Bosch D2000 Manual de usuario

Page 1

Security System User’s Guide

Before using this manual, you should be familiar with the

User’s Cards

located inside the keypad. The User’s Cards

provide instructions for frequently used functions.

This guide contains instructions for system owners to change

other user’s passcodes. It also describes basic features of the

security system.

Maintenance and Service

The keypad requires very little maintenance, however, test the

system weekly to insure early detection of a need for service.

A test schedule and maintenance program can be arranged

with your alarm company. If you notice a change in operation

during normal use or testing, call for service as soon as

possible. Do not attempt to repair the control panel, keypads,

or detectors yourself.

Call ________________________________ Before Testing

The security system is connected to this telephone number:

_______________________________________________________

The security control panel is connected to the phone jack

located:______________________________________________

Power Failure

If your keypad indicates a power failure, and you have power

in the rest of your premises, there may be a problem with the

electrical transformer or circuit breaker supplying power to

your security control panel. First, check to be sure that the

transformer is securely plugged into the electrical outlet. If it

appears to be damaged in any way, do not attempt to repair it.

Call your security company for service.

Transformer location: _____________________________

If the transformer is plugged in, check the circuit breaker

supplying power to the outlet. If the breaker is tripped, check

the appliances on the circuit for signs of electrical problems.

Make sure someone has not intentionally turned the breaker

off. When all is clear, reset the breaker.

Circuit breaker number: ___________________________

71-07117-000-C 1/95

Page 2

Fire Safety

Residential fire is a leading cause of accidental death. Most

fire related deaths occur at night when the occupants

suffocate in their sleep from smoke and deadly gases, rather

than from burns. To help reduce this risk, the following three-

step program should be implemented:

1. Minimize fire hazards around the home. Smoking in bed,

cleaning with flammable liquids such as gasoline, leaving

children home alone, and unsafe holiday decorations are

some of the more common causes of household fire.

2. Install a fire warning system. The primary purpose of this

system is to protect lives, not property, by giving the

earliest possible warning of the danger. In the event of a

fire, the alarm system generates a loud intermittent tone

distinctly different than a burglar alarm.

In homes with more than one sleeping area a smoke

detector (indicated by an inverted "s" in a circle) should be

provided to protect each area.

3. Plan and practice an escape plan. A fire alarm warning

may be wasted unless the family has planned for a quick

evacuation. Because there may be very little time

between detection of a fire and the time it becomes

deadly, it is important that every member of the family

understand exactly what to do.

BED

ROOM

BED

ROOM BED

ROOM

BED

ROOM

ROOM DR K BR

KITCHEN

BEDROOM

BED

ROOM BED

ROOM

DINING

LIVING

ROOM FIRE

Possible escape routes through open windows marked with arrows.

Page 3

Primary and alternate escape routes should be established.

Since stairwells and hallways may be blocked during a fire,

exiting through a bedroom window at night should be an

essential part of the escape plan. If the sleeping area is above

the ground floor, provide a means for safely descending

outside the building if one does not already exist.

As part of this plan, all family members should arrange to

meet at a predetermined location away from the house (such

as a neighbor’s), to verify that all are accounted for.

In Case of Fire

1. The primary purpose of a fire warning system is to protect

lives. In the event of a fire alarm, quickly leave the

building and call the fire department from a neighbor's or

public telephone.

2. If it is determined the alarm was accidentally tripped, the

bell should be silenced, the detectors reset and your

alarm company notified immediately of the situation.

Emergency Keys

There are three emergency keys across the top of the keypad.

These keys perform system functions when pressed twice.

Your alarm technician programs the Emergency Keys.

Remember, press the key two times to perform an

emergency function.

Emergency Key Function

Left (A) ________________________________

Center (B) ________________________________

Right (C) ________________________________

Page 4

Reporting to the Security Company

❒My system reports to my security company.

❒My system does not report to my security company.

Your system may be programmed to send a "closing" report to

your security company when you turn it on, and an “opening”

report when you turn it off.

❒My system sends opening and closing reports.

❒My system does not send opening and closing reports.

Your security system automatically disconnects your

telephone from its line when it sends reports to your security

company. This prevents reports from being interrupted during

transmission. Once the report has been completed, the

telephone line is restored to normal service.

