Page 3
© 2001-2014 attocube syste s AG. Product and co pany na es listed are trade arks or trade na es of their respective
co panies. Any rights not expressly granted herein are reserved. ATTENTION: Specifications and technical data are subject
to change without notice.
Table of Contents
List of Abbreviations..........................................................................5
I.
Introduction ..........................................................................7
I.1.
Syste Overview.................................................................7
I.2.
Safety Infor ation..............................................................8
I.2.a.
Safety Sy bols on the Equip ent ....................................8
I.2.b.
Safety Sy bols in this Manual .........................................9
I.2.c.
Warnings .................................................................. 10
I.3.
Declarations of Confor ity ................................................. 11
I.4.
Waste Electrical and Electronic Equip ent (WEEE) Directive ....... 12
II.
Setup Procedure.................................................................... 13
II.1.
Mechanical Installation...................................................... 13
II.1.a.
Positioning .............................................................. 13
II.2.
Electrical Installation ........................................................ 13
II.2.a.
Connecting to the Voltage Supply ................................. 13
II.2.b.
Fuses...................................................................... 14
II.3.
Front Panel Controls and Indicators ...................................... 16
II.4.
Back Panel Connections ..................................................... 18
II.4.a.
How to connect a positioner ........................................ 18
II.5.
Pin Assign ent ................................................................ 20
II.5.a.
Trigger Port.............................................................. 20
III.
Description of the Controller and General Use .............................. 21
III.1.
Overview......................................................................... 21
III.2.
Main Graphical User Interface.............................................. 22
III.2.a.
Start-up Screens ......................................................22
III.2.b.
General Usage of the ANC300 GUI ................................ 23
III.2.c.
Main Configuration Dialogs......................................... 23
III.2.d.
Feature Codes.......................................................... 24
III.2.e.
Network Configuration Dialog ..................................... 24
III.2.f.
Trigger Configuration Dialog ....................................... 25
III.2.g.
Li its Configuration Dialog........................................ 26
III.3.
ANM300 Module ............................................................... 27
III.3.a.
ANM300 Front Panel Usage......................................... 28
III.3.b.
ANM300 Axis Screen Ele ents and Usage ...................... 29
III.3.c.
Stepping Functionality .............................................. 30
III.3.d.
Offset Voltage Functionality ....................................... 31
III.3.e.
DC-IN Functionality .................................................. 32
III.3.f.
AC-IN Functionality ................................................... 33
III.3.g.
Filter Settings ......................................................... 33
III.3.h.
GND Functionality .................................................... 34
III.3.i.
Capacitance Measure ent .......................................... 35
III.3.j.
Li it Functionality.................................................... 36
III.4.
ANM150 Module ............................................................... 38
III.4.a.
ANM150 Axis Screen Ele ents and Usage ...................... 39
III.5.
ANM200 Module ............................................................... 40
III.5.a.
ANM200 Axis Screen Ele ents and Usage ...................... 41
IV.
Re ote Control of the ANC300 ................................................. 43
IV.1.
Connecting the ANC300 ..................................................... 43
IV.1.a.
Ethernet Connection.................................................. 43
IV.1.b.
USB Slave Port ......................................................... 43
