Black Box LB9020A-R2 Manual de usuario

Installation

This installation guide gives step-by-step instructions about how to install the Express Plus Ethernet Switches:

LB9020A-R2

Selecting a Site for the Express Ethernet Switch: LB9020A-R2

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

-The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

-The relative humidity should be less than 90 percent, non-condensing.

-Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) fieldstrength.

-Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

-The power outlet should be within 1.8 meters of the switch.

Connecting to Power

?? Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 260 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

?? First, ensure the power of the switch and end devices is turned off.

<NOTE> Always ensure that the power is off before any installation.

?? Prepare cable with corresponding connectors for each type of port in use.

?? Consult Table 2 below for cabling requirements based on connectors and speed.

?? Connect one end of the cable to the switch and the other end to a desired PC or workstation.

?? Once the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Receptacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µmmulti-mode fiber-optic cable.

Table: Cable Specifications Ethernet

Standards Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-TRJ-45 10/20

Mbps Cat. 3, 4 or 5

UTP/STP 100 m

100BASE-TX

RJ-45 100/200

Mbps Cat. 5

UTP/STP 100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com ?E-mail: [email protected]

Otros manuales para LB9020A-R2

Tabla de contenidos

Otros manuales de Cambiar de Black Box

Black Box

Black Box ServSwitch Ultra KV5002MA-R2 Manual de usuario

Black Box

Black Box EMS1G-48 Manual de usuario

Black Box

Black Box LGB5052A-R3 Manual de usuario

Black Box

Black Box LB9019A Manual de usuario

Black Box

Black Box LPB708A Instrucciones de funcionamiento

Black Box

Black Box SW1023A Manual de usuario

Black Box

Black Box LB9009A-FO Manual de usuario

Black Box

Black Box SW487A-R2 Manual de usuario

Black Box

Black Box SW459A-ST Manual de usuario

Black Box

Black Box IDM-AP-100 Manual de usuario

Black Box

Black Box LB8405A-R2 Manual de usuario

Black Box

Black Box ServSelect III KV22016A Manual de usuario

Black Box

Black Box ServSwitch KV1608C-R3 Manual de usuario

Black Box

Black Box KV5016FA-R2 Manual de usuario

Black Box

Black Box SWI081A Manual de usuario

Black Box

Black Box SWL065A Manual de usuario

Black Box

Black Box ServSwitch Manual de usuario

Black Box

Black Box ServSwitch SW721A-R5 Manual de usuario

Black Box

Black Box SERVSWITCH KV3108SA-R4 Manual de usuario

Black Box

Black Box DISPLAYPORT KV4402A Manual de usuario

Black Box

Black Box ServSelect IP VM KV2116A Manual de usuario

Black Box

Black Box LPH1004A Manual de usuario

Black Box

Black Box 12 VDC load Manual de usuario

Black Box

Black Box ServSwitch DT Basic II KV7024A Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario