Bacharach Leakator 10 Manual de usuario
LEAKATOR®10
INSTRUCTION 0019-9167
COMBUSTIBLE GAS DETECTOR
Part No. 0019-7051
Rev. 18 – October 2012
WARRANTY
Bacharach, Inc. warrants to Buyer that at the time of delivery
this Product will be free from defects in material and manufac-
ture and will conform substantially to Bacharach Inc.’s ap-
plicable specifications. Bacharach’s liability and Buyer’s remedy
under this warranty are limited to the repair or replacement,
at Bacharach’s option, of this Product or parts thereof returned
to Seller at the factory of manufacture and shown to Bacharach
Inc.’s reasonable satisfaction to have been defective; provided
that written notice of the defect shall have been given by Buyer
to Bacharach Inc. within one (1) year after the date of delivery
of this Product by Bacharach, Inc.
Bacharach, Inc. warrants to Buyer that it will convey good title
to this Product. Bacharach’s liability and Buyer’s remedy under
this warranty of title are limited to the removal of any title de-
fects or, at the election of Bacharach, to the replacement of this
Product or parts thereof that are defective in title.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND
ARE GIVEN AND ACCEPTED IN LIEU OF (I) ANY AND ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
WITHOUT LIMITATION THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE: AND (II) ANY OBLIGATION, LIABILITY, RIGHT,
CLAIM OR REMEDY IN CONTRACT OR TORT, WHETHER
OR NOT ARISING FROM BACHARACH’S NEGLIGENCE,
ACTUAL OR IMPLIED. The remedies of the Buyer shall be
limited to those provided herein to the exclusion of any and
all other remedies including, without limitation incidental or
consequential damages. No agreement varying or extending
the foregoing warranties, remedies or this limitation will be
binding upon Bacharach, Inc. unless in writing, signed by a duly
authorized officer of Bacharach.
Copyright © 1994-2012 by Bacharach, Inc.
A
Leakator 10
Instruction 0019-9167 i
WARNING!
Because this instrument is used to detect and monitor materials and
conditions which are listed by OSHA or others as potentially haz-
ardous to personnel and property, the information in this manual
must be fully understood and utilized to ensure that the instrument
is operating properly and is both used and maintained in the proper
manner by qualified personnel. An instrument that is not properly
calibrated, operated and maintained by qualified personnel is likely
to provide erroneous information, which could prevent user awareness
of a potentially hazardous situation for the instrument user, other
personnel and property.
If, after reading the information in this manual, the user has questions
regarding the operation, application or maintenance of the instrument,
supervisory or training assistance should be obtained before use. Fac-
tory assistance is available by calling 1-800-736-4666.
WARNING!
The Leakator 10 is not to be used in any application that is beyond
its intended purpose or beyond the scope of its specifications. Failure
to follow this warning can result in personal injury or damage to the
equipment. For details on appropriate use, refer to the general descrip-
tion, application, and operation discussions in this manual.
CONTENTS
Page
1.0 INTRODUCTION ........................................................ 1
2.0 TECHNICAL CHARACTERISTICS........................... 3
3.0 BATTERY INSTALLATION ....................................... 5
4.0 OPERATION................................................................ 6
4.1 Turning ON the Instrument............................ 6
4.2 Taking a Gas Reading...................................... 6
4.3 Using the Earphone ......................................... 8
4.4 Turning OFF the Instrument .......................... 8
5.0 MAINTENANCE ......................................................... 9
5.1 Replacing the Sensor........................................ 9
5.2 Replacing the Printed Circuit Board............. 12
5.3 Replacing the Speaker ................................... 13
5.4 Replacing the Flexible Probe Assembly.........14
6.0 TROUBLESHOOTING............................................... 16
7.0 PARTS/SERVICE........................................................ 17
7.1 Parts List ......................................................... 17
7.2 Bacharach Sales/Service Centers................... 20
8.0 DECLARTION OF CONFORMITY ........................... 21
Leakator 10
Instruction 0019-9167
ii
1.0 GENERAL DESCRITPION AND USE
The Leakator 10 is an intrinsically safe, battery-powered
portable instrument designed to primarily detect the source
of combustible-gas leaks. The instrument is ideally suited
for heating service contractors, utility personnel, and other
users who are interested in pinpointing gas leaks, and test-
ing gas appliances in residential, commercial and industrial
installations.
