Brahler CDSVAN Manual de usuario

Operating instructions

Rev 3.80

CDSVAN Digital Conference Management System

B8 –AD/DA Interface

B8 CDSVAN

2 Copyright by Brähler ICS

Printed in Germany

Should you have questions about this manual please contact:

Brähler ICS Konferenztechnik

International Congress Service AG

Auf der Alten Burg 6

53639 Königswinter, Germany

T +49 (0)2244 930-0

[email protected]

You will find further information about our Products on the internet at:

www.braehler.com

similar methods.

All other trademarks and trade names are the property of their respective owners.

BRÄHLER ICS reserves the right to make changes without notice.

Operating instructions B8 BGE-B8 (3.x).DOC

CDSVAN B8

Safety instruction

! CAUTION !

DANGER OF ELECTRIC SHOCK

DO NOT OPEN DEVICES

Do not open housing with mains cable connected.

Maintenance operations may only be done by

qualified personnel.

Our equipment and installations have been built and tested according to the latest state of the art. Under

normal conditions, they do not require any special maintenance.

However, please be aware of the following:

secure and stable position of the installation

sufficient ventilation - never operate equipment near heat sources such as heating radiators etc.

power connection - install all power cables to avoid damaging

connecting cables - avoid trip-traps

liquids - avoid penetration of liquids into the housing

exclusively operate equipment via wall sockets that are connected to ground according to the

relevant specifications and regulations

Warning: Never expose equipment to rain or humidity.

Please be also aware of the fact that rough handling of the equipment, such as strong bumps or vibrations,

may result in damages. Inappropriate handling and storage, i.e. handling and storage not in conformity with

the operating instructions, may as well lead to equipment damages.

B8 CDSVAN

4Copyright by Brähler ICS

CDSVAN B8

Content

Safety instruction.............................................................................................. 3

About this manual ............................................................................................. 6

Symbols ................................................................................................................ 6

Important remarks................................................................................................... 7

For customers in the EU and in the USA ..................................................................... 7

For customers in the United Kingdom......................................................................... 7

General ................................................................................................................. 8

The B8 AD/DA Interface .................................................................................... 9

Included in delivery ............................................................................................... 10

Accessories ......................................................................................................... 10

System Components ............................................................................................. 10

CAT5 Cable usage ................................................................................................ 10

Operating Controls .......................................................................................... 11

Front view ........................................................................................................... 11

Rear view ............................................................................................................ 11

DIP Switch Settings .............................................................................................. 13

Device ID ....................................................................................................................... 13

WordClock Mode............................................................................................................. 14

Slave Sync ..................................................................................................................... 14

Master Clock .................................................................................................................. 14

AF Control...................................................................................................................... 14

Cable Length .................................................................................................................. 14

Termination .................................................................................................................... 15

Ground-to-Earth .............................................................................................................. 15

Analogue Audio Connections .................................................................................. 16

Digital Audio Connections ...................................................................................... 16

Audio Control....................................................................................................... 17

Automatic Memory ............................................................................................... 17

Audio Routing ...................................................................................................... 18

MotorMixer connection .......................................................................................... 19

16/32 Channel Audio Distribution ..................................................................... 20

Appendix ....................................................................................................... 22

Technical Data ..................................................................................................... 22

Troubleshooting table ............................................................................................ 23

SERVICE FORM .................................................................................................... 25

Block diagrams ..................................................................................................... 27

Your current DIP switch settings: ............................................................................ 29

Contact information .............................................................................................. 31

B8 CDSVAN

6Copyright by Brähler ICS

About this manual

Symbols

The meanings of the symbols and fonts used in this manual are as follows:

Indicates an important note, if not minded, the functionality of the unit, the security of your data, or

your health are put at risk.

Supplementary information, remarks, and tips follow this symbol.

Text which follows this symbol describes activities that must be performed in the order shown.

Texts in bolded letters require your special attention.

CDSVAN B8

Important remarks

For customers in the EU and in the USA

The equipment has been tested and found to comply with the limits of the CE test. These limits are designed

to provide reasonable protection against harmful interference when the equipment is operated in a

commercial environment. The equipment generates, uses, and can radiate radio frequency energy and if not

installed and used in accordance with the user manual it may cause harmful interference to radio

communications. You are cautioned that any changes or modifications not expressly approved in this manual

could void your authority to operate this equipment.

For customers in the United Kingdom

The wires in the main lead are coloured in accordance with the following codes:

Green-and-yellow: Earth

Blue: Neutral

Brown Live

The colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings

identifying the terminals in your plug, so please proceed as follows:

The green-and-yellow wire must be connected to the terminal in the plug marked with the letter E or with the

safety earth symbol or marked with green-and-yellow colour. The blue wire must be connected to the

terminal marked with the letter N or marked with black colour. The brown wire must be connected to the

terminal marked with the letter L or marked with red colour.

The equipment must be connected to earth!

Safety

Check that the operating voltage of the unit is identical with the voltage of your local power supply. If a

voltage conversion is required, consult your BRÄHLER ICS dealer or qualified personnel.

Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by qualified

personnel before operating it further. Unplug the unit from the wall outlet or set the Main Power switch to

OFF if it´s not used for several days. To disconnect the cord, pull it out holding the plug. Never pull the cord

itself.

Installation

Allow adequate air circulation to prevent internal heat built-up. Do not place the unit on a surface (rugs,

blankets, etc.) that may block the ventilation holes.

Do not install the unit in a location near heat sources such as radiators or air ducts, or in a place exposed to

direct sunlight, excessive dust or humidity, mechanical vibration or shock.

To avoid moisture condensations do not install the unit where the temperature may rise rapidly.

