Bkav AI View S200-0233 Manual de usuario
ULTRA ZOOM bullet
AI-based Camera
Qualcomm products contained here in are products of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
The Made with Qualcomm Technologies logo is a trademark of Qualcomm Incorporated.
Model: S200-0233
INSTALLATION GUIDE
PRODUCT KIT
Wall bracket
3
Safety cable
Installation guide
Ø10 mm, 4 holes
WALL DECAL FOR
DRILLING POSITION
Drilling position decal
ULTRA ZOOM bullet
AI-based Camera
Qualcomm products contained here in are products of Qualcomm Technologies,Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
The Made with Qualcomm Technologies logo is a trademark of Qualcomm Incorporated.
Thank you letter
Camera
4
PRODUCT KIT
Antenna GPS Set 4 of screws
and anchors
Hex key IR led
(Optional)
Power supply
(Optional)
Water supply tank
(Optional)
Water supply tank accessories
(Optional)
5
TECHNICAL SPECIFICATIONS
Power supply
Protection standards IP66, IK10
Resolution, frame rate FHD 1920x1080, Max 60fps
Digital zoom 4x
Optical zoom 33x
Focal length 4.5 - 148.5mm
Angle of view (horizontal - vertical) Near: 60.1° - 36.2° / Far: 2.28° - 1.29°
Operating temperature
Dimensions (L x W x H) L503 x W242 x H170mm
4.05kgWeight
-40°C - 60°C (-40°F - 140°F)
Humidity 10 - 100%
PoE IEEE 802.3af/802.3at
30 - 80W depends on IR LED module (IR LED: 6, 12, 24, 48W)
6
Water and dust camera shield
PRODUCT OVERVIEW
Lens protection
Lens wiper
GPS antenna
Wall bracket
Safety cable
77
Step 1: Pass the PoE network cable through the center position on the decal. Put the decal onto the place
need to install and drill the expansion hole (Figure 1).
Step 2: Route the network cable through the bracket and waterproof knob then fix the bracket to the wall (Figure 2).
Then route it through the waterproof knob of the camera and press the network connector as shown.
INSTALLATION GUIDE
1 2
Network cable
Drilling position
decal
8
Step 3: Fix the waterproof knob to the camera (Figure 3).
Step 4: Fix the camera to bracket with latch and tighten screws, then screw the safety cable (Figure 4).
INSTALLATION GUIDE
3 4
9
INSTALLATION GUIDE
Step 5: Plug network cable to the signal stand-by (Figure 5).
5
6 9
10
INSTALLATION GUIDE
Step 6: Remove safety latch and lift the camera, then insert GPS atena cable into the camera (Figure 6).
Step 7: Connect GPS antena to the signal stand-by on the camera (Figure 7).
GPS antena
Tabla de contenidos
Idiomas:
Otros manuales de Cámara de seguridad de Bkav
Bkav
Bkav AI VIEW P450 Manual de usuario
Bkav
Bkav AI VIEW ULTRA ZOOM BULLET S200 Manual de usuario
Bkav
Bkav AI VIEW C300-0200 Manual de usuario
Bkav
Bkav AI VIEW C300-0200 Manual de usuario
Bkav
Bkav AI View P200-0802GN Manual de usuario
Bkav
Bkav AI View S500-0233 Manual de usuario
Bkav
Bkav AIView S201 Manual de usuario
Bkav
Bkav AI View P400 Manual de usuario
Bkav
Bkav AI View P450-0802GN Manual de usuario
Bkav
Bkav AI VIEW S500 Manual de usuario
