AUDAC AWP06 Instrucciones de instalación y funcionamiento

PROFESSIONAL AUDIO EQUIPMENT

In-wall Ceiling Speaker AWP06

UserManual&InstallationGuide

CeilingSpeaker

AWP06

AUDAC

A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T

User Manual & Installation Guide

AUDAC

http://www.audac.eu

info@audac.eu

INTRODUCTION...............................................................................................................................................................................................................3

WARNING-CAUTION.......................................................................................................................................................................................................4

INSTALLATION ...............................................................................................................................................................................................................5

CONNECTIONS.................................................................................................................................................................................................................5

ADDITIONAL INFORMATION.......................................................................................................................................................................................6

TECHNICAL SPECIFICATIONS ..............................................................................................................................................................................6

Index

Introduction

With the AWP06 is you have purchased a state-of-the-art ceiling speaker. The speaker was

specially designed to provide high-quality sound in a variety of in- and outdoor

applications and damp locations. Its wide, smooth frequency response and high efficiency

ensure high-fidelity music reproduction and intelligible speech at very low distortion. The

housing is made of strong, white ABS material and is waterproof. The AWP06 can be used

in a 100V PA system with tapping for 6 W or 3 W or in low impedance systems 8 Ohm/6

W. The AWP06 ceiling speaker meets the IP65 standards.

Warning

Use only the correct amplifier output voltage and impedance, exceeding these limits

could cause fire or other failures.

Avoid explosions: do not use the speaker around gasoline, thinner or other

combustibles.

Only install the speaker in locations that can structurally support the weight of the

speaker. Not doing this may result in the speaker falling down.

Do not use any other method than specified to mount the speaker. If extreme force is

applied to the speaker, it could fall down.

Attach a safety wire to the speaker when it is mounted high above the ground. Failure

in doing so could cause the speaker to fall down for any reason.

Avoid mounting the speaker in locations exposed to constant vibrations. The

mounting points can be damaged by excessive vibration, potentially causing the

speaker to fall down.

Caution

Avoid electric shocks: switch off the amplifier power when connecting the speaker.

Avoid installing the speaker in locations exposed to solvents, acids, smoke and

heaters, as excessive exposure to these factors could result in speaker failure, fire or

electric shock.

Do not operate the speaker for an extended period of time at distorted sound. This

could cause (irreparable) damage to the speaker.

Do not stand or sit on, nor hang down from the speaker, as this may cause failure of

the speaker.

Installation

Make a hole with a diameter of 140 mm This is very easy when you use the carton

that is inside of the box.

Install the unit only in a ceiling made of strong material so that the mounting springs

don’t damage the ceiling. For weak ceiling panels you can use a wooden plank to the

ceiling in which you can make the mounting hole.

Connections

Cable

Be sure that you use the following polarities for your speaker cable, when using

several speakers in the same location:

Red: Negative or common

Black: Positive

The total rated input of all connected speakers may not exceed the amplifiers

output.

Additional information

Technical Specifications

RMS Power 6 W

Max Power 10 W

Impedance 8 Ohm

Line transformer power tappings 6 W / 1666 Ohm

3 W / 3333 Ohm

1,5 W / 6666 Ohm

Sound pressure 1W / 1m 87 dB

Sound pressure max W / 1m 95 dB

Frequency response -3 dB 100 Hz –15 kHz

IP Rating 65

Driver 4”

Dimensions ( H x Diam.) 130 x 140 mm

Built-in depth 130 x 140 mm

Cut-out measurement 125 mm

Weight 0,95 Kg

Colour White

Otros manuales para AWP06

Tabla de contenidos

Otros manuales de Oradores de AUDAC

Manuales populares de Oradores de otras marcas

argon audio

argon audio IE20 Manual de usuario

Denon

Denon SC-N7 Manual de usuario

Gemline

Gemline Ace 3952 Manual de usuario

Focal

Focal ON WALL 300 Manual de instrucciones

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manual de usuario

SoundLogic

SoundLogic BCCS-6/6395 Manual de usuario

Peavey

Peavey DTH 218 Manual de usuario

Avantree

Avantree Pluto Air Manual de usuario

Morel

Morel Integra Series INTEGRA OVATION 4 Manual de usuario

Oppo

Oppo SONICA Manual de usuario

Bose

Bose SoundLink Wireless Music System Manual de usuario

Rocksteady

Rocksteady Stadium Manual de usuario

Bowers & Wilkins

Bowers & Wilkins 4 Manual de usuario

Sonance

Sonance SONOS OUTDOOR Series Manual de usuario

Electro-Voice

Electro-Voice EVID FM4.2 Manual de usuario

Pioneer

Pioneer XW-HTD630 Manual de usuario

Onn

Onn BWA16AA002 Manual de usuario

HP GL313AA - USB Speakers PC Multimedia Manual de usuario