Aruba AP-500H-MNTD Manual de usuario
AP-500H-MNTD Mount Kit
Installation Guide
0512187-02 | August 2020 1
The AP-500H-MNTD is a stand-alone desk mount for the 500H access points.
Package Contents
Mount stand
(x3) M2.6x0.45x8 Pan Head, T8H Driver Machine Screws
Installation
1. Attach an active Ethernet cable to the E0 port located on the back of the access point, as shown in Figure 1.
2. Align the slots on the back of the access point against the guide posts and slots on the mount, then slide the
access point down, as shown in Figure 1.
Figure 1 Install Access Point to Mount Cover
3. Once the access point is attached to the desk mount, insert and fasten the security screw on the right side of
the mount, as shown in Figure 2.
4. Insert T8H Hex security screws into the holes on the back of the mount stand and tighten the access point to
the mount, as shown in Figure 2.
A T8H screwdriver is required for installation.
This mount kit only supports the desktop solution for the 500H Series access points.
2AP-500H-MNTD Mount Kit | Installation Guide
Figure 2 Secure Access Point Onto Mount
5. (Optional) Use the Kensington lock slot located on the back of the mount stand to lock this mount kit to a
secure surface.
6. If the access point requires a DC power adapter, insert a power cable into the receptacle located on the side
of the access point.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Rack y soporte de Aruba
Aruba
Aruba LS-BT1-MNT-50 Manual de usuario
Aruba
Aruba AP-130-MNT-W1 Manual de usuario
Aruba
Aruba 205H-MNT1 Manual de usuario
Aruba
Aruba AP-220-MNT-W1W Manual de usuario
Aruba
Aruba AP-270-MNT-H1 Manual de usuario
Aruba
Aruba AP-130 Series Manual de usuario
Aruba
Aruba AP-303H-MNTU Manual de usuario
Aruba
Aruba AP-270-MNT-H2 Manual de usuario
Aruba
Aruba AP-220-MNT-W2 Manual de usuario
Aruba
Aruba AP-205H-MNT1 Manual de usuario
