Atmel CAP AT91CAP7X-DK Manual de usuario

The AT91CAP7X-DK development board implements the fixed portion of the AT91CAP7 device as a

microcontroller standard product, tightly coupled to a high-density FPGA that emulates the MP Block.

The boards also include a range of memories and physical interfaces/connectors representing

external system components. This configuration enables parallel hardware/software testing of

the application under development at close to operational speed, with no

penalty for hardware modifications. This enables software development

to proceed in parallel with hardware development, and significantly

reduces the design cycle time, increasing confidence in a right-first-time

system solution.

The AT91CAP7X-DK development board or “kit” is composed of three

associated boards, namely Motherboard, Mezzanine and Memory

Extension to be used jointly in order to develop AT91CAP7 processor

applications.

AT91CAP7X-DK Motherboard

The AT91CAP7X-DK motherboard features the following on-board interfaces:

AT91CAP7X-DK Development Kit

for CAP Customizable Microcontroller

CAPTM CUSTOMIZABLE MICROCONTROLLERS

nATX power supply connector

n2x Full-speed Host USB interfaces

n100-base TX Ethernet PHY with three status

LEDs

nDBGU serial communication port

n4x analog inputs

nAC97 interface with three 3.5 mm audio jack

connectors (MIC IN, LINE IN, LINE OUT)

nI2S audio codec with two 3.5 mm audio jack

connectors (LINE IN, LINE OUT)

n2x SD/MMC card slots

nAtmel TWI serial EEPROM

n1/4 inch TFT LCD VGA interface

nTouch Screen Controller

nImage Sensor expansion connector

n16 push buttons arranged in a keypad form

nCAN bus interface

nSoftware controlled Power LED

n2x general-purpose LEDs

nPIO expansion connectors (PIOA, PIOB, PIOC,

PIOD)

nCAP Mezzanine extension connectors

(2x 320 pins)

nPCI64 form FPGA I/O extension connector

nCustom mezzanine-style FPGA I/O extension

connector

n3x USB device PHY interfaces with USB B

connectors (FPGA controlled)

Headquarters

Atmel Corporation

2325 Orchard Parkway

San Jose, CA 95131

USA

TEL 1 (408) 441-0311

FAX 1 (408) 487-2600

International

Atmel Asia

Room 1219

Chinachem Golden Plaza

77 Mody Road Tsimshatsui

East Kowloon

Hong Kong

TEL (852) 2721-9778

FAX (852) 2722-1369

Atmel Europe

Le Krebs

8, Rue Jean-Pierre Timbaud

BP 309

78054 St.-Quentin-en-Yvelines

Cedex, France

Tel: (33) 1-30-60-70-00

Fax: (33) 1-30-60-71-11

Atmel Japan

9F, Tonetsu Shinkawa Bldg.

1-24-8 Shinkawa

Chuo-ku, Tokyo 104-0033

Japan

TEL (81) 3-3523-3551

FAX (81) 3-3523-7581

Product Contacts

Technical Support

www.atmel.com/products/AT91CAP

Sales Contacts

www.atmel.com/contacts

Web Site

www.atmel.com

Atmel®, logo and combinations thereof,

and others, are registered trademarks,

CAP™ and others are trademarks of

Atmel Corporation or its subsidiaries.

ARM®and ARM7TDMI®are registered

trademarks of ARM Ltd. Other terms

and product names may be trademarks

of others.

REV.: 8522A-03/08

Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with

the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR

STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL

ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF

INFORMATION) ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the

accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information

contained herein. Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications

intended to support or sustain life.

AT91CAP7X-DK Development Kit

for CAP Customizable Microcontroller

The CAP Customizable Microcontroller

Atmel’s CAP is an ARM microcontroller-based system-on-chip with fast local memory, a wide range

of industry standard peripherals and interfaces, and a Metal Programmable (MP) Block that allows the

designer to add custom logic. By combining the performance, density and low power consumption of

the fixed portion of the device with the flexibility of the MP Block, CAP enables application-specific

products to be developed in a fraction of the time and at a fraction of the cost of standard-cell ASICs,

but at a unit price close to that of standard cell devices. CAP also offers superior performance, smaller

form factor and lower power consumption at a unit price significantly lower than an MCU-plus-FPGA

combination for the same functionality.

