Auber Instruments KIT-RSPb Manual de usuario

KIT-RSPb Installation Guide

Version 1.4

Auber Instruments, 730 Culworth Manor, Alpharetta, GA 30022

e-mail: [email protected] Tel: 770-569-8420

www.auberins.com

This is a PID controller kit installation guide solely distributed to our clients, who have

purchased the KIT-RS kit. Once you are done with this guide, please send us your feedback,

comments, and/or suggestions (via e-mail to auberins@gmail.com) so that we may continue

making improvements to this guide. Your help is greatly appreciated!

Note: Please read through the entire guide before attempting any kind of installation.

Disclaimer:

This product was created and distributed by Auber Instruments Inc. Everything included in this

guide (images, text, etc.) is the intellectual property of Auber Instruments Inc. Thus, this guide is

not to be replicated, altered, or sold without express written permission from Auber Instruments

Inc. If you did not receive this document from Auber Instruments Inc, please let us know as it is

subject to inaccuracy and/or obsolescence. The Rancilio Silvia names and trademarks are owned

by Rancilio Macchine per caffè. S.p.A.

The modifications of Rancilio Silvia involve tampering with high-wattage electrical circuits in a

wet environment, which could result in electric shock, burns, other serious personal injury or

death, as well as fire, explosion and other property damage. This kit is for users with proper

electrical safety knowledge only. Attempting to access your espresso machine will void its

warranty. You, the user, will assume full responsibility for any modifications undertaken. Auber

Instruments Inc is not liable for any damage caused to your property as a result of improper use.

Parts Identification.

Figure 1. PID Controller, Aluminum extrusion box, rubber grommet, double sided tape

pre-assembled - Front view on left. Back view on right.

Figure 2. Dual Solid State Relay (SSR), mounting screw, nut and washer. The dual SSR

in the kit contains two SSRs in one package. The left side will be used for steam control

and the right side will be used for brew control.

Figure 3. Pair of red cables for connecting SSR output to the cables that used to be on

the brew thermostat. They are terminated with female disconnect on end and male

disconnect on the other.

Figure 4. Pair of black cables for connecting SSR output to the cables that used to be on

the steam thermostat. They are terminated with female disconnect on end and male

disconnect on the other.

Figure 5. Cables for connecting controller brew control output to SSR brew control

input. Red cable is for positive. White cable is for negative. They are terminated with

female disconnect terminal on one end.

Figure 6. Cables for connecting controller steam control output to SSR steam control

input. Red cable is for positive. Blue cable is for negative. They are terminated with

female disconnect terminal on one end.

Figure 7. Cables for tapping power to controller. One black and one brown color,

terminated with piggyback connector on one end.

Figure 8. The RTD temperature sensor..

Figure 9. Cable ties

Figure 10. Brew pump control cable. Green

Figure 11. Left, silicone heat transfer compound (white paste in the vial) for SSR and

sensor, Middle, RTD jumper cable, white. Right, jumper cable for brew pump control,

black.

Figure 12. Controller box ground wire. Green

Procedure

A. Preparation for installation.

1) Disconnect the power cord from power outlet. Remove the water tank, portafilter, and drip

tray.

2) Remove the top cover after removing the screws indicated by the red arrows in Figure 13.

Pull out the top panel.

Figure 13. Top panel. Red arrows indicate the screws that hold the top panel.

B. Install SSR.

1) Remove the back panel of the machine after removing the two screws indicated in Figure 14a.

Loosen the screw indicated in Figure 14b by several turns (do not remove it). The back panel

can be removed by sliding it back and lifting up.

Figure 14a. Red arrow indicates the screw that hold back panel.

Figure 14b. The screw on the bottom of machine that holds the back panel (Red arrow).

2) Remove the protecting panel for the pump after removing the two screws indicated in Figure

15.

Figure 15. Screws that hold the protecting panel for the pump.

3) Mounting the SSR on the first hole from left. Apply small amount of thermal conductive

grease to the bottom of the SSR. Place it on the metal. The screw and washer should be

installed from the bottom of the base as shown in Figure 16a and 16b.

Figure 16a. SSR mounted on the base.

Figure 16b. Bottom view of the SSR mounting screw.

C. Connecting SSR Cables and Grounding Wire.

1) Connecting the cables to SSR as shown in Figure 17. The left side is for steam temperature

control. The two black cables are connected to the output. The blue cable is connected to the

negative of the input. Red cable is connected to the positive of the input. The right side is for

the brew temperature control. The two red thick cables are connected to the output. The

white cable is connected to the negative of the input. Red cable is connected to the positive

of the input.

Figure 17. Connection of the cables to SSR

2) There are two thermostats on top of the boiler as shown in Figure 18. The blue arrow points

to the brew control thermostat (it has a red dot on the top). The two cables on it have been

removed. One is the gray cable on top and other is the red cable below. These cables are

going to be connected to the red cables from the SSR output. The green arrow points to the

steam control thermostat. The cables on it need to be removed and connected to the black

cables from the SSR output.

Figure 18. Brew control thermostat and steam control thermostat

3) As shown in Figure 19, the blue arrows show the red cables from SSR output are connected

to the cables originally were on the brew control thermostat. The green arrows show the

Tabla de contenidos

Otros manuales de Controladores de Auber Instruments

Auber Instruments

Auber Instruments HD220-W Instrucciones y recetas

Auber Instruments

Auber Instruments TH220A Manual de usuario

Auber Instruments

Auber Instruments DSPR400 Manual de usuario

Auber Instruments

Auber Instruments SYL-3615 Manual de usuario

Auber Instruments

Auber Instruments WS-1500A Guía del administrador

Auber Instruments

Auber Instruments SYL-3615 Manual de usuario

Auber Instruments

Auber Instruments DSPR300 Manual de usuario

Auber Instruments

Auber Instruments WS-1500EPM Guía del administrador

Auber Instruments

Auber Instruments SYL-2381-SSR Manual de usuario

Auber Instruments

Auber Instruments EZboil DSPR310 Manual de usuario

Auber Instruments

Auber Instruments EZboil DSPR120 Manual de usuario

Auber Instruments

Auber Instruments AUB6500 Manual de usuario

Auber Instruments

Auber Instruments EZboil DSPR310D Manual de usuario

Auber Instruments

Auber Instruments KIT-CUBE2S Manual de usuario

Auber Instruments

Auber Instruments EZboil DSPR320 Manual de usuario

Auber Instruments

Auber Instruments KIT-Cube5E Manual de usuario

Auber Instruments

Auber Instruments HD220 Manual de usuario

Auber Instruments

Auber Instruments SYL-2362B Manual de usuario

Auber Instruments

Auber Instruments HD330 Manual de usuario

Auber Instruments

Auber Instruments AW-SYL-2352 Manual de usuario

Auber Instruments

Auber Instruments SYL-2615 Manual de usuario

Auber Instruments

Auber Instruments EZboil DSPR310D Manual de usuario

Auber Instruments

Auber Instruments SYL-53 2P Series Manual de usuario

Auber Instruments

Auber Instruments Auberins KIT-GGP Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario