Options ➙ Program settings ➙ Files 53
▸ File save style 53
▸ Automatically check for newer versions of
actual file 53
▸ Check device type when loading .hex file 53
▸ Save device type into .hex file 53
▸ Warn when loaded HEX does not contain
CFG memory data 53
▸ Warn when loaded HEX is not aligned to
word size. 53
▸ Binary file loading and saving style 53
▸ Save unused locations to .hex file 54
▸ Clear code/main / data memory / ID
positions before file reading 54
▸ Erase configuration memory before file
reading 54
▸ Read data memory not from the file but
from the device 54
▸ Read ID positions not from the file but
from the device 54
▸ Project storing style 54
▸ Load last project on start-up 54
Options ➙ Program settings ➙ Colors 55
Options ➙ Program settings ➙ Editors 55
▸ Code/main memory editor: show words as
bytes 55
▸ Code/main memory editor 8 words wide 55
▸ Data memory editor 8 words wide 55
▸ Boot memory editor 8 words wide 55
▸ Show only the lowest byte of word in ASCII 55
▸ Mask ID positions while reading from
device, from file, etc. 55
▸ Mask ID positions during direct user input 55
▸ Configuration memory editor: show cfg
word instead of fuses 55
Options ➙ Program settings ➙ Serial numbers 55
▸ Serial numbers 55
▸ Prepare S/N before programming 56
▸ Find successor after programming 56
▸ Prepare S/N after programming 56
▸ Serial number interval 56
▸ Log to file 56
▸ Serial number length (the number of
characters) 56
▸ Number base 56
▸ Code as ASCII 56
▸ Initial serial number 56
▸ Next S/N 56
▸ Destination 56
▸ Hexadecimal address of first word 56
▸ Fill with RETLW instruction 57
▸ Characters per word 57
▸ Sequence 57
Options ➙ Program settings ➙ Checksum 57
▸ Show checksum in status bar 57
▸ Checksum algorithm 57
Options ➙ Program settings ➙ Others 57
▸ Update check settings 57
▸ Allow internal and external supply
voltages collision 57
▸ Do not show warning if internal 5V is
switched on with 3.3V device 58
▸ Allow to change supply voltage level when
it is on 58
▸ Allow external supply voltage for devices
requiring VPP before VCC. 58
▸ Pin T during programming 58
▸ Pin T after programming 58
Options ➙ Select programmer 58
Options ➙ Language selection... 58
Options ➙ Keyboard shortcuts... 58
Help Menu 59
Help ➙ Help on program 59
Help ➙ List of supported devices 59
Help ➙ Check Internet for updates 59
Help ➙ ASIX website 59
Help ➙ About 59
59Programmer Settings Window5.5.4
FORTE Programmer Settings Window 59
