Audiovox Eddie Bauer PE703 Manual de usuario
PE703
PORTABLE 7" LCD MONITOR AND DVD PLAYER
128-7203
2
NOTICE:
This Product incorporates copyright protection technology that is pro-
tected by method claims of certain patents and other intellectual prop-
erty rights owned by Macrovision Corporation and other rights owners.
Use of this copyright protection technology must be authorized by
MacrovisionCorporation,andisintendedforhomeandotherlimitedview-
ing uses only unless authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.
NOTICE:
An LCD panel and/or video monitor may be installed in a motor vehicle
and visible to the driver if the LCD panel or video monitor is used for
vehicle information, system control, rear or side observation or naviga-
tion. If the LCD panel or video monitor is used for television reception,
video or DVD play, the LCD panel or video monitor must be installed so
thatthese featureswill onlyfunction whenthe vehicleis in‘park’ orwhen
the vehicle’s parking brake is applied.
An LCD panel or video monitor used for television reception, video or
DVD play that operates when the vehicle is in gear or when the parking
brake is not applied must be installed to the rear of the driver’s seat
where it will not be visible, directly or indirectly, to the operator of the
motor vehicle.
3
A. Introduction
Thank you for choosing the PE703 portable DVD player. The main
features include a 7" Wide Screen (16:9Aspect Ratio) Liquid Crystal
Display (LCD)monitor and aDVD player. The unit applies the latest
state of the art electronics and is designed for use in hotels, offices
or your home. The unit is constructed to provide years of reliable,
trouble-free service, and is compact so that you can take it with you
anywhereandis designedforquick andeasyinstallation. Please read
the entire instruction manual supplied with this product prior to using.
The documentation will assist you in installing the system properly to
obtain the best equipment performance. Please save this manual for
later use.
B. Cautions and Warnings
1. Placement
To prevent fire or electric shock, do not expose this appliance to
rain or moisture. Do not place the set on an unstable cart, stand,
tripod,bracket ortable to prevent it from falling. Keepthe unitaway
fromstrong magnets,heatsources, directsunlight, excessivedust.
If the unit is brought directly from a cold to a warm location, mois-
ture may condense inside the unit. When you move it from a cold
to a warm location, wait for about one hour before operating the
unit, or remove the disc and leave the unit turned on until the mois-
ture evaporates.
2. Installation
Ensure that the PE703 is installed in accordance with the instruc-
tions and illustrations provided in this manual.
3. Caution
Do not push objects of any kind into the unit through openings; do
not spill or spray liquid of any kind on or in the system (this may
result in a fire or electric shock). Do not place anything heavy on
4
the unit. To ensure proper ventilation and proper operation, never
cover or block and openings with a cloth or other material. Keep
the unit away from an open flame such as,.fire, candle etc,. It is
hazardous to replace the battery incorrectly. Replace the battery
only with the same or equivalent type, in order to protect the
enviromnent,please dispose the battery properly. Do not use the
unit in temperatures higher than 104 degrees Fahrenheit or 40 de-
grees Celcius.
4.Disassemble
Do not attempt to disassemble the cabinet. There is a risk of elec-
tric shock and/or exposure to Laser Radiation. Contact qualified
service personnel if your system needs repair.
5. Cleaning Unit
Whencleaning,makesurethe system isunplugged fromthepower
source. Do not use liquid cleaners or aerosol cleaners. Use a cloth
lightly dampened with water for cleaning the exterior of the system
only.
6. Disc
Do not use irregularly shaped discs such as heart or star-shaped
discs as they may cause the unit to malfunction. Do not stick pa-
per, tape or glue on the disc. Do not expose the disc to direct sun-
light or heat sources. Do not touch the surface of disc. Handle the
disc by its edge. Clean the disc by wiping the disc from the center
out with a cleaning cloth. Remove the disc from the unit and store
it in its case after playing. Some playback operations of discs may
be intentionally fixed by software producers. Since this unit plays
discs according to the disc contents the software producers de-
signed, some playback features may not be available.Also refer to
the instructions supplied with the discs.
5
C. Contents
1. 1 x 7’’ LCD Monitor & DVD Player Combo
2. 1 xAC to DCAdapter
3. 1 x Remote Control with battery (CR2025)
4. 1 x Instruction Manual
5.1 xAudio/VideoCable
6. 1 x DC PowerAdapter
7. 1 x Rechargeable Battery
D. Powering and installation
1. Powering the system indoors (Refer to Figure 1)
Plug one end of the AC to DC adapter into the DC 9V jack on the
rightsideof themainunit, thenplugthe otherendinto the 120V AC
power outlet.
2. Powering the system in a car (refer to Figure 1)
Plug one end of the DC power adapter into the DC 9V jack on the
unit, then plug the other end into the vehicle power socket.
