Asus G1S Manual de usuario

Otros manuales para G1S

1

Tabla de contenidos

Manuales populares de Computadora portátil de otras marcas

HP

HP ze2401xt - Pavilion Notebook PC Manual de usuario

Velocity

Velocity NoteMagix M10 Manual de usuario

Dell

Dell Alienware 17 R2 Manual de usuario

Toshiba

Toshiba A105-S2236 Manual de usuario

HP

HP ENVY 17 Manual

Winbook

Winbook LM Manual de usuario

Dell

Dell Inspiron 1464 Manual de usuario

Dell

Dell Inspiron 15R 5537 Manual de usuario

HP

HP PROBOOK 4520S Manual

Dell

Dell Latitude ATG D620 Manual de usuario

Sony

Sony VAIO PCG-FX270 Manual de usuario

Dell

Dell Latitude 7310 Manual de usuario

Dell

Dell Precision GU806 Manual de usuario

Sony

Sony VAIO PCG-R505JLK Manual de usuario

Lenovo

Lenovo THINKPAD X32 Manual de usuario

HP

HP Compaq tc4200 Guía de inicio rápido

Toshiba

Toshiba mini NB300 Manual de usuario

Lenovo

Lenovo ThinkPad X201 Tablet Manual

Disassembly procedure

2 - 1

Disassembly Procedure

Please follow the information provided in this section to perform the complete

disassembly procedure of the notebook. Be sure to use proper tools described

before.

SUS G1S Series Notebook consists of various modules. This chapter describes the

procedures for the complete notebook disassembly. In addition, in between procedures,

the detailed disassembly procedure of individual modules will be provided for your service

needs.

The disassembly procedure consists of the following steps:

•Battery Module

•CPU Module

•Memory Module

•HDD Module

•Optical Drive Module

•Keyboard Module

•Top Case Module

•LCD Module

•Motherboard Module

•WLAN Module

Chapter

2

A

Disassembly procedure

2 - 2

Battery Module

The illustration below shows how to remove the battery module.

Remove battery module

1．Slide the battery latch 1 to open battery lock

2．Slide the battery latch 2 and pull the whole battery away from the system.

CPU Module

The illustrations below show how to remove the CPU module from the notebook.

Replacement CPU

1. Remove 2 screws (M2*4) and take the CPU door away.

BATTERY

CPU MODULE

REMOVAL

3

1 2

3

M2*4

Disassembly procedure

2 - 3

2. Remove the Mylar.

3. Remove 4 screws (M2*5) aside the CPU. And take away the heat sink..

4. Turn the non-removable screw here 180 degrees counter-clockwise to loosen the CPU.

M2*5

Disassembly procedure

2 - 4

5. Squeeze the vacuum handling pump and use it to lift the CPU away.

Memory Module

The illustration shows how to remove the memory module form the notebook.

Removing Memory module

1. Remove 2 screws on the memory cover and then remove the cover.

2. Unlock two latches to pop up the memory at 45 angles then pull out the memory at that angle.

MEMORY

MODULE

MEMORY

REMOVAL

Disassembly procedure

2 - 5

WLAN Module

The illustrations below show how to remove the WLAN module from the notebook.

Remove WLAN module

1. Disconnect 3 antenna cables, remove 1 piece of tape and remove the antennas out of cable guide;

then unlock two latch and take WLAN out of system;

WLAN

MODULE

Disassembly procedure

2 - 6

HDD Module

The illustrations below show how to remove the HDD module from the notebook.

Removing HDD Module

1. Remove 2 screws (M2*5) here, open HDD door by the tweezers and then take away the HDD

door.

2. Remove the sponge and pull the hard disk module toward the direction of the arrow and lift it up

and take it out.

Optical Drive Module

1. Unlock and hold the latch, and remove the ODD module.

HDD

MODULE

HDD

MODULE

REMOVAL

OPTICAL

DRIVE

REMOVAL

Disassembly procedure

2 - 7

Keyboard Module

The illustration of below shows how to remove the keyboard

Removing Keyboard

1. Remove 2 screw (M2*5) here, and then turn over the notebook.

2. Push the 3latches in (F1, F8, Ins) with a pair of tweezers or a single-slotted screwdriver

and lift the keyboard plate up.

3. Lay the keyboard down over the Top case. *Do not remove the keyboard yet.

The keyboard cable is still attached.

KEYBOARD

Disassembly procedure

2 - 8

4. Disconnect the FPC connector by a pair of tweezers and then remove the keypad plate.

Removing Keyboard Cable

1. Use a flexible connector tool to unlock the cable connector on both ends (no. 1).

2. Carefully pull out the keyboard cable (no. 2) with a pair of tweezers.

3. Lock the connector (no. 3) again to avoid possible breakage.

Top Case Module

The illustrations below show how to disassemble and remove the top case module of the notebook.

The module contains the top case itself.

Removing Top Case Module

1. Remove 6 screws (M2*8; M2*5) here

1. Unlock

2. Cable out

3.

1. Unlock

3.

TOP CASE

MODULE

TOP CASE

REMOVAL

Disassembly procedure

2 - 9

2. Remove the both hinge covers.

3. Remove 2 screws in hames cover, then take the hames cover away.

4. Remove 1 piece of tape fixing the table and then remove 1 screw here, and disconnect the LCD

cable

Disassembly procedure

2 - 10

5. Remove 1 screw here, and disconnect the cable.

6. Remove 2 screws on both end

7. Remove 2 screws beside the system.