Cabletron Systems EPIM-3PS Manual de usuario

EPIM-3PS

Installation Guide

Cabletron Systems, P.O. Box 5005, Rochester, NH 03866-5005

P/N 9031283-01

EPIM-3PS Book Page 1 Tuesday, August 18, 1998 8:42 AM

EPIM-3PS Book Page 2 Tuesday, August 18, 1998 8:42 AM

Notice

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other infor-

mationcontainedinthisdocumentwithoutpriornotice.Thereadershouldinallcasescon-

sult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without

notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, IN-

DIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING

BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS

MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYS-

TEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSI-

BILITY OF SUCH DAMAGES.

Cabletron Systems, Inc.

P.O. Box 5005

Rochester, NH 03866-5005

Printed in the United States of America

Part Number: 9031283-01 November 1994

BRIM

EPIM-3PS

EMM-E6

ESXMIM

MicroMMAC

, and

NBR-420/620

are trademarks

of Cabletron Systems, Inc.

CompuServe

is a registered trademark of CompuServe, Inc.

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

EPIM-3PS Book Page i Tuesday, August 18, 1998 8:42 AM

Notice

NOTE:

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment uses, generates, and can radiate radio frequen-

cy energy and if not installed in accordance with the operator’s manual, may cause harm-

ful interference to radio communications. Operation of this equipment in a residential area

is likely to cause interference in which case the user will be required to correct the inter-

ference at his own expense.

WARNING:

Changes or modifications made to this device which are not expressly ap-

proved by the party responsible for compliance could void the user’s authority to operate

the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian Depart-

ment of Communications.

Leprésentappareil numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de la class A prescrites dans le Règlement sur le

brouillage radioélectrique édicté par le ministère des Communications du Canada.

CABLETRON SYSTEMS, INC.

PROGRAM LICENSE AGREEMENT

IMPORTANT:

Before utilizing this product, carefully read this License Agreement.

This document is an agreement between you, the end user, and Cabletron Systems, Inc.

(“Cabletron”) that sets forth your rights and obligations with respect to the Cabletron soft-

ware program (the “Program”) contained in this package. The Program may be contained

in firmware, chips or other media.

EPIM-3PS Book Page ii Tuesday, August 18, 1998 8:42 AM

Notice

iii

BY UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME

BOUND BY THE TERMS OF THIS AGREEMENT, WHICH INCLUDES THE LICENSE

AND THE LIMITATION OF WARRANTY AND DISCLAIMER OF LIABILITY. IF YOU DO

NOT AGREE TO THE TERMS OF THIS AGREEMENT, PROMPTLY RETURN THE UN-

USED PRODUCT TO THE PLACE OF PURCHASE FOR A FULL REFUND.

CABLETRON SOFTWARE PROGRAM LICENSE

1. LICENSE. You have the right to use only the one (1) copy of the Program provided

in this package subject to the terms and conditions of this License Agreement.

You may not copy, reproduce or transmit any part of the Program except as permitted

by the Copyright Act of the United States or as authorized in writing by Cabletron.

2. OTHER RESTRICTIONS. You may not reverse engineer, decompile, or disassem-

ble the Program.

3. APPLICABLE LAW. This License Agreement shall be interpreted and governed un-

der the laws and in the state and federal courts of New Hampshire. You accept the

personal jurisdiction and venue of the New Hampshire courts.

EXCLUSION OFWARRANTY

AND DISCLAIMER OF LIABILITY

1. EXCLUSION OF WARRANTY. Except as may be specifically provided by

Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning

the Program (including Its documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED

TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUD-

ING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABLITY AND

FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM,

THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING

HARDWARE.

EPIM-3PS Book Page iii Tuesday, August 18, 1998 8:42 AM

Notice

2. NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL

CABLETRON OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEV-

ER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS,

PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION,

SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTH-

ER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS CABLETRON

PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE POSSIBILITY OF

SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION

OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAG-

ES, OR ON THE DURATION OR LIMITATION OF IMPLIED WARRANTEES IN

SOME INSTANCES THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT AP-

PLY TO YOU.

UNITED STATES GOVERNMENT RESTRICTED RIGHTS

The enclosed product (a) was developed solely at private expense; (b) contains “restrict-

ed computer software” submitted with restricted rights in accordance with Section 52227-

19 (a) through (d) of the Commercial Computer Software - Restricted Rights Clause and

its successors, and (c) in all respects is proprietary data belonging to Cabletron and/or its

suppliers.

For Department of Defense units, the product is licensed with “Restricted Rights” as de-

fined in the DoD Supplement to the Federal Acquisition Regulations, Section 52.227-7013

ject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical Data

and Computer Software clause at 252.227-7013. Cabletron Systems, Inc., 35 Industrial

Way, Rochester, New Hampshire 03867.