Note: If damage occurs to the telephone line and your

telephone service is interrupted, reports will not be sent to

your security company unless an alternate means of

transmitting signals is installed in your system.

Passcode Privileges

Users can have one of three passcode types: Owner, User, or

One-Time.

•Owner type passcodes can re-configure how the system

responds to “watched” points. This feature is described in

Watch ~Test

in the

User Cards

. In addition, the Owner

passcode can be used to change other users’ “type” and

can change other users’ passcodes. The type and

passcode change features are described in the pages that

follow.

•User type passcodes are given to most users of the

system, and allow all but owner functions to be performed.

• One-Time passcodes allow the user to disarm the system

one time only. You can give them to temporary users, such

as housekeepers or service workers.

Page 5

Show User

The Show User mode shows each user’s passcode type on

lights 1 to 8. The type for Code 1 displays on light 1 and so

on.

Flash (fast blink) ––– Owner type

Wink (slow blink) ––– User type

On –––––––––––––– One-Time type

Off –––– Disabled passcodes and One-Time

passcodes that have been used once to turn

the system off.

To renew One-Time passcodes:

1. Press Key 6to enter Show User Mode.

2. Enter your passcode. (Owner type required.)

3. Press 9to renew all One-Time passcodes.

Lights for One-Time passcodes turn on.

4. Press Clear to exit Show User Mode.

To change Passcode Types:

1. Press Key 6to enter Show User Mode.

2. Enter your passcode. (Owner type required.)

3. Press keys 1to 8to toggle the passcode type. Key 1for User

1 and so on.

For example, if light 3 is winking (User Type), pressing key 3

changes the code type for user 3 to One-Time. Light 3

changes from wink to on.

Pressing 3again disables the passcode; light 3 is off.

Pressing key 3a third time changes to Owner; light 3 flashes.

You can not change your own passcode type.

To "remove" a passcode, change its type to disabled.

4. Press the Clear key to exit Show User mode.

Page 6

To change other users' passcodes:

1. Press Key 6to enter Show User Mode.

2. Enter your passcode. (Owner type required.)

3. Press 0.

The Part light begins flashing. You are now in Owner

Passcode Change Mode.

4. Enter the number of the passcode you want to change

(1 to 8).

5. Enter a new passcode

with the same number of digits as

your passcode

The OK tone sounds.

If the error tone sounds, go to step 4. Try a different

passcode.

6. Enter the new passcode again.

The OK tone sounds. Go to step 4 to change another

passcode or step 7 to continue.

If the error tone sounds, return to step 4. Be sure to enter the

same passcode in steps 5 and 6.

7. After changing a passcode you should check its user type.

Press Clear once to go back to Show User mode. See

Change Passcode Type,

step 3 on Page 5.

8. Press Clear a second time to exit the Passcode Change

mode.

Page 7

Security System Limitations

Not even the most advanced security system can guarantee

protection against burglary, fire, or environmental threats. All

security systems are subject to possible compromise or

failure-to-warn for a variety of reasons including, but not

limited to, the following:

• If sirens or horns are placed outside the hearing range of

people in remote areas of the building or in areas which

are frequently closed off, they do not provide the intended

protection.

• If intruders gain access through unprotected points of

entry, the system will not detect their entrance.

• If intruders have the technical means of bypassing,

jamming, or disconnecting all or part of the system, they

will not be detected.

• If the AC power supply is OFF and the backup battery is

either missing or dead, sensors will not detect intrusion.

• Smoke detectors cannot detect smoke in chimneys,

walls, or roofs, or smoke blocked by a closed door. They

may not detect smoke or fire on a level of the building

different from the one on which they are located. Smoke

detectors may not be able to warn in time about fires

started by explosions, improper storage of flammables,

overloaded electrical circuits, or other types of hazardous

conditions.

• If phone lines are out of service, reports from the security

system to the security company cannot be sent.

Telephone lines are vulnerable to compromise by several

means.

Inadequate maintenance and failure to test are the most

common causes of alarm failure. It is strongly recommended

that you test your system once a week to be sure that all

system components are working properly.

Although having a security system may make you eligible for

reduced insurance premiums, the system is no substitute for

insurance. Warning devices cannot compensate you for loss

of life or property.

Page 8

User Record

Passcode Type Name

Number Circle One

1Owner, User, ___________________