The instrument is supplied with a durable plastic carrying
case, 20" probe and instruction manual.
The Leakator 10 features:
•Ten bright-red LEDs and a speaker that provide visual
and audible indications to the presence of gas.
Figure 1. Leakator 10
1
IntroductionLeakator 10
Instruction 0019-9167
•Three operation-status LEDs that show power on, sensor
operation, and low battery.
•A 20-inch flexible probe.
•Simple thumb wheel on/off and gain control allowing one-
handed operation.
•A solid-state sensor that has a typical life of 5 years.
•A battery capacity of 30 hours under normal use conditions.
•The ability to detect natural gas (methane) in concentrations
as low as 20 ppm. In addition, the following gases and vapors
are also detectable:
Acetone Ethanol IndustrialSolvents
Acetylene Ethylene Oxide Paint Thinners
Ammonia Gasoline Propane
Benzene Hexane Naphtha
Butane Hydrogen
Introduction
2
Leakator 10
Instruction 0019-9167
WARNINGS!
For safety reasons, the Leakator 10 must only be operated
and serviced by qualified personnel. Read and understand
the contents of this instruction manual before operating
or servicing.
To prevent ignition of a hazardous atmosphere, do not
perform any maintenance work, such as replacing the in-
strument’s batteries, sensor, or sensor-matching resistor,
in an area classified as being hazardous.
Technical Characteristics
3
Leakator 10
Instruction 0019-9167
2.0 TECHNICAL CHARACTERISTICS
Power ..........................Five C-size Alkaline Batteries.
Battery Life ..................Approximately 30 hours of contin-
uous operation under normal-use
conditions.
Sensor:
Type ...........................Solid State, plug-in replacement.
Life Expectancy ......Typically 5 years.
Calibration ..............No user calibration required.
Probe .............................Self storing 20" (51 cm) flexible
probe, includes integral sensor.
Response Time ............Less than 3 seconds to full scale
indication.
Sensitivity ....................20 ppm Methane.
Warm-Up Time ............Approximately 25 to 55 seconds.
Duty Cycle ....................Continuous with no limitation.
Gas Indication .............Visual: 10 red ultra-bright LEDs.
Audible: Variable speed ticking
sound (earphone provided for use
in noisy environments).
Status LEDs .................Power On (green)
Sensor Failure (yellow)
Low Battery (yellow)
Weight ...........................17.8 oz (0.5 kg) (w/o batteries)
Dimensions: ..................8.5" x 2.25" x 1.75"
(21.6 x 5.7 x 4.4 cm)
Operating
Environment:
Position ..................Any
Temperature ..........23° to 130°F (–5° to 54°C)
Humidity .................10% to 90% RH, non-condensing
Safety Approvals .........Intrinsically Safe for use in Class
I, Division 1, Groups A, B, C and
D. CE Mark.
3.0 BATTERY INSTALLATION
WARNING!
Do not replace batteries in a hazardous area.
CAUTION:
To maintain agency approval, use only
NEDA-14A type batteries or equivalent.
Remove battery cover. Install five (non-rechargeable) 1.5V
C-size alkaline batteries per Figure 2 – observe proper polar-
ity. Then reinstall battery cover.
4.0 OPERATION
4.1 Turning ON the Instrument
Turn ON the instrument by rotating its thumb-wheel switch
Technical Characteristics
4
Leakator 10
Instruction 0019-9167
Figure 2. Battery Installation
Battery Installation
5
Leakator 10
Instruction 0019-9167
(Fig 3) clockwise until a click is heard. Observe the following:
•The Power LED lights.
