Canon Racer 539 Hawk Manual de usuario

Mountain fold (dotted line)

Make a mountain fold.

Valley fold (dashed and dotted line)

Make a valley fold.

Scissors line (solid line)

Cut along the line.

Cut in line (solid line)

Cut along the line.

Tools

Scissors, glue, ruler, tweezers, pencil

![Caution] Glue, scissors and other tools may be dan-

gerous to young children so be sure to keep them out of

the reach of young children.

Assembly Instructions

Try to avoid bending the parts when you cut them out.

When assembling the parts, follow the assembly in-

structions and use the parts in the order given.

When sticking surfaces together, spread the glue evenly

and stick the parts together quickly and line up the

edges cleanly. While the glue is drying, put the fuse-

lage inside a sheet of paper and then press it down with

a book or similar in order to get a nice, straight finish.

When sticking the right and left wings together, make

sure that the center line is not off center.

C enter line

To glue the wings flush onto the fuselage, use a pencil

or scissors to flatten out the part where the wings at-

tach to the fuselage.

Rub with pencil or scissors

to flatten out.

Flatten the uneven surface.

C ross section of the fuselage

To give the wings an angle, bend along a straight

ruler. (Refer to the assembly instructions for details on

what degree of angle to use.)

Dihedral angle

Attach the wings and horizontal stabilizer carefully so

that their center lines match up exactly with the center

line of the fuselage.

Make sure that the center line of

the wings matches up exactly

with the center line of the fuselage.

Also attach the horizontal stabilizer firmly.

Arrow points forward.

If any of the cut out parts are bent, this will seriously

affect the glider's performance. Therefore, be sure to

keep all parts perfectly flat till you join them up. For

the wings, stabilizer and other parts, use a ruler to

give you a proper straight edge to make your folds.

Align the parts

against a ruler to fold them.

Points to note when making the glider

http://www.canon.com/c-park/en/

- 1 -

Racer 539 Hawk: Assembly Instructions

Assemble the main wing

following the assembly

instructions 3-1 to 3-8.

Glue the main wing firmly to

the fuselage, aligning the

center of the wing along the

top of the fuselage.

5˚

Dot towards the front.

G lue

Folded stands

Fold all tabs outward.

Aligning the noses flush,

glue

through

together

in the order shown.

Placing a ruler along the fold lines, bend the cut

strips slightly upward.

Glue parts

and

to the underside of

parts

and

respectively.

Using a ruler along the center line, fold part

from the

center line to make 5˚ angle on both sides. Then curve it

carefully with your fingers to fit the curved fuselage top

where the main wings are to be attached.

Curve the main wings,

respectively in the same manner as

This curve is called camber.

Apply glue on half of the underside

and glue onto

(The dots on the parts should meet

with each other.)

In the same manner,

attach

to the other

side of

Glue the horizontal stabilizer

to the fuselage, making sure that

the dots appearing in its center

portion line up along the top of

the fuselage.

Placing the dihedral angle gauge on the main wing,

check that the dihedral angle is 5˚.

Putting folded stands under the main wing

will be conducive to fast and thorough drying.

GLUING INSTRUCTIONS

Glue the parts together in the order indicated.

- 2 -

Racer 539 Hawk: Assembly Instructions

View the plane from both the front and the back

and straighten any warps or bends

in the fuselage and the wings.

5˚5˚

30˚

C amber the wing tips carefully.

C amber the wings carefully.

Dot towards the front.

Level the camber on the main wings carefully

with your fingers, checking the curve

with the camber gauge.

Using the dihedral angle gauge,

make sure the dihedral angle for the main

wing is 5˚ and for the wing tips is 30˚.

Camber both wing tips

and

slightly.

Fold tabs on both ends of the main wing to form a 30˚ dihedral angle

using the gauge and then camber them as well.

Apply glue to the top surface of the folded tabs of the main wing.

Glue wing tips

and

onto them as shown.

Once again, check that the dihedral angle at the tip of the wing is 30˚

using the gauge.

FINISHING TOUCHES

Give the finishing touches to the plane

after it dries thoroughly.

- 3 -

Racer 539 Hawk: Assembly Instructions

Otros manuales de Juguete de Canon

Canon

Canon CREATIVE PARK Fractional Cake Manual de usuario

Canon

Canon CREATIVE PARK Manta ray Manual de usuario

Canon

Canon Creative Park JAGUAR XKR Manual de usuario

Canon

Canon Paper Craft Emperor Penguin Manual de usuario

Canon

Canon creative park Manual de usuario

Canon

Canon Paper Craft Special Vehicle 01 Series Manual de usuario

Canon

Canon CREATIVE PARK (Moving) Clowns out of a... Manual de usuario

Canon

Canon Creative Park Shaky-Shaky Maracas Manual de usuario

Canon

Canon Creative Park Caribbean flamingo Guía de inicio rápido

Canon

Canon Creative Park Cube Perpetual Calendar Monkey Manual de usuario

Canon

Canon Sidewheeler Guía de configuración

Canon

Canon Supersaurus Manual de usuario

Canon

Canon Creative Park Clowns on funny unicycles Manual de usuario

Canon

Canon Creative Park Nikko Toshogu Shrine Yomeimon Manual de usuario

Canon

Canon Creative Park Performing white horses Manual de usuario

Canon

Canon CREATIVE PARK Pop-up ABC QRSTUVWX Manual de usuario

Canon

Canon Paper Craft Hercules Beetle Manual de usuario

Canon

Canon Creative Park Budgerigar Manual de usuario

Canon

Canon Creative Park Elastic-powered Duck Manual de usuario

Canon

Canon CREATIVE PARK 3D Paper Mosaic (Tropical... Manual de usuario

Canon

Canon Creative Park Paper Aquarium Clown Fish Manual de usuario

Canon

Canon Creative Park Leaping Goat Pattern Manual de usuario

Canon

Canon Paper Craft Castel Sant'Angelo Italy Manual de usuario

Canon

Canon Creative Park Rabbit Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario

Mattel

Mattel HOTWHEELS DWL04 Manual de usuario