Canon Paper Craft Manual de usuario

Mountain fold (dotted line)

Make a mountain fold.

Valley fold (dashed and dotted line)

Make a valley fold.

Cut line (solid line)

Cut along the line.

Cut in line (solid line)

Cut along the line.

Tools

Scissors, glue, ruler, tweezers, pencil

![Caution] Glue, scissors and other tools may be dan-

gerous to young children so be sure to keep them out of

the reach of young children.

Assembly Instructions

Try to avoid bending the parts when you cut them out.

When assembling the parts, follow the assembly in-

structions and use the parts in the order given.

When sticking surfaces together, spread the glue evenly

and stick the parts together quickly and line up the

edges cleanly. While the glue is drying, put the fuse-

lage inside a sheet of paper and then press it down with

a book or similar in order to get a nice, straight finish.

When sticking the right and left wings together, make

sure that the center line is not off center.

Center line

To glue the wings flush onto the fuselage, use a pencil

or scissors to flatten out the part where the wings at-

tach to the fuselage.

Rub with pencil or scissors

to flatten out.

Flatten the uneven surface.

Cross section of the fuselage

To give the wings an angle, bend along a straight

ruler. (Refer to the assembly instructions for details on

what degree of angle to use.)

Dihedral angle

Attach the wings and horizontal stabilizer carefully so

that their center lines match up exactly with the center

line of the fuselage.

Make sure that the center line of

the wings matches up exactly

with the center line of the fuselage.

Also attach the horizontal stabilizer firmly.

Arrow points forward.

If any of the cut out parts are bent, this will seriously

affect the glider's performance. Therefore, be sure to

keep all parts perfectly flat till you join them up. For

the wings, stabilizer and other parts, use a ruler to

give you a proper straight edge to make your folds.

Align the parts

against a ruler to fold them.

Points to note when making the glider

http://www.canon.com/c-park/en/

- 1 -

Flying-Boat: Assembly Instructions

8mm approx.

(1/3")

Fold all tabs outward.

Aligning the noses flush,

glue

through

together

in the order shown.

Assemble the sponson. (Sponson: a projection on the side of the fuselage.)

Arrow points forward.

Arrows point forward.

Fuselage

Placing a ruler along the dashed line on both edges

of the main wing (

), bend the strips upward

to make a dihedral angle of 10˚.

Glue the main wing firmly to the fuselage.

Camber the main wing (

)

after the curve of its gluing position on the fuselage.

Glue

to the upperside of

aligning the dashed line

on both edges of

. When dry, cut off the protruding portions.

Glue the horizontal stabilizer

to the fuselage.

Glue the sponson

to the printed box on the left side

of the fuselage. Glue the sponson

to the printed box

on the right side of the fuselage.

View the fuselage from the front. Before the glue dries thoroughly,

fix the sponsons

and

to ensure that they are glued horizontally.

Insert a pencil into the sponson and swell it

again to make it into a streamline shape.

Fold all tabs on

. Swell the inside of the two folds of

Then spread glue on the shaded portion

as shown in the figure and glue the part

together to complete its bag shape.

Assemble part

in the same manner.

GLUING INSTRUCTIONS

Glue the parts together in the order indicated.

- 2 -

Flying-Boat: Assembly Instructions

10˚

Using the engine installation lines and cuts on the main

wing as a guide, glue the four engines to the main wing.

Adjust the camber of both the main wing

and the wing tips carefully with your fingers.

Using the dihedral angle gauge, make sure

the dihedral angle for the main wing is 10˚.

View the plane from both the front and the back

and straighten any warps or bends in the fuselage

and the wings.

Camber the wing tips carefully.

Camber the wing carefully.

Dot towards the front.

According to the curve of the gluing position

for the main wing on the fuselage,

camber the main wing (

) evenly up

to both edges. Make sure that the dihedral

angle for the folded tabs are 10˚.

Camber both wing tips

and

equally to the main wing.

Apply glue to the top surface of the folded tabs of the

main wing and attach wing tips

and

respectively.

Before it dries, adjust the dihedral angles of

and

to 10˚. (Use the dihedral angle gauge.)

Fold the tabs on

through

Glue together

and

to make four engines.

FINISHING TOUCHES

Give the finishing touches to the plane after it dries thoroughly.

- 3 -

Flying-Boat: Assembly Instructions

Otros manuales de Juguete de Canon

Canon

Canon CREATIVE PARK Five-storied pagoda of Horvuji Temple,... Manual de usuario

Canon

Canon PaperCraft Gift Box E Manual de usuario

Canon

Canon Paper Craft Tower Bridge England Manual de usuario

Canon

Canon Creative Park Church of the Transfiguration Manual de usuario

Canon

Canon Paper Craft Emperor Penguin Manual de usuario

Canon

Canon CREATIVE PARK Moving Money Box: Pig Manual de usuario

Canon

Canon Paper Craft Catcher Manual de instrucciones

Canon

Canon Creative Park Shaky-Shaky Maracas Manual de usuario

Canon

Canon Creative Park Mallet of Luck Manual de usuario

Canon

Canon Creative Park Football Money Box Guía de inicio rápido

Canon

Canon CREATIVE PARK Bottlenose Dolphin Manual de usuario

Canon

Canon Floral Teddy Bear Manual de usuario

Canon

Canon Creative Park Matryoska doll Manual de usuario

Canon

Canon CREATIVE PARK Paper Copter Manual de usuario

Canon

Canon PaperCraft White striped longhorn beeetle Manual de usuario

Canon

Canon Creative Park Veiled chameleon Manual de usuario

Canon

Canon Supersaurus Manual de usuario

Canon

Canon CREATIVE PARK Zebra Manual de usuario

Canon

Canon Sidewheeler Guía de configuración

Canon

Canon Creative Park Miniature Pig Manual de usuario

Canon

Canon Racer 539 Hawk Manual de usuario

Canon

Canon CREATIVE PARK Manta ray Manual de usuario

Canon

Canon CREATIVE PARK (Moving) Performing white... Manual de usuario

Canon

Canon CREATIVE PARK Shoebill Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario

Mattel

Mattel HOTWHEELS DWL04 Manual de usuario