Cleaning

To keep the cabinet in its original condition, periodically clean it with a soft cloth. Stubborn stains may be

removed with a cloth lightly dampened with a mild detergent solution. Never use organic solvents such as

thinners or abrasive cleaners since these will damage the cabinet.

Repacking

Save the original shipping carton and packing material; they will become handy if you ever have to ship the

unit.

For maximum protection, re-pack the unit as originally packed from the factory.

If not supplied with the equipment, a complete transportation and storage box system is available from

BRÄHLERICS. We recommend you to use this system for long-term protection and care.

B8 CDSVAN

8Copyright by Brähler ICS

General

Please keep this manual together with the B8. If you pass on the units to other parties, please include this

manual.

Please read the manual carefully, taking special care when you see this symbol as

indicates important information!

This product conforms to the rules of the following European regulations:

2004/108/EG

Council directive to the alignment of the rules, of rights of all member states about the electromagnetic

compatibility, adapted through RL 91/263/EWG, 92/31/EWG and 93/68/EWG of the council. Further

information is available on request.

The warranty invalidates, if you cause (generate, precipitate) inappropriate use or handling of the

unit.

CDSVAN B8

The B8 AD/DA Interface

Thank you for choosing the B8 AD/DA interface.

The B8 is your interface to the digital world and of course, vice versa.

The B8 AD/DA interface offers you a high quality audio conversion from analogue to digital (AD) and digital

to analogue (DA) in one single 2HU housing.

Almost all digital sound processing systems offer a large amount of digital channels, but due to space

restrictions the AD/DA conversion has to be outsourced, if more channels are required.

At this point the B8 starts its work.

Feed in the analogue signals, using the analogue input sockets at the rear side of the B8. Depending on the

available patch cable, either XLR or ¼ inch jacks can be used.

All inputs are electrically balanced to avoid electromagnetic interference (transformer balanced version

available on request).

The B8 operates line and microphone level signals. The 8 inputs are individually adjustable to the level of

the incoming signal. Even phantom power is provided by the B8 and switch able to all microphone inputs.

High quality microphones (e.g. condenser microphones) can be connected directly to the B8 without any

additional power supply.

All input channels are equipped with individual level adjustment of +/- 9dB.

To deliver you the best audio performance the analogue-to-digital conversion works with a 24 Bit resolution

and selectable sample rates of 32, 44.1 or 48 kHz.

The B8 offers the common digital multichannel interfaces ADAT®and of course an interface to the CDSVAN

system –EDAT.

With the EDAT (RJ45) connectors the number of in- and outputs can be extended to 16, linking a second B8

to the first one.

The B8 can also be used as a digital 32 channel (16 channels in and 16 channels out) audio distributor with

the specifications shown above independently of the CDSVAN system.

B8 CDSVAN

10 Copyright by Brähler ICS

Included in delivery

Mains power cable - 2 metres, black

Accessories

19” rack mounting set - silver anodised (no. 60.KIT.2)

Terminator - TERM216 (no. 06.6161)

Data cable - CAT5 several cable lengths available *) see below

Adapter CCAT5 - crossed cable adapter to connect two B8 IN/OUT (PC) sockets

System Components

CDSVAN pro Audio processing software

DSP6/15 RJ45 DSP Card with 6 or 15 digital sound processors and EDAT I/O plate

DOLV Interpreter Console for 32 channels

DV9 Delegates Unit

PV9 Chairman Unit

EDV9 Delegate Unit, build-in version

EPV9 Chairman Unit, build-in version

PSU04 Power Supply Unit, up to 4 branches for interpreter consoles/ delegate units

PSU01MA/SL Additional Power Supply for interpreter consoles/ delegate units

B8 AD/DA Interface 8 channels

MotorMixer Remote Mixer with 8 motorised faders

MSI8V INFRACOM®Infrared Transmitter

IRad INFRACOM ® Infrared Radiator

IRX INFRACOM ® Infrared Receiver

Cables CAT5 *) see below

CAT5 Cable usage

*) The system warranty is only valid with the intended use of the CDSVAN system cables specified

below. The usage of any other cable type will void the warranty.

Specified patch cable: Brähler CAT5 System Cable (Art.-No. 13.5331)

Specified installation cable: Brähler CAT5 Installation Cable (Art.-No. 13.5330.H)

Tabla de contenidos

Otros manuales de Sistema de conferencias de Brahler

Brahler

Brahler Digivote III Manual de usuario

Brahler

Brahler MSI8V CDSVAN Manual de usuario

Brahler

Brahler DIGIMIC Manual de usuario

Manuales populares de Sistema de conferencias de otras marcas

Kramer

Kramer VIA GO Manual de usuario

AVT

AVT MAGIC AC1 Go Manual de usuario

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Manual de usuario

Sony

Sony PCS-I150 Manual de usuario

Middle Atlantic Products

Middle Atlantic Products VTC Series Manual de usuario

Prentke Romich Company

Prentke Romich Company Vanguard Plus Guía

Speakerbus

Speakerbus iD 712 Manual de usuario

Trelleborg

Trelleborg SafePilot CAT PRO Manual de usuario

Sennheiser

Sennheiser ADN Manual de usuario

ADTRAN

ADTRAN NetVanta 7100 Manual de usuario

AINA

AINA PTT Voice Responder Manual de usuario

Yamaha

Yamaha ProjectPhone PJP-100H Manual de usuario

vissonic

vissonic VLI Series Manual de usuario

Panasonic

Panasonic KX-VC500 Manual de usuario

Poly

Poly Trio 8300 Manual de usuario

Crestron

Crestron Mercury CCS-UCA-SMK Dibujo dimensional

Inmarsat

Inmarsat mini M Manual de usuario

Tenveo

Tenveo ALL-IN-ONE Manual de usuario