Cabela's Alaskan Guide Model Manual de usuario
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
VISIT WWW.CABELAS.COM OR CALL 1-800-237-4444 FOR ASSISTANCE.
SAVE THESE INSTRUCTIONS!
ALASKAN GUIDE MODEL®TENT
GEAR GUIDE
CABELA’S SET NUMBER: 51-7569
R
R
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. CALL 1-800-237-4444 FOR ASSISTANCE OR VISIT WWW.CABELAS.COM
2
TABLE OF CONTENTS
CABELA’S-BRAND MERCHANDISE IS GUARANTEED FOR THE LIFE OF THE PRODUCT AGAINST
DEFECTS IN WORKMANSHIP UNDER NORMAL WEAR AND TEAR CONDITIONS. SEE CABELA’S FULL
POLICY AT THE BACK OF THIS GUIDE.
PAGE 2............................................................................................................................................... TABLE OF CONTENTS
PAGE 3.............................................................................................................................................................. WARNINGS
PAGE 4............................................................................................................................................ TIPS, BEST PRACTICES
PAGE 5.............................................................................................................................................................. ASSEMBLY
PAGE 6.................................................................................................................................................... ASSEMBLY CONT.
PARTS LIST
PART NAME: TENT BODY
PART NAME: RAIN FLY
PART NAME: POLES (FIBERGLASS)
PART NAME: STAKES
PART NAME: GUY LINES
PART NAME: GEAR LOFT
PART NAME: REPAIR KIT
QTY: 1
QTY: 1
QTY: 7
QTY: 24
QTY: 16
QTY: 1
QTY: 1
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. CALL 1-800-237-4444 FOR ASSISTANCE OR VISIT WWW.CABELAS.COM3
WARNINGS
WHEN YOU SEE A “WARNING!” SIGN ( ) BE SURE TO HEED THE MESSAGE!
THE INFORMATION CONTAINED IN THESE MESSAGES MAY PREVENT INJURIES!
CABELA’S TENTS ARE EASY TO ASSEMBLE AS LONG AS YOU READ THE INSTRUCTIONS CAREFULLY AND AVOID
EXCESSIVE FORCE TO ANY PART OF THE TENT OR POLES.
FAMILIARIZE YOURSELF WITH ALL PARTS AND FULLY ASSEMBLE YOUR TENT BEFORE GOING ON YOUR FIRST
ADVENTURE.
DO NOT PITCH THE TENT OVER ROCKS, STICKS OR OTHER SHARP OBJECTS THAT COULD DAMAGE THE TENT FLOOR.
PLACING A FOOTPRINT UNDER THE TENT IS HIGHLY RECOMMENDED.
AVOID UNNECESSARY STRESS ON THE POLES. THE POLES SHOULD ONLY BE USED AS INTENDED AND NOT BENT
MORE THAN THE CURVATURE OF THE TENT. MAKE SURE JOINTS ARE FULLY ENGAGED BEFORE BENDING THE POLES.
BEWARE OF HAZARDS WHEN PICKING A TENT SITE. BEWARE OF POSSIBLE FALLING ROCKS OR TREE LIMBS,
LIGHTNING STRIKES, FLASH FLOODS, STRONG WINDS AND OTHER HAZARDS WHICH MAY CAUSE INJURY OR
DAMAGE.
DO NOT USE FUEL-BURNING DEVICES INSIDE OR NEAR THIS PRODUCT. STOVES, LANTERNS, CANDLES, HEATERS
AND OTHER FUEL-BURNING DEVICES PRODUCE CARBON MONOXIDE AND WILL CONSUME THE AVAILABLE OXYGEN
IN A TENT. USE OF SUCH DEVICES IN A TENT MAY CAUSE ASPHYXIATION, CARBON-MONOXIDE POISONING, AND
DEATH OR SERIOUS AND PERMANENT INJURY.
CABELA’S TENT FABRICS ARE FLAME-RETARDANT TREATED PER CPAI-84 SPECIFICATIONS. THEY ARE NOT
FIREPROOF! OPEN FLAMES SHOULD NOT BE USED IN OR NEAR THE TENT SINCE FLAME-RESISTANT MATERIALS CAN
STILL BURN OR MELT.
TO REMOVE TENT STAKES, USE A HAMMER OR STAKE PULLER. DO NOT REMOVE BY PULLING ON THE TENT FABRIC.
THIS COULD CAUSE DAMAGE TO THE TENT.
ALWAYS STORE YOUR TENT DRY AND CLEAN. TO CLEAN SOILED AREAS, GENTLY APPLY NONDETERGENT SOAP AND
WATER. DO NOT SCRUB THE TENT FABRIC, AS YOU MAY DAMAGE THE WATER-REPELLENT PROPERTIES.
DO NOT SPRAY WITH INSECTICIDES. MOST CONTAIN CHEMICALS THAT MAY DAMAGE TENT MATERIALS.
TIPS AND BEST PRACTICES
ADDITIONAL INFORMATION
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. CALL 1-800-237-4444 FOR ASSISTANCE OR VISIT WWW.CABELAS.COM
4
Cabela’s recommends that you familiarize yourself with all parts and fully assemble your tent before going on
your first adventure.
It can be easier to assemble a tent with the door facing the wind. Once you have fully assembled the tent, you
can turn it to face the way you want and re-stake.
Stakes should be placed at a 45˚ angle with the tops facing away from the center of the tent.
If your tent has fabric ties or hooks on top of the tent, secure these to the poles. These are usually the support
for an accessory hang point inside the tent.
