio-Systems

Caraudio-Systems CI-TF-NTG5 Manual de usuario

Caraudio-Systems

Caraudio-Systems r.LiNK RL-FD79-TF Manual de usuario

Caraudio-Systems

Caraudio-Systems z.LiNK ZL-MFD1 Manual de usuario

Caraudio-Systems

Caraudio-Systems V5-CIC-F Manual de usuario

Caraudio-Systems

Caraudio-Systems r.LiNK RL-PCM3-TF Manual de usuario

Caraudio-Systems

Caraudio-Systems V5-CIC-E Manual de usuario

Caraudio-Systems

Caraudio-Systems TF-UCON52 Manual de usuario

Caraudio-Systems

Caraudio-Systems USB-C25 Manual de usuario

Caraudio-Systems

Caraudio-Systems TV-Free TF-NTG5 Manual de usuario

Caraudio-Systems

Caraudio-Systems MD-VW01 Manual de usuario

Caraudio-Systems

Caraudio-Systems TF-NTG3 Manual de usuario

Caraudio-Systems

Caraudio-Systems r.LiNK RL-PCM3-2-TF Manual de usuario

Caraudio-Systems

Caraudio-Systems C2-MK-CD Manual de usuario

Caraudio-Systems

Caraudio-Systems OBD-ASK-CDC Series Manual de usuario

Caraudio-Systems

Caraudio-Systems RL-MZ72D Manual de usuario

Caraudio-Systems

Caraudio-Systems OBD-CCC-CDC-01 Manual de usuario

Caraudio-Systems

Caraudio-Systems c.LOGiC C1-PHAETON Manual de usuario

Caraudio-Systems

Caraudio-Systems TF-LR17 Manual de usuario

Caraudio-Systems

Caraudio-Systems TV-Free TF-MFD2 Manual de usuario

Caraudio-Systems

Caraudio-Systems usbLOGiC USB-E65-TV Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario