Asko HG1615ab Manual de usuario
Instructions for use
Gas hob
HG1615ab / HG6ABE1A
HG1675sb / HG6ABE1B
EN Manual EN 3 - EN 9
Pictograms used:
Important information
Tip
EN 3
OPERATION
Description
Ignition and adjustment
1. zone indication
2. 0 position
3. High setting
4. Low setting
Each burner is fully adjustable between high and low settings.
• Press the control knob and turn it anticlockwise. The burner will ignite.
• Keep the control knob fully depressed for at least 3 seconds
between high and low settings. The thermocouple safety pilot has
been activated.
2
3
4
1
1. standard burner
2. rapid burner
3. simmer burner
4. pan support
5. glass top or stainless steel
drip tray
6. control knob
61
5
3
2
4
1
Top view of appliance
EN 4
Use
Pans
• Always ensure than the flames stay under the pan. A lot of energy
is lost if flames burn around the pan. The handles may also become
too hot.
• Do not use pans with a base diameter smaller than 12 cm. Smaller
pans are not as stable.
Pan support
Place the pan supports vertically, without sliding over the drip tray. Use
the leads to position the pan supports on the drip tray.
Small pan grid
The small pan grid supplied or obtainable as an accessory makes it
possible to use very small pans.
Burner
Use the leads (1) to put together the burner parts.
OPERATION
error
good
small pan grid
1
1
EN 5
MAINTENANCE
Maintenance
Regular maintenance after use prevents spilt food from setting too long
and creating stubborn stains. Use a mild detergent for this. First clean
the control knobs, burners and pan supports and only then the drip tray
or glass cover. This prevents the drip tray or glass cover to becoming
dirty again after cleaning.
Please note! Do not clean burner parts in the dishwasher. Dishwasher
detergent can corrode burner parts!
Persistent stains on enamel (pan supports, burner caps)
Persistent stains can best be removed with a fluid detergent or a plastic
scouring sponge. Never use scouring powder, scouring pads, sharp
objects or aggressive cleaning products.
Persistent stains on the glass cover
Clean the glass cover with a special cleaning product for ceramic hobs.
Water stains or limescale are best cleaned using cleaning vinegar.
Persistent stains on the stainless steel (drip trays)
Persistent stains on stainless steel are best removed with a special
stainless steel cleaning product. Always wipe with the structure of the
steel to prevent scraping away the protective layer (damage caused
in this way does not fall under the guarantee!) The surface of stainless
steel drip trays can discolour slightly over time.
Consult the www.asko.com website for additional maintenance
and cleaning instructions!
EN 6
ERRORS
Fault list
If your gas hob does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points below or check the ‘www.asko.com' website for more
information.
SYMPTOM POSSIBLE CAUSE SOLUTION
You smell gas near
the appliance.
The appliance connection
is leaking.
Close the main gas switch. Contact the your
installer.
A burner does not
ignite.
Plug not in socket.
Fuse defective/fuse
switched off in fuse
cupboard.
Spark plug (1) dirty/damp.
Burner parts not placed
correctly.
Burner parts dirty/damp.
Main gas tap closed.
Fault in gas mains.
Gas bottle or tank is empty.
Wrong type of gas used.
Put the plug into the socket.
Put in a new fuse or switch on the fuse in the
fuse box.
Clean/dry the spark plug.
Use the centring leads to put the burner parts
together.
Clean/dry the burner parts. Make sure that
the outflow holes are open.
Open the main gas tap.
Consult you gas supplier.
Connect a new gas bottle or have the tank
refilled.
Check whether the gas used is suitable for
the appliance. Contact your installer if it is not
correct.
The burner does not
burn evenly.
Burner parts not placed
correctly.
Burner parts dirty/damp.
Wrong type of gas used.
Use the centring leads to put the burner parts
together.
Clean/dry the burner parts. Make sure that
the outflow holes are open.
Check whether the gas used is suitable for
the appliance. Contact your technician if it is
not correct.
Burner extinguishes
after igniting.
The control knob has not
been depressed long or
deep enough (at least
3 seconds).
Thermocouple (2) is dirty.
Keep the control knob fully depressed for
at least 3 seconds between high and low
settings. This can take longer the first time
because of the gas supply.
Clean/dry thermocouple.
1
2
EN 7
ERRORS
SYMPTOM POSSIBLE CAUSE SOLUTION
Timer indicates
error code F0 – F6
(if present).
There is an object, water or
dirt on the buttons. Button
used for too long.
Ensure that there is nothing on the buttons.
Ensure that the buttons are clean and there is
no water on them.
Contact the technician if the error code does
not disappear.
Ceramic glass plate
broken.
Object fallen onto it. Close the gas main switch and pull the plug
out of the socket. Contact the your installer.
Please note! Do not throw a broken
ceramic glass plate in the glass recycling
bin but take this to the Municipality's
waste recycling centre.
EN 8
ENVIRONMENTAL CONSIDERATIONS
Disposal of the appliance and packaging
Sustainable materials have been used during manufacture of this
appliance.
The appliance packaging is recyclable. The following may have been
used:
• cardboard;
• paper;
• polyethylene film (PE);
• CFC-free polystyrene (PS-rigid foam);
• polypropylene tape (PP).
Dispose of these materials in a responsible manner and in accordance
with government regulations.
To designate the requirement for separate collection of household
electrical appliances, the symbol of a crossed-out dustbin is applied to
the product.
This means that at the end of its working life, the product must not
be disposed of as urban waste. It must be taken to a special local
authority differentiated waste collection centre or to a dealer providing
this service. Disposing of a household appliance such as this hob
separately avoids possible negative consequences for the environment
and health and enables the constituent materials to be recovered,
resulting in significant savings in energy and resources.
Please note! Do not throw a broken ceramic glass plate in the glass
recycling bin but take this to the Municipality's waste recycling
centre.
Declaration of conformity
We hereby declare that our products satisfy the applicable European
directives, orders and regulations, as well as the requirements stated in
the referenced standards.
EN 9
ENVIRONMENTAL CONSIDERATIONS
Information according regulation (EU) 66/2014
Measurements according EN 30-2-1
Model identification HG1615ab HG1675sb
Type of hob
Number of gas burners 4 4
Energy efficiency per gas burner
(EEgas burner) in %
1 = 61.5
3 = 62.1
4 = 62.1
1 = 61.5
3 = 62.1
4 = 62.1
Energy efficiency for the gas hob
(EEgas hob) in % 61,9 61,9
Gas hob
EN 10
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Quemador de Asko
Asko
Asko HI1995G Manual de usuario
Asko
Asko HG11 series Manual de usuario
Asko
Asko HG1666AB Manual de usuario
Asko
Asko HG1145AB Manual de usuario
Asko
Asko HI1884M Manual de usuario
Asko
Asko HG8313BGD Series Manual de usuario
Asko
Asko HG1355gb Manual de usuario
Asko
Asko H4 Manual de usuario
Asko
Asko HG1675sb Manual de usuario
Asko
Asko HIHD854GF Manual de usuario
Asko
Asko HIG1995AB Manual de usuario
Asko
Asko SIVK7QATX HI1774IQ Manual de usuario
Asko
Asko HG9ADE1A Manual de usuario
Asko
Asko HG1ABE3A Manual de usuario
Asko
Asko HG1825AD Manual de usuario
Asko
Asko HG8BDE1A Manual de usuario
Asko
Asko HI9ETA04 Manual de usuario
Asko
Asko HG1355gd Manual de usuario
Asko
Asko HG1825AB Manual de usuario
Asko
Asko HIG1944MD Manual de usuario
