Cabletron Systems MMAC-Plus 9F116-01 Manual de usuario

SmartSwitch 9000

9F116-01 User’s Guide

9031184-01

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information

contained in this document without prior notice. The reader should in all cases consult Cabletron

Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALLCABLETRON SYSTEMS BE LIABLE FOR ANYINCIDENTAL, INDIRECT,

SPECIAL, OR CONSEQUENTIALDAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED

TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUALOR THE INFORMATION

CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR

SHOULD HAVE KNOWN, THE POSSIBILITYOF SUCH DAMAGES.

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

Printed in the United States of America

Order Number:9031184-01

LANVIEW

is a registered trademark, and

SmartSwitch

is a trademark of Cabletron Systems, Inc.

CompuServe

is a registered trademark of CompuServe, Inc.

i960 microprocessor

is a registered trademark of Intel Corp.

Ethernet

is a trademark of Xerox Corporation.

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a Class Adigital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environment.

This equipment uses, generates, and can radiate radio frequency energy and if not installed in

accordance with the operator’s manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause interference in which case the user

will be required to correct the interference at his own expense.

WARNING:

Changes or modiﬁcations made to this device which are not expressly approved by the

party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This is a Class Aproduct based on the standard of the Voluntary Control Council for Interference by

Information Technology Equipment (VCCI). If this equipment is used in a domestic environment,

radio disturbance may arise. When such trouble occurs, the user may be required to take corrective

actions.

DOC Notice

This digital apparatus does not exceed the Class Alimits for radio noise emissions from digital

apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class Aprescrites dans le Règlement sur le brouillage radioélectrique

édicté par le ministère des Communications du Canada.

iii

Notice

DECLARATION OF CONFORMITY

ADDENDUM

Application of Council Directive(s):

89/336/EEC

73/23/EEC

Manufacturer’s Name:

Cabletron Systems, Inc.

Manufacturer’s Address:

35 Industrial Way

PO Box 5005

Rochester, NH 03867

European Representative Name:

Mr. J. Solari

European RepresentativeAddress:

Cabletron Systems Limited

Nexus House, Newbury Business Park

London Road, Newbury

Berkshire RG13 2PZ, England

Conformance to Directive(s)/Product Standards:

EC Directive 89/336/EEC

EC Directive 73/23/EEC

EN 55022

EN 50082-1

EN 60950

Equipment Type/Environment:

Networking Equipment, for use in a

Commercial or Light

Industrial Environment.

We the undersigned, hereby declare, under our sole responsibility, that the equipment packaged with

this notice conforms to the above directives.

Manufacturer Legal Representative in Europe

Mr. Ronald Fotino Mr. J. Solari

____________________________________________________ ______________________________________________________

Full Name Full Name

Principal Compliance Engineer Managing Director - E.M.E.A.

____________________________________________________ ______________________________________________________

Title Title

Rochester, NH, USA Newbury, Berkshire, England

____________________________________________________ ______________________________________________________

Location Location

Notice

Contents

Chapter 1 Introduction

Features...........................................................................................................................1-1

Related Manuals............................................................................................................1-4

Getting Help .................................................................................................................. 1-4

Chapter 2 Installing the MicroLAN Modules

The Reset Switch ...........................................................................................................2-3

User-Accessible Components......................................................................................2-4

Setting the Module Card DIP Switch......................................................................... 2-5

Installing an FPIM.........................................................................................................2-7

Chapter 3 Operation

Flexible Network Bus (FNB)........................................................................................3-1

System Management Buses .........................................................................................3-2

SMB-1 Bus...............................................................................................................3-2

SMB-10 Bus.............................................................................................................3-2

System Diagnostic Controller...................................................................................... 3-2

DC/DC Converter ........................................................................................................3-3

FNB Interface.................................................................................................................3-3

i960 Core.........................................................................................................................3-3

Chapter 4 LANVIEW LEDs

Chapter 5 General Speciﬁcations

Safety...............................................................................................................................5-1

Service............................................................................................................................. 5-1

Physical...........................................................................................................................5-2

Dimensions:............................................................................................................ 5-2

Weight:.....................................................................................................................5-2

Appendix A FPIM Speciﬁcations

FPIM-00 .........................................................................................................................A-1

FPIM-02 and FPIM-04..................................................................................................A-2

FPIM-05 .........................................................................................................................A-3

Contents

1-1

Chapter 1

Introduction

The 9F116-01 MicroLAN™ Module (shown in Figure 1-1) is a two port FDDI

bridge/router used to connect an external FDDI network to one of the two FNB

networks, FNB-1 or FNB-2, on the SmartSwitch 9000 FNB backplane. Another

conﬁguration option allows the module to bridge/route between FNB-1 and

FNB-2 on the FNB backplane. The external FDDI network connects to the 9F116-

01 using a DualAttached Station (DAS) interface on the module’s front panel. The

9F116-01 is ANSI X3T9.5-compliant with two instances of Station Management

(SMT), two instances of MAC, and four instances of PHY and PMD (two per

interface).

