Bristan Java J BID C Manual de usuario

Java Bidet Mixer

Fitting Instructions

& Contents List

(With pop-up waste)

Please keep these instructions for future reference and request of

replacement part

(FI J BID) (REV D1)

AFTERCARE INSTRUCTIONS

GUARANTEE

Your fitting has a high quality finish and should be treated with care to preserve the

visible surfaces.

All surface finishes will wear if not cleaned correctly, the only safe way to clean your

mixer is to wipe with a soft damp cloth. Stains can be removed using washing up

liquid. All bath cleaning powders and liquids will damage the surface of your fitting,

even the non-scratch cleaners.

All products are manufactured to the highest standards and a 5 year guarantee

covers any defect in manufacture.

In the interests of continuous product development we reserve the right to alter

specification as necessary

Installer please fill in code here

Bristan Group Limited

Birch Coppice Business Park

Dordon

Tamworth

Staffordshire

B78 1SG

A Masco Company

Website: www.bristan.com

Telephone:+44 (0) 844 701 6274

Facsimile: +44 (0) 844 701 6275

NOTE: Never use abrasive detergents or

disinfectants or those containing alcohol, hydrochloric acid or phosphoric

acid.

NOTE: The 5-year guarantee on the cartridge is invalidated if damaged by any

waterborne debris.

All products must have access for servicing or replacement during the life of

the product.

PRODUCT IDENTIFICATION CODE LASER ETCHED ON PRODUCT

. (Where applicable)

PRODUCT CODE:

TELEPHONE HELPLINE! +44 (0)844 701 6273

Bristan recommend E-Cloth for cleaning all of our

bathroom & kitchen products. Using just water, E-cloth

gives a smear free, deep clean by breaking up and holding

dirt, which normal cloths leave behind. Order through

your Bristan stockist. (ORDER CODE: ECLOTH)

WATER PRESSURE

This mixer is suitable for use at all supply pressures. However for optimum use both

the hot and cold supplies should be reasonably balanced.

If the fitting is installed at low pressure (tank fed), then the minimum distance from the

outlet of the nozzle to the underside of the cold tank should be 2.0 metres to ensure

adequate shower performance.

This mixer should be installed in compliance with the Water Regulations. Where the

supplies are unbalanced, i.e hot water from the cylinder tank/cold from the mains,

approved check valves must be fitted in the supply pipes. For further details contact

your Local Water Authority.

PLEASE NOTE:

0844 701 6273

In the unlikely event you find a part missing, please contact our Customer Service

helpline on for immediate dispatch of part

INSTALLATION

1. Identify all components and check for completeness, particularly before

commencing installation.

2. Fit the mixer body (1) to the bidet using the ‘C’ plate fixing kit. The plinth (3)

and O-ring (15) go between the fitting and the bidet, and the ‘C’ shaped

rubber (4) and metal washers (5) on the underside of the bidet. Secure

Into position using the threaded rods (8) and nuts (6).

3. Fit the tail pipes (7) to the fitting and connect the hot and cold supplies.

4. Fit the pop-up waste, using washers (11) below & (12) above the bidet

& connect it to the mixer. It is recommended that a silicon sealant be applied to

both sealing faces of washers (11 and 12). The waste can be set by adjusting the

waste rod (9)/ operating rod (2) connecting bracket and the screw in the base of

the plug (14).

5. Fully open the mixer in the mid position, letting the water flow for a few minutes

to check all joints and connections for leaks.

6. See back page for aftercare instructions.

N.B. Please write the name and product code of your fitting in the spaces

provided overleaf. This will ensure a speedier service if you should need to

phone the helpline.

MAINTENANCE

If the fitting begins to drip:

Note: That there are locating pins on the bottom of the cartridge that fit in

Holes inside the tap, to ensure it is fitted the right way round.

1. Turn off the water supply

2. Remove indice cap(a), loosen grub screw (b) with 2.5mm hexagonal key and

pull off head (c), unscrew shroud (d) retaining nut (e).

3. Remove cartridge (f).

4. Clean or replace cartridge, clean and grease seal and refit.

5. Replace cartridge and head, then turn on the water supply.

6. Contact our helpline if problem persists.

CONTENTS

1. Mixer Body

2. Pop-up Operating Rod

3. Plinth

4. C-shaped Rubber Washer

5. C-shaped Metal Washer

6. Nut (x2)

7. Copper Tail Pipes (x2)

8. Threaded Rod (x2)

9. Waste Rod

10. Waste Body

11. Washer

12. Washer

13. Waste Flange

14. Plug

Otros manuales de Producto de plomería de Bristan

Bristan

Bristan Z2 DUS 1/2 C Diagrama de cableado

Bristan

Bristan Nero NRBSME6C Diagrama de cableado

Bristan

Bristan GLL RAPSNK4 C Instrucciones de montaje

Bristan

Bristan HOU SHCDIV C (D7) Diagrama de cableado

Bristan

Bristan Artisan Diagrama de cableado

Bristan

Bristan EV KIT-EFB C Instrucciones de montaje

Bristan

Bristan DUL3 THBSM C Manual de usuario

Bristan

Bristan ELVIRA SHWR PK Instrucciones de montaje

Bristan

Bristan GLE385 W Instrucciones de montaje

Bristan

Bristan smile Instrucciones de montaje

Bristan

Bristan Prism Manual de usuario

Bristan

Bristan Artisan AR SNK C Manual de usuario

Bristan

Bristan NIVA NVA BSM C Diagrama de cableado

Bristan

Bristan CAP2 SHXAR C (D6) Diagrama de cableado

Bristan

Bristan CRAZE CRZ2 SHXDIVCTFF C Diagrama de cableado

Bristan

Bristan WMNT12 Instrucciones de montaje

Bristan

Bristan VAL2 BAS C CD (D2) Diagrama de cableado

Bristan

Bristan ALP Series Diagrama de cableado

Bristan

Bristan KN2 SHXAR C Instrucciones de montaje

Bristan

Bristan JAVA J THBSMVO C Diagrama de cableado

Bristan

Bristan Options Bath Manual de usuario

Bristan

Bristan W SNK6 C Manual de usuario

Bristan

Bristan Java J SFSNK EF C Manual de usuario

Bristan

Bristan Descent Series Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario