BestScope BS-2052BDBD Manual de usuario

Biological Digital Microscope

BS-2052BDBD

Instruction Manual

This manual is for BS-2052BD series biological digital microscope. To ensure the safety, obtain optimum

performance and to familiarize yourself fully with the use of this microscope, it is recommended strongly

that you study this manual thoroughly before operating the microscope.

BestScope International Limited

CONTENTS BS-2052BD

CONTENTS .........................................................................................................0

USER NOTICE......................................................................................................2

1. Components Name ........................................................................................3

2．Assembly......................................................................................................4

2.1 Assembly Diagram..................................................................................4

2.2 Assembly procedure...............................................................................5

3. Adjustment and Operation.............................................................................9

3.1 Adjustment set diagram.........................................................................9

3.2 Adjustment and Operation...................................................................11

4．Technical Specifications..............................................................................15

5．Outfit .........................................................................................................16

6．Troubleshooting Guide...............................................................................17

BestScope International Limited

USER NOTICE BS-2052BD

I. Safety Note

1. Open the box carefully to avoid the accessories, like lens, dropping to ground or being damaged.

2. Do keep the instrument out of direct sunlight, high temperature or humidity, dusty and easy

shaking environment. Make sure the stage is flat, horizontal and firm enough.

3. When moving the microscope, carefully carry it with the handle and the base.

4. Make sure the instrument is earthed, to avoid lighting strike.

5. For safety, be sure the main switch is in “O” (off) state and cut off the power supply before

replacing the bulb or the fuse. If you replace the bulb during use or right after use, allow the lamp

bulb and the lamp house to cool completely before touching.

(Designated bulb: 1W S-LED or 6V20W Halogen Lamp)

6. Check the input voltage: be sure the input voltage which is signed in the back of the microscope

is consistent with the power supply voltage, or it will bring a serious damage to the instrument.

7. Always use the power cord provided by BestScope.

8. The electrical equipment of the microscope should be discarded as electronic waste.

II. Maintenance and Care

1. All the lenses have been adjusted properly; do not dismount them by yourself please.

2. The nosepiece and coarse and fine focusing parts are so delicate that it is forbidden to

disassemble them carelessly by yourself.

3. Keep the instrument clean, and do not pollute the optical element when wiping away the dust

on the instrument.

4. The contaminations on the prism, like fingerprints and oil smudges, could be gently wiped with

a piece of soft cloth or tissue paper, gauze which has been immersed in pure alcohol or ether.

(Note that the alcohol and ether are highly flammable, do keep them away from the fire or

potential sources of electrical sparks, and use them in a drafty room as possible as you can.)

5. Do not attempt to use organic solvents to clean the microscope components other than the

glass components. To clean them, use a lint-free, soft cloth slightly moistened with a diluted

neutral detergent.

6. When using, if the microscope is splashed by liquid, cut off the power at once, and wipe away

the splash.

7. Do not disassemble any parts of the microscope, as this will affect the function or reduce the

performance of the microscope.

8. Place the instrument in a cool, dry position. When not using the microscope, keep it covered

with a dust cover. Make sure the lamp socket is cool before covering the microscope.

BestScope International Limited

1. Components Name BS-2052BD

Eyepiece

Binocular digital viewing head

Nosepiece

Objective

Main body

Stage

Condenser

Illumination

BestScope International Limited

2．Assembly BS-2052BD

2.1 Assembly Diagram

The following figure shows the installation sequence of the components. The number in the figure

shows the assembly steps.

Before installing, be sure every component is clean, do not score any parts or glass surface.

Keep well with hexagon wrench provided. When changing the components, you will need it again.

This manual mainly introduces the operation of the microscope part, regarding the software part,

please refer to the software instruction manual.

Main body

Objective

Binocular digital viewing head

10X Eyepiece

Power cord

①

②

③

④

BestScope International Limited

BS-2052BD

2.2 Assembly procedure

Fig.1

Fig.3

Fig.2

2.2.1 Installing binocular digital viewing

head (Fig.1-2)

Insert the binocular digital viewing head

into the microscope head and turn it to a proper

position, then tight it. Plug the USB cable to the

digital head and PC USB port.

2.2.2 Installing the eyepiece (Fig3-4)

Insert the eyepiece into the eyepiece

tube until they are against each other, as shown

in Fig.4.

Fig.4

BestScope International Limited

BS-2052BD

Fig.6

Fig.5

2.2.3 Installing the objective (Fig.5-6)

1. Adjusting the coarse focus knob until the

support device of the mechanical stage

reaches its low limit position.

2. Screw the lowest magnification objective into

the nosepiece from the left or the right side,

then revolve the nosepiece clockwise and

mount other objectives by the sequence of

low to high magnification

Installing objective this way will make the

change of magnification to be easier during

using.

Clean the objective regularly, for lens is

susceptible to dust.

When operating, use 10× magnification

objective to search and focus specimen

firstly, then replace with higher

magnification objective if necessary.

When replacing the objective, slowly turn

the nosepiece until you hear “clicked”, that

means the objective is in place.