Features

Processor

The 9F116-01 is equipped with an advanced Intel i960 microprocessor. This

microprocessor provides a platform for all management functions within a

scalable RISC-based architecture.

System Management

The 9F116-01 interfaces to the two System Management Buses (SMB-1 and

SMB-10) for intermodule management. Management features include the

following:

• Module Insert/Bypass Control

• MAC Placement

• Station Management (SMT) Statistics

• Bridging Statistics (for all interfaces) including

- Frames Filtered

- Frames Forwarded

- All STA Parameters

Hardware Bridging Logic

Hardware frame ﬁlter/forward logic increases the bridging performance of the

9F116-01, allowing the module to achieve higher throughputs (up to 50,000

packets per second).

Introduction

1-2

SpanningTree Algorithm

The 9F116-01 supports both IEEE 802.1d and DEC Spanning TreeAlgorithm (STA)

protocols.

Connectivity

The 9F116-01 provides one FDDI dual attached connector pair from the module

front panel. This connector pair allows the 9F116-01 to act as a DAS (with two

FPIMs installed) or a SAS (with one FPIM) on the SmartSwitch 9000 FNB. The

9F116-01 has three physical FDDI interfaces (front panel, FNB-1, and FNB-2) and

allows bridging between any two of them.

FPIMs

The 9F116-01 uses FDDI Port Interface Modules (FPIMs) to provide several media

options on the front panel interfaces. These FPIMs are available in various media

types including the following:

• Multimode Fiber Optic (FDDI MIC)

• Single Mode Fiber Optic (FDDI MIC)

• Unshielded Twisted Pair (RJ-45)

• Shielded Twisted Pair (RJ-45)

LANVIEW LEDs

The 9F116-01 uses LANVIEW: the Cabletron Systems built-in visual diagnostic

and status monitoring system. With LANVIEW LEDs, you can quickly identify

the device, port, and physical layer status at a glance.

Hot Swapping

The 9F116-01 can be installed or removed from the chassis while the SmartSwitch

9000 is powered up without affecting the operation of the rest of the network.

Otros manuales para MMAC-Plus 9F116-01

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de Cabletron Systems

Cabletron Systems

Cabletron Systems MMAC-Plus 9H423-26 Manual

Cabletron Systems

Cabletron Systems HubSTACK SEHI-34 Manual de usuario

Cabletron Systems

Cabletron Systems SmartSwitch 9A100 Manual de usuario

Cabletron Systems

Cabletron Systems MMAC-Plus SFCS-1000 Hoja de instrucciones

Cabletron Systems

Cabletron Systems SmartSTACK 100 Manual de usuario

Cabletron Systems

Cabletron Systems 924TX Instrucciones de funcionamiento y mantenimiento

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-S24TX2M Manual de programación

Cabletron Systems

Cabletron Systems ELS10-26TX Manual de usuario

Cabletron Systems

Cabletron Systems SEHI-22FL Manual de usuario

Cabletron Systems

Cabletron Systems FN100 Manual de usuario

Cabletron Systems

Cabletron Systems SEHI SEHI100TX- Manual de usuario

Cabletron Systems

Cabletron Systems Spectrum 2E42-27 Manual de usuario

Cabletron Systems

Cabletron Systems TRXI-22 Manual de usuario

Cabletron Systems

Cabletron Systems SmartSwitch 8H02-16 Manual de usuario

Cabletron Systems

Cabletron Systems 9F122-12 Manual de usuario

Cabletron Systems

Cabletron Systems ESXMIM Manual de programación

Cabletron Systems

Cabletron Systems MMAC-Plus 9H531-24 Manual de usuario

Cabletron Systems

Cabletron Systems SmartSTACK ELS10-27MDU Instrucciones de instalación y funcionamiento

Cabletron Systems

Cabletron Systems MicroMMAC 22ES Manual de usuario

Cabletron Systems

Cabletron Systems CyberSWITCH CSX150 Manual de usuario

Cabletron Systems

Cabletron Systems MRXI 10BASE-T Manual de usuario

Cabletron Systems

Cabletron Systems 9F426-03 Documento técnico

Cabletron Systems

Cabletron Systems 7C04 Workgroup SmartSWITCH Manual de usuario

Cabletron Systems

Cabletron Systems MICROMMAC-22T Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario