Autrol APT 3000 Series Manual de usuario
Quick Start Guide
APT 3000 Series
© Autrol Corporation of America
02
03
This manual covers mainly the functional needs for powering and configuring 3100 A/D/G/H &
3200 A/G series transmitters, including the 3100 MP & 3100 L/ 3200 L sealed assemblies.
For full instructions on installation, configuration and other features/option sets available with these trans-
mitters please read the full product manuals available under the download tab of
www.autroltransmitters.com.
Additional instructional videos outlining programming and configuration functionalities can also be found
on www.autroltransmitters.com. First time users are encouraged to make use of these support resources
made available at no cost online.
For additional technical support or advanced troubleshooting please contact your nearest Autrol office or
call 1-847-779-5000.
04
05
Getting Started
Before installation check the model, specifications, and installation location for the transmitter. Install
using proper engineering practice.
Mount transmitter securely and stabilize any impulse piping.
Follow the published pressure and temperature limits for ordered transmitter and options.
For process temperatures ≥212°F, use of adequate impulse lines, capillaries (diaphragm seals), or
cooling elements are recommended.
Set Units, URL, and LRL (in menus 21, 22, and 23 respectively). See full menu tree at end of manual.
After installation of a 3100 D/H/G or 3200 G always perform a Zero Trim (menu 11 - note this is not the
same as Zeroing). Ensure applied process to transmitter is zero before attempting Zero Trim.
Do not perform Zero Trim for 3100 A/ 3200 A (absolute) unless a true zero PV can be applied to these
units. Instead a Zero Adjust (menu 12) is recommended.
Zero Adjust is also recommended for 3100/ 3200 L (tank level application) to compensate for tank noz-
zle offsets.
06
Functional Block/Sensor Part Diagram
APT 3100
07
APT 3200
08
APT 3100 Dimensional Drawing
09
APT 3100 Exploded View
10
APT 3100 MP Dimensional Drawing
11
APT 3100 MP Exploded View
12
APT 3200 Dimensional Drawing
13
APT 3200 Exploded View
14
LCD Screen
The 5 digit LCD screen shows:
Up to 5 digits of measured value
Error code
Units (Normal and Engineering)
Menu and Menu Option
Indication of being in Normal or Engineering mode
Indication of output being Linear or Square Root
Indication of performing a Loop Test
Indication of being in Multi-Drop mode
Mode/Output
Up to 5 Digit
Display
Unit/ Error
Menu
Menu Option
15
The 5 digit LCD screen shows:
Up to 5 digits of measured value
Error code
Units (Normal and Engineering)
Menu and Menu Option
Indication of being in Normal or Engineering mode
Indication of output being Linear or Square Root
Indication of performing a Loop Test
Indication of being in Multi-Drop mode
LCD Screen Rotation
Unscrewing the two screws on either side of the LCD
screen allows for the screen to be rotated 90° clock-
wise or counterclockwise.
16
LCD Screen Display Error Codes
17
18
Fail-Mode
AUTROL® Smart Pressure Transmitters automatically perform real time self-diagnostic routines and
display any error codes on the local LCD (M1 option if ordered) that can be used for troubleshooting.
In addition to this, the self-diagnostic routines are also designed to drive transmitter current output
outside of the normal saturation values in case a fault mode is detected. The transmitter will drive its
current 4-20mA output low (down) or high (up) based on the position of the failure mode alarm jumper
(or DIP switch) configured in line with NAMUR requirements.
19
*For Blind units using DIP
switch on MCU board .
Fail Mode Selecon Jumper
Switch on LCD Module
Este manual sirve para los siguientes modelos
9
Tabla de contenidos
Otros manuales de Transmisor de Autrol
Autrol
Autrol APT 3100 Series Manual de usuario
Autrol
Autrol APT 3100 Series Manual de usuario
Autrol
Autrol APT3200 Series Manual de usuario
Autrol
Autrol APT3200 Series Manual de usuario
Autrol
Autrol APT3200 Series Manual de usuario
Autrol
Autrol ALT-6100 Series Manual de usuario
Autrol
Autrol ATT Series Manual de usuario
Autrol
Autrol ATT2100 Manual de usuario
Manuales populares de Transmisor de otras marcas
Dejero
Dejero EnGo 3x Manual de usuario
Rosemount
Rosemount 4600 Manual de usuario
Speaka Professional
Speaka Professional 2342740 Manual de usuario
trubomat
trubomat GAB 1000 Manual de usuario
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Manual de usuario
Rondish
Rondish UT-11 Manual de usuario