AT91CAP7X Features

n160 KB of fast on-chip SRAM

nA large MP Block of 450K ASIC gates (2-input NAND equivalents)

nMicro Core = ARM7TDMI®at 80 MHz

nMPRAM = 2x DPRAM 2K x 16

nROM = 256 KB

nA minimal number of ARM peripherals are instantiated in the fixed portion

of the design to address low cost applications

nFlexibility to instantiate other peripherals in the MP Block using IP

available in Atmel's vast library

Otros manuales de Microcontrolador de Atmel

Atmel

Atmel AVR365 Manual de usuario

Atmel

Atmel AT90USB162 Manual de usuario

Atmel

Atmel AVR XMEGA D Series Manual de usuario

Atmel

Atmel AVR32 STK1000 Manual de usuario

Atmel

Atmel AT91FR40162S Manual de usuario

Atmel

Atmel ATmega32M1 Manual de usuario

Atmel

Atmel AVR XMEGA-A3BU Instrucciones de instalación y funcionamiento

Atmel

Atmel AVR2052 Manual de usuario

Atmel

Atmel SAM L21 Xplained Pro Manual de usuario

Atmel

Atmel AVR AT90S4434 Manual de usuario

Atmel

Atmel AT89STK-03 Manual de instalación

Atmel

Atmel AVR1605 Manual de usuario

Atmel

Atmel AT89RFD-10/EVLB002 Manual de usuario

Atmel

Atmel AT01607 Instrucciones de instalación y funcionamiento

Atmel

Atmel ATmega324PB Manual de usuario

Atmel

Atmel AT88CK101BK8 Manual de instalación

Atmel

Atmel ATmega128 Manual de usuario

Atmel

Atmel megaAVR Manual de usuario

Atmel

Atmel C51 Instrucciones de instalación y funcionamiento

Atmel

Atmel ATtiny26 Manual de usuario

Atmel

Atmel ATSAMB11 BluSDK SMART Manual de usuario

Atmel

Atmel ATSAMB11 BluSDK SMART Manual de usuario

Atmel

Atmel AVR2054 Manual de usuario

Atmel

Atmel ATBTLC1000 BluSDK Manual de usuario

Manuales populares de Microcontrolador de otras marcas

AMS

AMS AS7261 Demo Kit Manual de usuario

Novatek

Novatek NT6861 Manual de usuario

Espressif Systems

Espressif Systems ESP8266 SDK Guía de configuración

Nuvoton

Nuvoton ISD61S00 ChipCorder Guía

STMicrolectronics

STMicrolectronics ST7 Assembler Linker Manual de usuario

Texas Instruments

Texas Instruments Chipcon CC2420DK Manual de usuario

Lantronix

Lantronix Intrinsyc Open-Q 865XR SOM Manual de usuario

NEC

NEC 78GK0S/K 1+ Series Instrucciones de instalación y funcionamiento

Mikroe

Mikroe SEMITECH N-PLC Click Instrucciones de instalación y funcionamiento

Intel

Intel Agilex Manual de usuario

Cypress

Cypress CY4607 HX2VL Manual de usuario

DIGITAL-LOGIC

DIGITAL-LOGIC MICROSPACE Manual de usuario

Texas Instruments

Texas Instruments TMS320F2837 D Series Manual de usuario

CYPRES

CYPRES CY14NVSRAMKIT-001 Manual de usuario

Texas Instruments

Texas Instruments INA-DUAL-2AMP-EVM Manual de usuario

Espressif Systems

Espressif Systems ESP8266EX Instrucciones de funcionamiento

Abov

Abov AC33M8128L Manual de usuario

Laird

Laird BL654PA Manual de usuario