Figure 1
6
E. Controls, Indicators, and Connectors
1. Unit View (Refer to Figure 2)
Figure 2
1)MENU Button
2) Up Button
3) Left Button
4) Down Button
5) OK Button
6) Right Button
7) Open Button
8) Skip- Button
9) Stop Button
10) Skip+ Button
11) Play Button
12) Pause Button
13) Screen Mode Button
14) LCD Panel Shut Off Switch
15) Remote Control Sensor
16) Power Indicator
17) Video output Jack
18) DVDAudio output Jack
19)Video Input Jack
20)AudioInputJack
21) Power On/Off Switch
22) Volume Control
23) Headphone Jack 2
24) Headphone Jack 1
25) DC 9V Input Jack
26) Brightness Control
1
2
3
4
65 78910
11
12
13
14 15
16
17181920
21 22 2324 25
26
7
2. Remote Control View (Refer to Figure 3)
1) Display Button
2) Angle Button
3) Subtitle Button
4) Audio Button
5) Zoom Button
6) UP/DOWN/LEFT/RIGHT/
ENTER Buttons
7) Return Button
8) A-B Button
9) Forward Button
10) Reverse Button
11) Slow Button
12) Stop Button
13) Numeric Keypad
14) Setup Button
15) Menu Button
16) Repeat Button
17) Skip- Button
18) Skip+ Button
19) Play Button Figure 3
20) Pause Button
F. Loading and Playing a Disc
a. After connecting power to the unit, turn on the DVD player by slid-
ing the power switch to the on position. The power indicator will
light.
b. Open the disc tray by pressing OPEN, and place a disc into the
tray with the label side facing up.
c. Close the tray by pressing the “PRESS” area on the door. The unit
will load the disc and start playing.
d. Rotate BRIGHTNESS and VOLUME to adjust the LCD’s bright-
ness and the DVD player’s volume.
e. To stop playing a disc, press STOP.
8
G. SETUP
Press ‘SETUP’ to display the Main screen of the SETUP Menu on the
screen. Press ‘SETUP’ again to exit the SETUP Menu and the unit
will resume it’s last playback mode.
Main Setup Menu Screen Display
1) Press ‘SETUP’, the ‘General Setup Page’ will display on screen.
a).Select ‘TV Display’ using the UP/DOWN button, and then press
RIGHTto enterthe submenu. Selectthe TVdisplay modeon the
screen using UP/DOWN, and press ENTER to confirm the set-
ting. Press LEFT to return.
* Normal/PS: When the player is connected to a normal TV, and
a wide picture is shown on the full screen.
* Normal/LB: When the player is connected to a normal TV, and
a wide picture is shown on the screen with a black strip at both
the top and bottom of the screen.
* Wide: When the player is connected to a wide screen TV, a
wide picture is shown on the full screen.
TV Display Screen Display
9
b).Select ‘Angle Mark’ using the UP/DOWN buttton, and then press the
RIGHT button to enter the submenu. Choose Angle Mark on or off
using the UP/DOWN button and then press ENTER to confirm the
setting. Press the LEFT button to return.
Angle Mark Screen Display
* On: The screen will show the angle mark icon. (*If an angle
optionis available).
Off: The screen will not display theAngle Mark
NOTE: Not all discs contain the features above. The above
features are disc dependent.
c). Select ‘Screen Saver’ using the UP/DOWN button.
Screen Saver Screen Display
*On: Enable screen saver
*Off: Disable screen saver (off)
*NOTE: The DVD player will enter the Screen Saver mode after ap-
proximately five minutes if the same image remains on the screen.
10
d). Select ‘Last Memory’ by UP/DOWN button.
Last Memory Screen Display
*On: The unit will return to the last position on the disc.
*Off: The unit will not return to the last position on the disc.
2) Select “Video Quality Setup”by using the LEFT/RIGHT button, press
ENTER to enter the video quality setup page.
Video Quality Setup Menu Screen Display
a).Select ‘Brightness’ by using the UP/DOWN button, then press EN-
TER you can change the Brightness by pressing the LEFT/RIGHT
button. To exit Brightness Setting, press ENTER again to return
themain Menu.
Brightness Screen Display
State
Tabla de contenidos
Otros manuales de Monitor de Audiovox
Audiovox
Audiovox LCM-5600NP Manual de usuario
Audiovox
Audiovox LCM45NB Manual de usuario
Audiovox
Audiovox LCM-4000 Manual de usuario
Audiovox
Audiovox LCM-0565 Manual de usuario
Audiovox
Audiovox MZ7TFT Manual de usuario
Audiovox
Audiovox LCM1700TV Manual de usuario
Audiovox
Audiovox LCM-5600 Manual de usuario
Audiovox
Audiovox AVXMTG10U Manual de usuario
Audiovox
Audiovox GMRS1100 Manual de usuario
Audiovox
Audiovox AVX10USB Manual de usuario
Audiovox
Audiovox VOH1012 S Manual de usuario
Audiovox
Audiovox VBDV56 Manual de usuario
Audiovox
Audiovox LCM45NB - LCM 45NB - LCD Monitor Manual de usuario
Audiovox
Audiovox LCM58N Manual de usuario
Audiovox
Audiovox AOM562A Manual de instrucciones
Audiovox
Audiovox ACAM350 Guía de instalación
Audiovox
Audiovox LCM-0505 Manual de usuario
Audiovox
Audiovox ACAM250 Manual de instrucciones
Audiovox
Audiovox LCM50 Manual de usuario
Audiovox
Audiovox AVM6781 Manual de usuario