2.2.4 Mounting the filters (Fig.7)

1. Open the condenser carriage①;

2. Place the required filter②into the

condenser, then close the condenser

carriage.

★ the filter of the standard outfit is green

and baby blue.

Fig.7

BestScope International Limited

BS-2052BD

2.2.4 Connecting the Power Cord (Fig.8-

10)

★ The cable and cords are vulnerable when

bent or twisted, never subject the power cord

to excessive force.

1. Set the main switch① to “O” (off) state

before connecting the power cord.

2. Insert the plugs②into the power jack③

of the microscope safely.

3. Plug the power cord④into the power

supply receptacle⑤. Make sure the

connection is well.

★ Do use the supplied power cord all the

time. If lost or damaged, select the same

standard cord, please.

★ A wide range of voltage, 100V～240V, is

acceptable for this microscope.

2.2.5 Replacing the fuse (Fig.9-10)

Do remember to set the main switch①to

the state “O” (OFF) and unplug the power cord

before replacing the fuse. Rotate the fuse out of

the holder③, replace with a new fuse, then

rotate it back to the holder again.

Fig.9

⑤

Fig.10

Fig.8

④

③

①

②

BestScope International Limited

BS-2052BD

2.2.8 Installing and Replacing the bulb

(Fig.11-12)

 Please use the specified halogen Lamp 6V20W.

1. Loosing the screw①.

2. Hold the bulb②after you wrap it with gauze or

other protection materials, and then insert its

pin deeply into the jack in the lamp holder.

3. During microscope using or soon after it is

turned off, the bulb, the lamp house and

nearby parts will be very hot and will cause

serious burns. Please turn the main switch to

“O” (off) and disconnect the power plug, and

make sure the bulb, the lamp room and

periphery are all cool. Then, you can do your

replacing.

 Insert the bulb gently. Squeezing too hard will

damage the bulb.

 To prevent reduced bulb life or cracking, do not

touch the bulb with bare hands. If fingerprints

are accidentally left on the bulb, wipe the bulb

with a soft cloth.

Fig.11

Fig.12

①

②

BestScope International Limited

3. Adjustment and Operation BS-2052BD

3.1 Adjustment set diagram

Right Fine Focus Knob

Right Coarse Focus Knob

Tension Adjustment Collar

Main Switch

Portrait Adjustment Knob

Lateral Adjustment Knob

Fig.13

Aperture Iris Diaphragm adjustment

Tabla de contenidos

Otros manuales de Microscopio de BestScope

BestScope

BestScope BS-2020B Manual de usuario

BestScope

BestScope BS-2092 Manual de usuario

BestScope

BestScope BS-2093B Series Manual de usuario

BestScope

BestScope BS-2070 Manual de usuario

BestScope

BestScope BS-3003 Manual de usuario

BestScope

BestScope BS-6023 Series Manual de usuario

BestScope

BestScope BS-2080MH6 Manual de usuario

BestScope

BestScope BS-6004 Series Manual de usuario

BestScope

BestScope BLM2-241 Manual de usuario

BestScope

BestScope BS-2076 Series Manual de usuario

BestScope

BestScope BS-7000B Manual de usuario

BestScope

BestScope BS-2080D Manual de usuario

BestScope

BestScope BS-2030MH10 Manual de usuario

BestScope

BestScope BS-2081L Manual de usuario

BestScope

BestScope BS-2082 Series Manual de usuario

BestScope

BestScope BS-2023B Manual de usuario

BestScope

BestScope BS-6020RF Manual de usuario

BestScope

BestScope BS-2010BD Manual de usuario

BestScope

BestScope BS-6030 Manual de usuario

BestScope

BestScope BS-2053 Series Manual de usuario

BestScope

BestScope BS-2036 Series Manual de usuario

BestScope

BestScope BS-2094C Manual de usuario

BestScope

BestScope BS-3040 Manual de usuario

BestScope

BestScope BS-3001 Series Manual de usuario

Manuales populares de Microscopio de otras marcas

Thermo Scientific

Thermo Scientific Nicolet iN10 Guía

National

National DC3-163 Manual de usuario

KERN Optics

KERN Optics OPE-1 Manual de usuario

OPTIKA MICROSCOPES

OPTIKA MICROSCOPES B-150D Manual de usuario

Prior

Prior Lux POL Manual de usuario

Opitec

Opitec Smartscoop 115615 Manual de usuario

KERN

KERN OPO-1 Manual de usuario

Topcon

Topcon SP-1P Manual de usuario

Motic

Motic PA43 Manual de usuario

Leica

Leica DVM5000 Guía del usuario

MshOt

MshOt MZ62 Manual de usuario

KERN Optics

KERN Optics OZR-5 Manual de usuario

VWR

VWR VisiScope 384 Series Manual de usuario

Nikon

Nikon ECLIPSE E200 POL Manual de usuario

Leica

Leica DI C800 Manual

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manual de usuario

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manual de usuario

Olympus

Olympus SZ61 Manual de usuario