EPIM-3PS Book Page iv Tuesday, August 18, 1998 8:42 AM

Introduction

Page 1

Introduction

Welcome to the EPIM-3PS Installation Guide.This manual

guides you through the installation and setup of the

EPIM-3PS and includes the following sections:

• BRIM Installation Considerations

• Installing the EPIM-3PS

• Making Connections

• EPIM-3PS LEDs

BRIM Installation Considerations

You can install your EPIM-3PS in any device that supports

both BRIM and EPIM technology (e.g., EMM-E6,

MicroMMAC, ESXMIM or the NBR-420/620),

but

the

BRIM and the EPIM-3PS must go into equivalent slots in

order to be correctly recognized by local management.

Table 1 lists the EPIM-3PS and BRIM port match-ups for

the various Cabletron modules.

EPIM-3PS Book Page 1 Tuesday, August 18, 1998 8:42 AM

BRIM Installation Considerations

Page 2

Table 1. EPIM-3PS/BRIM Conﬁguration

You

must

match the BRIM slot with the correct EPIM slot.

Refer to your BRIM documentation for speciﬁc BRIM and

EPIM installation procedures.

Note

:On some devices, the EPIM slot is located

under

the

BRIM slot. In these cases, install the EPIM-3PS and

connect the internal Ethernet cable to the EPIM

before

installing the BRIM.

Cabletron

Module EPIM Slot BRIM Slot

ESXMIM EPIM Slot BRIM Slot

EMM-E6 Top EPIM Slot (1) Top BRIM Slot (E)

MicroMMAC EPIM 1 BRIM Slot on rear of

chassis

NBR 420/620 Port A (1st EPIM-3PS)

Port B (2nd EPIM-3PS)

Port E (1st BRIM)

Port F (2nd BRIM)

EPIM-3PS Book Page 2 Tuesday, August 18, 1998 8:42 AM

Installing the EPIM-3PS

Page 3

Installing the EPIM-3PS

To install the EPIM-3PS into a Media Interface Module

(MIM):

1.) Remove the mounting screw shown in Figure 1.

Note

:When removing an EPIM, be sure to pull the module

straight out to prevent damage to the connector.

2.) Remove the coverplate or the EPIM (whichever

applies).

3.) Slide your EPIM-3PS into place, making sure that the

connectors on the rear of the EPIM are fully engaged

with the connectors on the MIM.

4.) Reinstall the mounting screw.

EPIM-3PS Book Page 3 Tuesday, August 18, 1998 8:42 AM

Installing the EPIM-3PS

Page 4

Figure 1. EPIM-3PS Installation

EMM-E6

ETHERNET

STBY

RCV

XMT

CLN

D C B A

CPU

RESET

LANPWR SYS

RESET

S1 S0 CONSOLE

S1 S0

EPIM-3PS Book Page 4 Tuesday, August 18, 1998 8:42 AM

Tabla de contenidos

Otros manuales de Hardware de red de Cabletron Systems

Cabletron Systems

Cabletron Systems 6E122-26 Manual de usuario

Cabletron Systems

Cabletron Systems WPIM T1 Manual de usuario

Cabletron Systems

Cabletron Systems 3F00-01 Manual de usuario

Cabletron Systems

Cabletron Systems Spectrum EMM-E6 Instrucciones de instalación y funcionamiento

Cabletron Systems

Cabletron Systems TRMIM-10R Manual de usuario

Cabletron Systems

Cabletron Systems 9E132-15 Documento técnico

Cabletron Systems

Cabletron Systems SPECTRUM TRMMIM Manual de usuario

Cabletron Systems

Cabletron Systems W85 Manual de usuario

Cabletron Systems

Cabletron Systems BRIM-T6 Manual de usuario

Cabletron Systems

Cabletron Systems Spectrum EMM-E6 Manual de usuario

Cabletron Systems

Cabletron Systems MMAC-M8FNB Manual de usuario

Cabletron Systems

Cabletron Systems DLM6C-AA Manual de usuario

Cabletron Systems

Cabletron Systems 3Com PortSwitch Hub Manual de usuario

Cabletron Systems

Cabletron Systems Device Management Module Dec GigaSwitch Manual de usuario

Cabletron Systems

Cabletron Systems Netlink FRX4000 Manual de usuario

Cabletron Systems

Cabletron Systems MMAC-Plus 9A128-01 Manual de programación

Cabletron Systems

Cabletron Systems Netlink FRX8000 Instrucciones de montaje

Cabletron Systems

Cabletron Systems SmartSwitch 6000 Manual de programación

Cabletron Systems

Cabletron Systems ATX Manual

Cabletron Systems

Cabletron Systems TRXI-22 Instrucciones de instalación y funcionamiento

Cabletron Systems

Cabletron Systems 9E429-36 Guía de inicio rápido

Cabletron Systems

Cabletron Systems 6H133-37 Manual de usuario

Cabletron Systems

Cabletron Systems TRMIM-32A Manual de usuario

Cabletron Systems

Cabletron Systems 9A426-01 Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario