AUDAC CSE55 Instrucciones de instalación y funcionamiento
PROFESSIONAL AUDIO EQUIPMENT
Ceiling Speaker + Signal LED CSE55
UserManual&InstallationGuide
Ceilingspeaker
+SignalLED
CSE55
AUDAC
1
A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T
User Manual & Installation Guide
AUDAC
http://www.audac.eu
info@audac.eu
2
Introduction
The CSE55 is a single cone loudspeaker with an integrated red signal light with 6 integrated high intensity
LEDS (24 V), which emit a visual evacuation signal. The ceiling speaker is specially designed to deliver high-
quality speech reproduction, but can also be used for background music. It is standard fitted with a 100 Volt
line transformer with connections for different powers. The speaker combines professional audio equipment
with great design and comfort.
Warning
Only use the correct amplifier output voltage and impedance, exceeding these limits could cause fire
or other failures.
Avoid explosions: do not use the speaker around gasoline, thinner or other combustibles.
Only install the speaker in locations that can structurally support the weight of the speaker and the
mounting bracket. Not doing this may result in the speaker falling down.
Do not use any other method than specified to mount the bracket. If extreme force is applied to the
speaker,
it could fall down.
Avoid mounting the speaker in locations exposed to constant vibrations. The mounting bracket can be
damaged by excessive vibration, potentially causing the speaker to fall down.
Caution
Avoid electric shocks: switch off the amplifier power when connecting the speaker.
Avoid installing the speaker in locations exposed to solvents, acids, smoke and heaters, as excessive
exposure to these factors could result in speaker failure, fire or electric shock.
Do not operate the speaker for an extended period of time at distorted sound. This could cause
(irreparable) damage to the speaker.
Do not stand or sit on it, nor hang down from the speaker as this may cause it to fall down or drop.
3
Installation
Make a hole with a diameter of 165mm. This is very easy when you use the carton that is inside of the
box.
Take the grille from the speaker and put the speaker in the hole.
Tighten the screws of the speaker so that the speaker will be clasped on the ceiling or wall.
Inside of the box, you can find gums. Put these gums on the sides of the grille. Then put the grille on
the speaker. The gums on the sides of the grille will prevent the grille from falling down.
Connections
Impedance
Connect the speaker according to the desired power, according to the following scheme.
Connect the power supply for the LED also according to the following scheme. Pay attention that
you don’t put power on the inputs of the speaker.
If you use different speakers in the same place, make sure that you use the same polarity for all the
speakers.
The total power of all connected speakers may not exceed the output power of the amplifier.
4
Technical specifications
Speaker
Nominal Speaker Power: 15 W
Sound pressure: 1W / 1m 90 dB
Maximum SPL: 100.8 dB
Impedance Loudspeaker: 8 Ohm
Impedance line transformer: 1.600 Ohm/ 6 W
3.300 Ohm/ 3 W
6.600 Ohm/1.5 W
Frequency range: 70 - 14.000 Hz
Outside diameter: 200 mm
Installation depth: 70 mm
Cut-out measurement: 165 mm
Color: White RAL 9010
Weight: 1 kg
Option Available in other RAL colors
LED
Power: 24V (20V-30V)
Current: 45mA (@ 24V)
Angle: 120°
Light Intensity: 24 lumen
Color: Red
Dimensions (Diameter x Height): Ø 44 mm x 24 mm
Weight : 17 gr.
Housing: White ABS bottom with transparent cap.
Length connection cables : 80 mm
Tabla de contenidos
Otros manuales de Oradores de AUDAC
AUDAC
AUDAC CS75 Manual de usuario
AUDAC
AUDAC WX502B Instrucciones de instalación y funcionamiento
AUDAC
AUDAC KYRA24 Guía
AUDAC
AUDAC VEXO112A Manual de usuario
AUDAC
AUDAC CALI Series Manual de usuario
AUDAC
AUDAC ATEO4 Manual de usuario
AUDAC
AUDAC ARES5A Manual de usuario
AUDAC
AUDAC VIRO5 Manual de usuario
AUDAC
AUDAC AWP06 Manual de usuario
AUDAC
AUDAC WX Series Guía
AUDAC
AUDAC MERO5 Guía
AUDAC
AUDAC HS208MK2 Guía
AUDAC
AUDAC Ateo 6 Guía
AUDAC
AUDAC SPRING-FIT CENA812 Manual de usuario
AUDAC
AUDAC HS212MK2 Guía
AUDAC
AUDAC WS500 Manual de usuario
AUDAC
AUDAC VEXO1 A Series Manual de usuario
AUDAC
AUDAC MBK523/G Manual de usuario
AUDAC
AUDAC SPRING-FIT CENA306 Manual de usuario
AUDAC
AUDAC WX802/OB Instrucciones de instalación y funcionamiento