•The Fail LED will light, but should turn off in a few sec-
onds if the sensor is good and properly seated in its socket.
•If the Low Bat. LED is on, replace the batteries per Section
3.0 Battery Installation.
After the instrument stabilizes, rotate the Gain control in the
direction necessary to cause the bottom Gas Level LED to
just turn off. Be sure to always set this control in the same
environment you intend to test in.
The instrument is now ready for use.
4.2 Taking a Gas Reading
To verify that the instrument is operating, sample a known
combustible gas (e.g., a gas-air mixture from an unlit burner
of a natural-gas range). If no response is observed or heard,
refer to Section 6.0 Troubleshooting.
Important! The sensor becomes less sensitive
after being exposed to an excessive amount of
gas. Therefore, after testing the instrument as
described above, leave it on for several minutes
to restabilize the sensor.
Take a gas reading by positioning the end of the instrument’s
flexible probe near the area to be sampled.
The presence of a combustible gas is indicated by a column of
ten red LEDs and a speaker. The number of lighted LEDs gives
visual indication of the relative gas level, while the speaker
produces clicking sounds, similar to a Geiger counter, that
increase in repetition rate as the gas concentration goes up
in relation to the instrument’s gain setting.
The instrument’s sensitivity to gas concentrations is adjusted
by means of its thumb-wheel Gain control. Clockwise rotation
increases sensitivity, while counterclockwise rotation decreases
sensitivity. The Gaincontrol is useful in pinpointing large leaks
by starting with the control set to light 1 or 2 LEDs, and then
gradually rotating the control counterclockwise as the probe
gets closer to the leak.
Operation
6
Leakator 10
Instruction 0019-9167
Otros manuales para Leakator 10
4
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Equipo de prueba de Bacharach
Bacharach
Bacharach R-22id Manual de instrucciones
Bacharach
Bacharach Flue-Gas Sample Conditioning System Manual de usuario
Bacharach
Bacharach Model 105 Manual de usuario
Bacharach
Bacharach High Performance Oilless Commercial Refrigerant Recovery... Manual de usuario
Bacharach
Bacharach PCA3 Instrucciones de instalación y funcionamiento
Bacharach
Bacharach Tru Pointe Ultra Manual de instrucciones
Bacharach
Bacharach DIOXOR II Manual de usuario
Bacharach
Bacharach ODOROMETER Manual de usuario
Bacharach
Bacharach Informant 2 Manual de usuario
Bacharach
Bacharach ECO-2020 Manual de usuario
Bacharach
Bacharach Refrigerant Recovery System 3600 Manual de usuario
Bacharach
Bacharach The Informant2 Manual de instrucciones
Bacharach
Bacharach Fyrite INSIGHT Manual de usuario
Bacharach
Bacharach Fyrite Pro Manual de usuario
Bacharach
Bacharach Fyrite Pro Manual de funcionamiento
Bacharach
Bacharach Fyrite Pro Manual de funcionamiento
Bacharach
Bacharach OXOR II 19-7037 Manual de usuario
Bacharach
Bacharach Snifit 50 Manual de usuario
Bacharach
Bacharach Monoxor III Manual de usuario
Bacharach
Bacharach Fyrite INSIGHT Manual de instalación y operación
Manuales populares de Equipo de prueba de otras marcas
SMART
SMART KANAAD SBT XTREME 3G Series Manual de usuario
Agilent Technologies
Agilent Technologies BERT Serial Manual de usuario
Agilent Technologies
Agilent Technologies N3280A Manual de usuario
Vernier
Vernier Go Direct Voltage Manual de usuario
Lifeloc
Lifeloc R.A.D.A.R. Manual de usuario
Fluke
Fluke T5-600 Instrucciones de funcionamiento e instalación
