Caframo Pali 9510CA-BBX Manual de usuario
3
IMPORTANT - READ AND SAVE THESE INSTRUCTIONS!
Thank you for purchasing Pali, the Caframo Marine 400W Engine Compartment Heater.
Pali is designed to maintain the temperature in your engine compartment above freezing,
preventing damage from a sudden cold snap.
SAFETY WARNINGS
This heater is intended for use solely as a marine engine compartment heater. This heater
is not to be used for any other applications such as room heating.
INSTALLATION/ MOUNTING
While boat is in motion the Pali must be secured to the mounting bracket.
1. Vertical Secured Mount
Separate the Quick Mount Bracket from
the heater. Using a minimum of 4 screws*,
securely attach the Quick Mount Bracket
directly to the bulkhead of the vessel
within the engine compartment.
OPERATION
Pali 9510 (Automatic Thermostat)
The Pali 9510 automatically cycles ON/OFF to regulate and maintain desired
temperature. Connect the Pali 9510 to the secured Quick Release Bracket or lay it
collect water. Plug the heater into the appropriate 120V outlet. The LED will become
green once your unit is plugged in, indicating the unit has power and is ready to operate.
The Pali 9510 will automatically activate when the engine compartment ambient
temperature drops to 41°F (5°C). The LED will become red indicating the unit is
now running.
Pali is designed to continuously protect up to an 80 ft³ engine compartment at -4°F (-20°C)
outside temperature.
2. Horizontal Use Un-secured
(Ensure boat is motionless when using
this option.) Pali can be used without
mounting the unit to the bulkhead or engine
any dry surface.
* SCREWS NOT SUPPLIED
4
TESTING
There are 2 methods to test the functionality of the automatic Thermostat:
1. Freeze Spray: Plug heater into wall outlet, ensure green LED is on. Direct and spray
(for up to 10 seconds) a general purpose freeze spray coolant for electrical components
at the Test Target Area (A) marked on the inner rim of the air intake. Depending on
the ambient temperature as well as the temperature of the heater this may take a few
attempts. There may be residue left by the freeze which can be wiped off with a clean
cloth. NOTE: The spray used must be certified electrical safe and non-flammable.
(A)
2. Freezer Test: Ensure the Pali is unplugged and cooled down. Place the heater in a
plastic bag and into a freezer. This will lower the temperature of the thermostat. After 2
hours, remove the Pali from the freezer, remove plastic bag and plug in. The heater will
automatically activate indicated by the LED turning red.
CARE AND MAINTENANCE
The Pali requires very little maintenance. By following the instructions within this
manual the heater will operate problem-free for years.
Unplug unit before cleaning. A vacuum can be used to clear the heater of any dust build-
up and a dry cloth may be used to wipe the outer surface.
Do not attempt to open the unit to clean.
Certified to:
UL-499
Electric Heating
Appliances
C22.2 No. 191
Electric Heaters and
Battery Warmers
Independently tested to meet:
MIL-SPEC
810E: 514.6, 501.5, 502.5, 507.5
Vibration, High, Low Temperatures,
Humidity
UL-1500
Ignition Protection
USCG
Ignition Protection Guidelines
5
Important Instructions
When using electrical appliances, basic precautions should always be followed to reduce
1. SAVE THESE INSTRUCTIONS.
2. Read all instructions before using the heater.
3. Caution: High temperature. This heater is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains at least 3 feet from the front of the
heater and away from the sides and rear.
4. Extreme caution is necessary when any heater is used by or near children or
disabled persons.
5. Always unplug heater when not in use.
6. Do not operate any heater with a damaged cord, plug or after the heater
malfunctions, has been dropped or damaged in any manner.
7. Do not use outdoors where heating unit can be exposed to the elements and come in
contact with moisture.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bathtub or other water
container.
9. Never locate heater where it may come into contact with water.
10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the
11. To disconnect heater, remove plug from electrical outlet.
12. Only connect heater to a properly grounded 3 prong electrical outlet which meets
the electrical ratings as marked on the heater.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
14. Use this heater only as described in this manual. Any other use not recommended
15. The heater must not be located immediately below a socket-outlet.
Product Features
Features Description
Ignition Protected
Design
No electrical arcing and retains core temperature below
auto-ignition temperature of fuel fumes.
Safe Self-Regulated
PTC Heaters
PTC heaters do not overheat ensuring additional safety
around fumes.
Impinged Forced Air
Technology
engine compartment.
Redundancy
Two fans are used instead of one for added security in the
event of single fan failure.
Discharge
This allows for better thermal mixing of the engine
compartment air resulting in more uniform heating
throughout the engine compartment.
Safe Thermostat
Temperature Control
A hermetically sealed thermostat activates at 41°F (5°C).
This ensures that the coldest locations in compartment
components do not drop below zero. The heater will turn
off when the temperature reaches 59°F (15°C).
LED - Indicator LED will glow green to indicate power to the Pali. Once
thermostat activates LED will glow red indicating heat.
20’ Heater Grade Power
Cord
Extra long power cord included to plug in at shore lines or
weather resistant.
Small Foot Print
compartment’s tight corners.
Quick Release Bracket A mounting bracket with a positive lock can be quickly
removed for off season storage.
Model 9510CABBX
Dimensions: 9” (w) x 5” (h) x 5” (d),
Weight: 4.75 lbs.
Power: 120V AC, 60Hz, 400W (1365 BTU/Hour)
Draw: (Start-up: 9A), (Running: 3.4A)
Cord: 20’, 18AWG Heater Grade Cord (Oil and water resistant)
Discover other boat hatches and ventilation on our website.
Otros manuales para Pali 9510CA-BBX
3
Tabla de contenidos
Otros manuales de Calentador de Caframo
Caframo
Caframo TRUE NORTH 9206 Manual de usuario
Caframo
Caframo Cabinet Heater 9421CA Manual del propietario
Caframo
Caframo Pali 9510CA-BBX Manual de usuario
Caframo
Caframo TRUE NORTH 9206 Manual de usuario
Caframo
Caframo 7802CA-GBX Manual de usuario
Caframo
Caframo 9421 Manual de usuario
Caframo
Caframo Low Profile Space Heater 9206CA-BBX Manual del propietario
Caframo
Caframo HOTSPOT 9316CABBX Manual de usuario
Caframo
Caframo Pali 9510CA-BBX Manual de usuario
Caframo
Caframo Pali 9510CA-BBX Manual de usuario
Manuales populares de Calentador de otras marcas
Empire Heating Systems
Empire Heating Systems WCC65 Manual de usuario
Wetekom
Wetekom 92 86 43 Manual de usuario
Desa
Desa SPC170-F Manual de usuario
Watlow
Watlow Watrod Electric Tubular Heaters Manual de usuario
Haverland
Haverland ECO-DRY GPS Series Manual de lista de piezas
Stelpro
Stelpro ASILVC2060 Series Manual de usuario