We HIGHLY recommend setting guy lines every time to secure your tent. Guy lines will not only stabilize the tent
in windy conditions, they also ensure that the tent will vent properly.
When possible, open doors to increase ventilation and reduce condensation, which can form on the inner tent
surface.
Research the area where you intend to camp. Prepare for any possible weather conditions. Be aware of hazards
and emergency protocol.
Know the rules and regulations of the area where you intend to camp.
Be considerate of other people and wildlife.
Remember to clean up and dispose of all waste properly. “Leave no trace behind.”
Always store your tent dry and clean. To clean soiled areas, gently apply nondetergent soap and water.
You should set up and inspect your tent annually before using. Ensure that you have all the parts from the
provided list.
Inspect seams for wear and apply seam sealer if needed.
DISASSEMBLY INSTRUCTIONS
Follow all assembly steps in reverse order to disassemble the tent.
When disassembling the tent, you should slightly loosen all rain-fly buckles or webbing. You should also loosen
window zippers to relieve stress upon next assembly.
Fold the rain fly and place it over the tent body. Fold the tent body into thirds or quarters, depending on the tent.
The width of the folded tent should roughly match the length of the unassembled poles.
For smaller backpack tents, place the pole and stake bag on the short end of the tent. Firmly roll the tent up
around the pole bag and place in the carry bag.
ALASKAN GUIDE TENT ASSEMBLY
STEP 1 - GETTING STARTED
CABELA’S TENTS ARE EASY TO ASSEMBLE AS LONG AS YOU READ THE INSTRUCTIONS CAREFULLY AND AVOID EXCESSIVE
FORCE TO ANY PART OF THE TENT OR POLES.
WE RECOMMEND ASSEMBLY BE COMPLETED BY TWO PEOPLE.
Lay out your tent body with the door facing up. Place a
stake at each corner, through the loop at the end of the
webbing.
(Note: Insert all stakes into the ground at a 45˚ angle with
the tops facing away from the center of the tent.)
Pull the webbing taut so that you attain a straight line but
do not distort the shape of the tent.
STEP 2 - POLE ASSEMBLY
Assemble all poles. Each sleeve and clips are color-coded to
the correct poles. Starting at A1, insert the matching pole
through the sleeve. Repeat this step for the B and C
color-coded poles.
Insert one end of the A1 assembly into the middle ring pins.
Repeat this step for B1. Only these two points will have
three pins.
STEP 3 - SETTING TENT BODY
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. CALL 1-800-237-4444 FOR ASSISTANCE OR VISIT WWW.CABELAS.COM5
A
1
B
1
C
1
B
2
A
2
C
2
Front Door
BA
C
A and B
11
Carefully lift the tent and set the poles on the pins at
locations A2 and B2. Repeat previous steps for pole
assembly C.
Next, attach the C-clips to each of the three poles from the
bottom up.
ASSEMBLY CONT.
STEP 4 - SECURING POLES
CABELA’S TENTS ARE EASY TO ASSEMBLE AS LONG AS YOU READ THE INSTRUCTIONS CAREFULLY AND AVOID EXCESSIVE
FORCE TO ANY PART OF THE TENT OR POLES.
Pole D follows the seamline from points C1 to C2. Insert one
of the ends onto the ring pins and bend over the top of
existing poles. Next, insert the opposite end into corre-
sponding ring pin. Repeat the process for pole-assemblies E
and F. Pole E follows points B1 to B2. Pole F follows points
A1 to A2 (Fig. 5). Attach C-clips to the rest of the pole
assemblies.
(Note: Where poles intersect, there is a hook-and-loop
webbing attachment. Pass webbing over intersecting poles
and through the D-ring and then back onto itself. (Fig. 6))
STEP 5 - SETTING VESTIBULE
Position rain fly so that the zipper portions are over the two
tent windows and the extended (gray) roof portion is over
the front tent door. Insert the shorter rain-fly pole assembly
into the rain-fly pole sleeve at the rear of the vestibule until
it extends out the opposite end.
Connect the rain-fly corners to the tent by attaching the
shock-corded hooks to the tent corners’ black steel rings.
Insert pole ends onto the remaining ring pins at points A1
and B1 (Fig. 5) and attach remaining rain-fly hooks.
STEP 6 - FINAL STEPS
Guy out the front vestibule by pulling the front of the
vestibule away from the tent evenly until it is taut. Stake
out at each webbing loop on either side of the vestibule.
Stake out all remaining loops and guy lines.
(Note: Guy lines will not only stabilize the tent in windy
conditions, they also ensure that the tent vents properly.)
PLEASE READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. CALL 1-800-237-4444 FOR ASSISTANCE OR VISIT WWW.CABELAS.COM
6
A
AB
B
C
C
D
E
F
1
2
1
1
22
R
R
R
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Carpa de Cabela's
Cabela's
Cabela's ULTIMATE ALAKNAK 51-9278 Manual de usuario
Cabela's
Cabela's Ice Team 360 TC Hub Shelter Manual de usuario
Cabela's
Cabela's Ice Team 110524 Manual de usuario
Cabela's
Cabela's GETAWAY 10x14 CABIN TENT Manual de usuario
Cabela's
Cabela's ORION Manual de usuario
Cabela's
Cabela's 58-2722 Manual de usuario
Cabela's
Cabela's Clam QUICK-SET Manual de usuario
Cabela's
Cabela's 58-2720 Manual de usuario
Cabela's
Cabela's 58-2649 Manual de usuario
